Bloomfield 8752 инструкция обслуживания

PRINTED IN UNITED STATES OF A MERIC A 605 OWNERS M A NUAL for INTEGRITY™ 5-WARMER COFFEE BREWERS MOD EL : 8752 8752KFT Includes: Installation Operation Use & Care Servicing Instructions Model 8752 Brewer with optional 8900-Series Decanters p/n 70988 Rev. B ECN-12887 M605 05 0617 cps[...]

NOTE: For your protection, please note that equipment in this shipment was carefully inspected and packaged b y skilled personnel before le aving the factory. Upon acceptance of this shipm ent, the transportation company assumes full responsibility for its safe delivery. IF SHIPMENT ARRIVES DAMAGED: 1. VISIBLE LOSS OR DAMAGE: Be certain that any v [...]

MODEL STYLE VOLTS WAT TS AMPS 1ø POWER SUPPLY CORD 8752 8752KFT Decanter Brew er 5 W arm ers 115/230 4000 19.4 None provided Wire directly to cir cuit 1 TABLE OF CONTENTS SPECIFIC ATIONS Thank You for purc hasing this Bloomfield Industries appliance. Proper installation, professional operation and consistent maintenance of this appliance w ill ens[...]

FE AT U R E S AN D O P E R AT I N G CO N T R O L S 2 Fig. 1 Model 8752 Features and Operating Controls 605 70988 Ow ners Manual Integrity 5 W Decanter Brew er[...]

PRECAUTIONS A ND GENERAL INFOR M ATION 3 WARNING: ELECTRIC SHOCK H AZARD All servicing requiring access to non-insulated components must be performed by qualified service personnel. Do not open any access panels which requ ire the use of tools. Failure to heed this warning can result in electrical shock. WARNING: INJURY HA ZARD All installation pro[...]

INSTALL ATION 4 RE A D THIS CAREFULL Y BEFORE ST A RTING THE INST AL L A TION REFER TO EXPLODED VIE W S FOR COMPONENT NAMES/ NUMBERS Unpack the unit. Inspec t all components f or completeness and condition. Ensure that all packing materials have been removed from the unit. Verify that the Spray Head Gasket and Spray Disk are properly installed. LEV[...]

INSTALLATION (continued) 5 NOTE: This equipment must be installed to comply with applicable federal, state an d local plum bing codes an d ordinanc es. WARNING: SHOCK HAZARD Brewer must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide suc h a ground . Electrical shock will cause death or serious inju[...]

OPERATION Fig. 4 Brewer Operation Diagram START-UP For initial start-up, or if the br ewer has not been used for an extended period of t ime: ♦ Be sure spray disk and bre w gasket are properly installed in the brew head. ♦ Be sure the water supply is prope rly conne cted and the w ater supply valve is turned ON . ♦ Be sure the W ATER TANK IS [...]

OPERATION (continued) Water temperat ure is sensed by a thermobulb insert ed into the water tank. This temperature signal is fed to the thermostat, which controls line power to the heating elemen t. The setpoint temperature is adjustable at the therm ostat. The elem ent is pr otected f rom ov er- temperature by a hi -limit thermostat. WATER FLOW PO[...]

BREWING COFFEE CAUTION: BURN HAZARD Exposed surfaces of the brewer, brew chamber and decanter m ay be HOT to the touch, and can cause serious burns. CAUTION: BURN HAZARD To avoid splashing or overf lo wing hot liquids , ALWAYS place an empty decanter under the brew chamber before starting the brew cycle. Failure to comply can cause serious burns. C[...]

CLEANING I NSTRUCTIONS PROCEDURE: Clean Coffee Brewe r PRECAUTIONS: Disconnect brewer fro m electric power. Allow brewer to cool. FREQUENCY: Daily TOOLS: Mild Detergent, Clean Soft Cloth or S ponge Bristle Brush, Bottle B rush 1. Disconnect brewer from electric pow er. Allow brewer to cool before cleaning. 2. Remove and empty de canters. 3. Remove [...]

10 TROUBLESHOOTING SUGGESTIONS SUGGESTED REMEDY Check po wer supply cord Check / reset circuit breaker Set for desired temperature Allow to cool Reset hi-limit Examin e wiring & connec tors, thermostat and heating element Repair/replace as needed Be sure to add sufficient water prior to energizing Increase wat er amount Adjust am ount of gr oun[...]

SERVICING IN STRUCTIONS CAUTION: SHOCK HAZARD Opening acce ss panels o r remov ing warmer plat es on this brew ma y expose uninsul ated electrical co m ponents. Disconnect brewer from electrical power before removing any pan el. ACCESS PANELS TOP PANEL: Remove top panel to access hot water tank, thermostat, he ating elements, brew circuit tubing an[...]

SERVICING INST RUCTIONS (continued) TEMPERATURE ADJUSTMENT Unplug power cord or turn circuit breaker OFF. Remove top panel. Pull vent tube o ut of tank lid and inse rt a thermometer of known accuracy in hole. Reconnect brewer to electrical powe r. Place empty cont aine r under bre w chamber. Energize brewer and allo w unit to h eat. W hen READY TO [...]

