Bosch DWB098E51B инструкция обслуживания

[en] Instructions for installation and use Extractor hood[...]

2 Ú T able of contents [ e n ] I n s t r u c t i o n s f o r i n s t a l l a t i o n a n d u s e INSTRUCTION MANUAL ............................................................ 2 Important safety information ................................................ 2 Environmental pro tection ..................................................... 4 Environm[...]

3 Danger of suf focation! Packaging material is dangerous to children. Never allow children to play with packaging material. Danger of death! Risk of poisoning from flue gases that are drawn back in. Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room air-dependent heat-produc[...]

4 Risk of injur y! ■ Components inside the appliance may have sharp edges. Wear protective gloves. Risk of injury! ■ Items placed on the appliance may fall down. Do not place any objects on the appliance. Risk of injury! ■ The light emitted by LED lights is very dazzling, and can damage the eyes (risk group 1). Do not look directly into the s[...]

5 Operation These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fume[...]

6 Intensive se tting You can use the intensive setting if there is a large build-up of odours and fumes/vapours. Press the + button when the fan is at setting „ . The intensive boost setting ‚ is activated. Pressing the + button again activates the intensive boost ƒ setting. After approx. six minutes, the electronics automatically reduce the f[...]

7 1. When the fan is switched off, press the 1 button and hold it for approx. 4 seconds. The setting is displayed. 2. Press the + or - button to change the setting of the sensor control. 3. To confirm the entries, press and hold the 1 button for approx. 4 seconds. Fan run-on time The fan run-on time is possible at every fan setting (except boost ?[...]

8 Cleaning the metal mesh grease filters : Risk of fire! Grease deposits in the grease filter may catch fire. Clean the grease filter at least ev ery 2 months. Never operate the appliance without the grease filter. Not es ■ Do not use any aggressive, acidic or alkaline cleaning agents. ■ When cleaning the metal mesh grease filters, also clean t[...]

9 T rouble shooting Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service. : Risk of electric shock! Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the[...]

10 Accessor ies for circulating-air mode (not included in the delivery) Not es ■ Follow the installation instructions supplied with the accessories. ■ For appliances with an additional internal filter, only the CleanAir recirculation module can be used. Basic equipment: Starter set for circulating-air mode - narrow Throw-away filter Basic equip[...]

11 INSTALLATION INSTRUCTIONS Installation instructions ■ This appliance is installed on the wall. ■ Follow the enclosed installation instructions for additional special accessories (e.g. for circulating-air mode). ■ The surfaces of the appliance are sensitive. Avoid damaging them during installation. : Impor tant safety information Read these[...]

12 Room air-dependent heat-producing appliances (e.g. gas, oil, wood or coal- operated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e.g. a chimney). In combination with an activated vapour extractor [...]

13 General information Exhaust air mode : Risk of death! Risk of poisoning from flue gases that are drawn back in. The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms that contain heating appliances. If the exhaust air is to be conveyed into a non-functionin[...]

14 Installation 1. Screw on the fixing bracket for the flue duct. ¨ 2. Screw on brackets for the extractor hood hand-tight, max. 3 Nm . © 3. Screw in threaded pin, leaving it protruding out of the wall by 5 - 9 mm. . ª Attaching and aligning the appliance 1. Initially remove the protective foil from the back of the appliance and, following insta[...]

15 Removing the safety caps If the safety caps must be removed, use a flat screwdriver. Connecting the pipes Note: If using an aluminium pipe, smooth the connection area beforehand. Exhaust-air pipe Ø 150 mm (recommended size) Attach the exhaust-air pipe directly to the air-pipe connector and seal. Exhaust-air pipe Ø 120 mm 1. Attach the reducing[...]

*9000852654* 9000852654 Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.com[...]