Bissell 6595 инструкция обслуживания

USER’S GUIDE 3750/6595/6801 SERIES Safety Instructions 3 Product Diagram 4 Assembly Instructions 4-6 Operation / Special T ools 6-9 Maintenance 10-13 T roubleshooting 14 Warranty 16 Replacement Parts 15 Consumer Services 15 Lift-Off ® BAGLESS ug603-5540_3750_905.indd 1 ug603-5540_3750_905.indd 1 10/3/05 3:47:49 PM 10/3/05 3:47:49 PM[...]

2 Thanks For Buying A BISSELL Lift-Off ® We’re glad you purchased a BISSELL Lift-Off Vacuum. Everything we know about floor care went into the design and construction of this powerful, high-tech home vacuuming system. Y our BISSELL Lift-Off is well made, and we back it with a limited comprehensive one-year warranty . We also stand behind it with[...]

3 IMPOR T ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be observed, inc luding the following: READ ALL INSTRUCTIONS BEFORE USING Y OUR UPRIGHT V ACUUM. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance. W ARNING: T o redu[...]

4 C AUTION: Do not plug in your vacuum cleaner until you are familiar with all instructions and operating pr ocedures. Power Switch Crevice T ool Handle Quick Release Cord Wrap Handle Release Pedal Powerfoot Stretch Hose Power Cord Furniture Protection Guard Height Adjustment Knob Upper T ank Dirt Container Pre-Motor Filter Lock ’n Seal ® Lever [...]

How T o Use This Guide This User’ s Guide has been designed to help you get the most satisfaction from your BISSELL Lift-Off. Y ou’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling your vacuum cleaner . Pay particular atte[...]

Slide the end of the Hose Grip onto the Hose Grip Base. Place the Hose into the Hose Clip. NOTE: The P owerfoot will not operate effectively unless the Hose is firmly attached to the base. Snap the T elescoping Extension W and, Crevice T ool, and Combination T ool into storage clips as shown. On Board T urboBrush ® (Select Models Only) The T urboB[...]

The Powerfoot on your BISSELL Lift-Off can be adjusted to clean several floor surfaces. NOTE: For optimal c leaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Place Handle in Upright Position. T urn Height Adjustment Knob to desired setting. Lowest Setting – For ba[...]

T elescoping Extension Wand: Use with desired attachment for a longer reach. T o extend the W and, twist the collar to “Unlock” position and push away from you. T wist the collar to the “Lock” position to lock into place. T o retract, twist to unlock, pull toward you and twist to relock. T urboBrush ® (Select Models) : Use rotating brush a[...]

9 Select Models Only The Shoulder Strap may be used while cleaning with the Detachable Canister . T o attach the Shoulder Stra p, wrap the V elcro ends attached to the bottom of the strap securely around the Canister handle as shown. The length of the strap may be adjusted as required for comfort Select Models Only The Clean Filter Indicator tells [...]

Upper T ank Knob How to Maintain Y our BISSELL Lift-Off T o maintain maximum cleaning performance, the following maintenance steps must be performed: Empty the Dirt Container when the dirt reaches the “Full” line on the side. Check the Upper T ank and Pre-Motor Filters at least once a month and clean and replace as needed. Replace the HEP A Med[...]

Use only BISSELL Style 8 Replacement Filters in your BISSELL Lift-Off ® . Unplug the cleaner from electrical outlet. The Pre-Motor Filter protects the motor from dirt partic les. It is located in the slide out tray underneath the Dirt Container . If the filter becomes dirty , pull out the tray, lift out the filter and clean. This filter may be han[...]

Place one end of the new Drive Belt over Motor Pulley and the other end over the Brush in the space between the bristles. Pull the Brush firmly to stretch the Drive Belt and place ends of Brush down into slots on sides as shown. T urn Brush several times by hand to center the Drive Belt. Reposition Brush Cover and screws. Tighten screws securely . [...]

Low suction or poor pickup may be due to a clog in the vacuum cleaner . If you notice a change in the sound of the motor or a reduction in the spinning action, check for c logs. Unplug cleaner from electrical outlet. Empty Dirt Container . Check Upper T ank for build up or clogs. Remove the Upper T ank and check the suction inlet for a clog. Grasp [...]

Vacuum c leaner won’t run P ossible Causes Remedies Power cord not plugged in Check electrical plug Blown fuse/tripped breaker Check/Replace fuse or reset breaker Thermal protector activated Allow cleaner to cool for 30 minutes, see pg. 13 No P ower at Rotating Floor Brush P ossible Causes Remedies Canister is not securely seated Remove Canister [...]

Y ou may purchase replacement parts from your retailer , by calling BISSELL Consumer Services or by visiting our website. T o locate a retailer near you, or to place an order using Visa, MasterCard, Discover or American Express, call BISSELL Consumer Services 1-800-237-769 1 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or vis[...]

Warranty 16 This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover , please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. Limited One Y [...]