Bloomfield 8372 инструкция обслуживания

PRINTED IN UNITED STATES OF A MERIC A p/n 75612 Rev. F ECN-12597 M 681 040914 cps 681 OWNERS MANUAL for BOTTLED WATER DECANTER COFFEE BREWERS MODEL 8372 for 3 Gallon and 5 Gallon Plastic Bottles Includes: Installation Operation Use & Care Servicing Instructions Model 8372 Brewer with optional 8900-Series Glass Decanter[...]

NOTE: For your protection, please note that equipmen t in this shipment was carefully inspected and packaged by skilled personnel befor e leaving the factory. Upon accep- tance of this shipment, the transp ortation company assumes full responsibility for its safe delivery. IF SHIPMENT ARRIVES DAMAGED: 1. VISIBLE LOSS OR DA M AGE: Be certain that an[...]

TABLE OF CONTENTS SPECIFICATIONS Thank You for purc hasing this Bloomfield Industries appliance. Proper installation, professional operation and consistent maintenance of this appliance w ill ensure that it gives you the very best performance and a long, economical service life. This ma nual contains t he information needed to properly install this[...]

FEATURES AND OPERATING CONTROLS 2 Fig. 1 Fe atures & Op erating Con trols[...]

PRECAUTIONS AND GENERAL INFORMATION WARNING: Electr ic Shock Hazard All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which requ ire the use of tools. Failure to heed this warning can result in electrical shock. WARNING Electric Shock Hazard Brewer mu st be plu[...]

INSTALLATION INSTRUCTIONS RE A D THIS CAREFULL Y BEFORE ST A RTING THE INST A LL A TIO N Unpack the unit. Inspec t all components f or completeness and condition. Ensure that all packing materials have been removed from the unit. Verify that the Spray Head Gasket (#33) and Spray Disk (#34) are properl y installed. LEVELING THE UNIT Verify that an a[...]

OPERATION 5 CA UTI ON : Personal Injury 5 Gallon water bottle can weigh up to 50 pounds. Install bottle carefully. Injury can result fr om improper lifting techniqu e or from attempting t o lift a full bottle with ou t adequate physical ability. CA UTI O N: Equ ipme nt Electrical Damage DO NOT manually fill brew er through bottle ring. IMPORTANT: U[...]

OPERATION (contin ued) WATER HEATER Water temperature is sensed b y a thermobulb inserted into the water tank. This temperature signal is fed to the thermostat, which controls line power to the heating elem ent. The setpoint temperature is adjustable at the thermostat. The element is protected from over- temperature by a hi-limit thermostat. WA TER[...]

BREWING COFFEE CAUT ION: Burn Haza rd Exposed surf aces of the brewer, brew chamber and decanter may be HO T to the touch, and can cause serious burn s. CA UTI ON: Burn Hazard To avoid splashing or over- flowing ho t liqu ids, ALWAYS place an empty decanter under the brew cham be r bef ore starting the brew cycle . Failure to comply can cause serio[...]

8 CLEANING INSTRUC TIONS PROCEDURE: Clean Coffee Brewer PRECAUTIONS: Di sconnect bre wer from elect ric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean So ft Cloth or Sponge Bristle Brush. 1. Disconnect brew er from electric power. Allow brewer to cool before cleaning. 2. Remove and empty de canters. 3. Remove and empty b[...]

9 CLEANING INSTRUCTIONS (continued) PROCEDURE: Clean a nd Sanitize Basi n Pan PRECAUTIONS: Disconnect brewer fro m electric power. Allow brewer to cool. FREQUENC Y: Monthl y TOOLS: #2 Phillips Head Scre wdriver Mild Detergent, Food Equipment Sanitizer Clean Soft Cloth or Sponge 1. Disconnect brewer from electric pow er. Allow brewer to cool before [...]

10 TROUBLESHOOTING SUGGESTI ONS SUGGESTED REMEDY Check po wer supply cord Check / reset circuit breaker Set for desired temperature Allow to cool Reset hi-limit (8786, 8788) Examin e wiring & connec tors, thermostat and heating element Repair/replace as needed Replace water bottle Adjust amount of grounds Adjust timer Use one (1) genuine Bloomf[...]