SERVICING INSTRUCT IONS (continued) 13 IMPORTA NT: Water pressure must be betwee n 20 p.s.i and 90 p.s.i. flowing pressure. If wate r pressure ex ceeds this value, or if water pressure varies g reatly, a pres sure regulator must be installed in the w ater s upply line. IMPORTA NT: Before se tting assembly into tank, make sure tank lid gasket is pro[...]

SERVICING IN STRUCTIONS (continued) 14 REPLACE SOLENOID Symptom: Automatic brewer will not flo w water; or, automatic brewer drips continuously from brew head. Unplug po wer cord or t urn circ uit break er OFF . Turn OFF and disconnect water supply from brewer inlet fitting. Unscrew water inlet fi tting f rom solenoid. Remov e two screws holdin g a[...]

REPLACE TIMER A SSEMBLY Unplug power cord or turn circuit breaker OFF. Remove front panel. Remove knob and three screws holding timer to bracket. Disconnect wiring to timer. Reassemble in reve rse o rder. Adjust timer as described on page 13 REPLACE HOT WATER FAUCET COIL Symptom: Brewer drips continuously from brew head, except when fa ucet valve i[...]

CAUTION: CHEMICAL BURN HA ZARD Deliming chemicals may be caustic. Wear appropriate protective gloves and goggles during this procedure. Never siphon deliming chemicals or solutions by mou th. This operation should only be perfo rme d by qualified and experienced service personnel. IMPORT ANT: DO NOT spill, splash or pour water or deliming solution [...]

7. Set the tank back into the bre wer. Reassemble the tank lid to the water tank. Mak e sure the gasket is properly in place, then reinstall lid clamps. 8. Reinstall wiring to heating el em ent and therm ostat. Reassemble piping for the faucet. Veri fy that all internal components are dry , then reinstall the top panel. 10. Reconnect brew er to ele[...]

EXPLODED VIEW & PARTS LIST 18 CA BIN ET ASSEMBLY ITEM PART NUMBER DESCRIPTION 1 8700-16 PLATE, WARMER COVER 4 8543-80 CLIP, MOUNTING 23 BUSHING, HEYCO 1/78 33 8543-42 GASKET, SPRAYHEAD 34 82727 SPRAY DISK, EMBOSSED 34a 8543-85 RETAINER, SPRAY DISK (DRILL & RIVET REQUIRED TO INSTALL) 35 85089 DOOR, SOLENO ID 48 8516-150 LEG SET, BLACK PLASTI[...]

EXPLODED VIEW & PART S LIST (continued) 19 ELECTRICAL COMPONENTS ITEM PA RT NU MBER DESCRIPTION 2 8572-18 ELEMENT, WARMER 120V 100W 30 8707-55 SW IT C H , BR EW (M O ME N T A RY ) 31 8528-40 SWITCH, TANK HEATER 24 0V 20A 32 8738-2 INDICATOR LIGHT 120V GREEN 35 8718-1 TI MER W / KN OB 2 -MI N 36 8552-18 TERMINAL BLOCK 4P 39 86945 SW I T C H, W A[...]

EXPLODED VIEW & PARTS LIST 20 HOT WATER TANK ASSEMBLY ITEM PART NUMBER DESCRIPTION 13 8043-5 HOLD-DOW N STRAP 14 8942-92 NUT 8-32 HEX KEPS 50 86280 T HERMOSTAT 199ºF 54 8043-12 GASKET, TANK COVER 55 8043-28 NUT, HEX 1/2-20 BRASS 56 8043-30 GASKET, SEAL 57 8941-21 NUT, HEX 7/16-20 BRASS 58 8540-6 HOT W ATER COIL 59 8043-8 ELBOW, INLET 60 8043-1[...]

EXPLODED VIEW & PART S LIST (continued) 21 PLUMBING COMPONENTS ITEM PART NUMBER DESCRIPTION 8 8540-3 ASSEMBLY, FORMED TUBE FAUCET SUPPLY 9 86904 T UBE, FORMED ASSEMBLY 1/4FF x 1/4 FF 10 80154 FITT ING, UNION 1/4MF x 1/4MF 12* 82556 ASSEMBLY, FAUCET 24 8043-26 TUBE, BREW OU TLET METAL 25 8043-13 ELBOW, BREW SPRAY 26 82680 NUT , HEX 7/16-20 Ni 27[...]

EXPLODED VIEW & PARTS LIST (continued) 22 SERVICE KITS FAUCET REPAIR KITS 82573 Handle (item 12a) 82575 Seat Cup (item 12c) 82576 Faucet Repa ir Kit (Includes 12a Handle, 12c Seat Cup, 12d Spring, 12h Stem, 12j Pin & 12k Bonnet 82682 Retainer Clip (item 12b) 84804 Aerator Repl acement Kit (Includes 12e O-Ring, 12f Aerator Disk & 12g Aer[...]

WIRING DIA GRAM 23 605 70988 Owners Manual Integrity 5W Decanter Brewer[...]

PRINTED IN UNITED STATES OF AMERICA Bloo mf iel d Indu stri es, Inc . Division of Carrier Co mmercial Refrigeration In US and Can ada T elep hone: 775 -689- 5700 Fa x: 888-4 92-2783 Fa x: 800-3 56-5142 () websi te: www . wells bl oomfi eld. com fo r order s onl y Bloomf iel d Indus t ri es p roudl y suppor ts CFESA Commerc ial Fo od Equi pment Serv[...]