Bissell 3574 инструкция обслуживания

USER’S GUIDE 3574/3576 SERIES Safety Instructions 3 Product View 4 Assembly Instructions 5-6 Operation / Special T ools 6-8 Maintenance 8-11 T roubleshooting 12-13 Warranty 16 Replacement Parts 14 Consumer Services 15 CleanView ® II BAGLESS[...]

2 Thanks For Buying A BISSELL CleanV iew ® II We’ re glad you purchased a BISSELL CleanView II Vacuum. Everything we know about floor care went into the design and construction of this complete , high-tech home vacuuming system. Y our BISSELL CleanView II is well made, and we back it with a limited comprehensive one-year warr anty . W e also sta[...]

3 IMPOR T ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, inc luding the following: READ ALL INSTRUCTIONS BEFORE USING Y OUR UPRIGHT V ACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. W ARNING: T o redu[...]

4 C AUTION: Do not plug in your vacuum cleaner until you are f amiliar with al l instructions and operating procedures. Power Switch Carrying Handle Crevice T ool Post-Motor Filter Quick Reach ® Handle Handle Quick Release Cord Wrap Handle Release Pedal Powerfoot Stretch Hose Extension W and Power Cord Furniture Protection Guard Height Adjustment [...]

How T o Use This Guide This User’ s Guide has been designed to help you get the most satisfaction from your BISSELL CleanView II. Y ou’ll find assembly and opera ting instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling your vacuum cleaner . Pay particular[...]

Snap the Extension W and and the Crevice T ool together into the storage clip as shown. Snap the Combination T ool into the storage clip as shown. Press the Handle Release Pedal with your foot to place your vacuum in one of three cleaning positions. Upright- For storage and above floor cleaning with tools. Normal Cleaning- Press Handle Release Peda[...]

T o move your cleaner from room to room, put the Handle in the upright position, tilt the cleaner back on its rear wheels and push forward. The cleaner can also be moved by using the Carrying Handle on the back. Use the Stair Cleaning Handle on the front to hold your vacuum while cleaning stairs. Y our BISSELL CleanView II is not only a powerful ca[...]

When you are done using your vacuum, return it to the Upright position and store the Power Cord. T urn vacuum cleaner off. Unplug Power Cord by grasping the polarized plug (NOT the cord) and disconnect from outlet. Loop Power Cord around Cord Wraps on side of vacuum cleaner . Clip molded plug to Power Cord to secure. T o maintain maximum cleaning p[...]

Use only BISSELL Style 9 Replacement Filters in your BISSELL CleanView II. Unplug the cleaner from electrical outlet. Remove the Dirt Container as described in the previous section. Grasp the Filter Cup located at the bottom of the Dirt Container and twist counterclockwise to unlock and remove. Grasp the Circular Filters and twist to unlock. Pull s[...]

Y ou should check your vacuum cleaner’ s Rotating Floor Brush and Drive Belt regularly for wear or damage. Y ou should also c lean the brush and brush ends of strings, hair , and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover[...]

Use only BISSELL Replacement Bulb (#203-1007) in your BISSELL CleanView II. Unplug cleaner from electrical outlet Using a flat screwdriver , table knife or coin, insert into the slot on the right of the Lens and gently push inner latch to the left as shown to remove the lens. Remove the bulb from the socket by pushing in gently and turning it count[...]

12 T roubleshooting V acuum cleaner won’t run P ossible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker V acuum cleaner won’t pick up dirt P ossible Causes Remedies Incorrect Height Adjustment Adjust Powerfoot to correct height setting Hose not attached to suction op[...]

T ools won't pick up dirt continued P ossible Cause Remedies Dirt Container full Empty Dirt Container Dirt Container or Upper T ank Position correctly and not installed properly lock in place Filters are dirty Check and clean Inner and Outer Circular filters, Pre-Motor and Post-Motor F ilters Louver missing or installed incorrectly Check for a[...]

14 Replacement P arts – BISSELL Cleanview II Series Y ou may purchase replacement parts from your retailer , by calling BISSELL Consumer Services or by visiting our website. T o loca te a retailer near you, or to place an order using Visa, MasterCard, Discover or American Express, call BISSELL Consumer Services 1-800-237-769 1 Monday - Friday 8 a[...]

BISSELL Consumer Services For information about repairs or replacement parts, or questions about your warranty , call: BISSELL Consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare Inc . PO Box 3606 Grand Rapids , MI 49501 A TTN: Consumer Ser vices Or visit the BISSELL websit[...]

Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may var y from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover , please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below . Limited One [...]