11 SERVICING INSTRUCTIONS ACCESS PANELS Top panel is held by four screws at the corners. Front panel i s held b y two clips under each warm er plate, th ree screws at the bottom and a re taining lip at the top. Top rear pa nel is held b y two clips unde r the war mer pl ate. TEMPERATURE ADJUSTMENT With the “READY TO BREW” light ON , dr aw a cup[...]

IMPORTANT: Adjust timer with a full water bottle install e d in the bottle rin g. IMPORTANT: Before setting assembly into tank, make sure tank lid gasket is properly seated on flange of lid. DO NOT OVER-TIGHTEN . IMPORTANT: When removing tank lid assembly, be careful to not damage or kink thermosta t capillary tube. IMPORTANT: When mounting thermos[...]

SERVICING INSTRUCTIONS ( continued) 13 REPLACE HEATING ELEMENT Remove tank lid assembly per ab ove. Remove two hex nuts h o l ding elem ent to cover. Pull elem ent from mounting holes. Reassemble in reverse order. REPLACE WARMER ELEMENT Remove warmer plate by turning cou nter-clockwise. Lift element from bracket. Disconnect wiring. Reassemble in re[...]

CA UTI ON - CH EMICA L BURN HA ZA RD Deliming chem icals are caustic. W ear ap pr op riate prote ctive gloves and goggles during this procedure. Never siphon deliming chemicals or solutions by mou th. This operation should only be perfo rm e d by qualifie d an d ex- perienced service personnel. IMPORT ANT: DO NOT spill, splash or pour water or deli[...]

7. Set the tank ba ck into the brewer. Reassem b le the ta nk lid to the water tank. Mak e sure the gasket is properly in place, then reinstall the hold-down strap. 8. Reinstall w iring to heating element and thermostat. Reinstall the hi-limit thermostat . Verify that all internal components are dry, then reinstall the top panel. 10. Reconnect brew[...]

EXPLODED VIEW & PARTS LIST 16 ITEM PART# DESCRIPTION QTY 8 83538 TU BE, F AUC ET SUPP LY 1 0” SIL ICONE 1 13 8 043- 5 ST RAP, TANK LI D HO LD D OWN 1 25 80 43-13 ELB OW , BRE W NOZZL E SILICO NE 1 29 8783-1 FAUCET 1 30 82681 W ASHER, FLAT SS 15/32 x 1-1/8 OD 1 33 8543-42 GASKET, SPRAY DISK 1 34 8 4132 SP RAY DISK 1 34a 8543-45 BRE W HEAD (mus[...]

EXPLODED VIEW & P ARTS LIST (continued) 17 ITEM PART# DES CRIPTIO N QTY 2 8572-18 W ARM ER, 120 V 100 W 3 30 85647 SWITCH, WARM ER ON/O FF 120V 3 31 85646 SWITCH, BRE W MOM ENTARY 120V 1 32 8718-31 INDICATOR LIGHT, GREEN 120V 1 35 8812-61 TIMER, 8 MIN 1 36 6407-15 POWER CO RD, N EMA 5-15 P 1 37 35-210 STRAIN REL IEF 1 45 83388 SOLENOI D, BR EW [...]

EXPLODED VIEW & P ARTS LIST (continued) 18 ITEM P ART# DESCRIPTION QTY 1 8700-16 PLATE, WARMER COVER 3 33 8543-42 GASKET, SPRAY DISK 1 34 84132 SPRAY DISK 1 34a 8543-45 BREW HEAD (must be drilled & riveted to in stall 1 70 8706-75 BUTTON PLUG, 2” DIA 1 73 81732 LEG ADJUST ABLE 4 73a 8033-55 LEG, METAL 73b 8033-56 FOOT, RUBBER 75 8543-69 B[...]

WIRING DIAGRAM 19[...]

PRINTED IN UNITED STATES OF AMERICA Bloo mf iel d Indu stri es, Inc . Division of Carrier Co mmercial Refrigeration In US and Can ada T el eph one: 77 5-6 89-5 700 Fa x: 888-4 92-2783 Fa x: 800-3 56-5142 () websi te: www .wel lsbl oomfi el d. com fo r order s onl y Bloomf iel d Indus t ri es p roudl y suppor ts CFESA Commerc ial Fo od Equi pment Se[...]