Britax P222000 инструкция обслуживания

Registration Information R2:09/01 P222000 Fill out the registration card and mail it in today! Child restraints could be recalled for safety r easons. Y ou must register this restraint to be r eached in a recall. Send your name, address and the restraint's model number and manufacturing date to Britax Child Safety , Inc. 13501 South Ridge Driv[...]

This product fulfills the requir ements of the U.S. Federal Motor V ehicle Safety Standards and is certified for use in motor vehicles and aircraft. The Britax Expressway can be installed in motor vehicles or aircraft using the seat belts and in motor vehicles using the Britax ISOFIT connectors. It is only intended for use as a forward facing child[...]

Safety Information Safety Information 2 3 F AILURE TO FOLLOW THESE INSTRUCTIONS CAN RESUL T IN YOUR CHILD STRIKING THE VEHICLE'S INTERIOR DURING A SUDDEN STOP OR CRASH. SECURE THE EXPRESSW A Y WITH A VEHICLE SEA T BEL T AS SPECIFIED IN THIS INSTRUCTION BOOKLET . • Secure the Expressway even when it is not occupied. In a crash, an unsecured c[...]

Feature Identification Feature Identification 4 5 V ersa-T ether TM Shoulder Slots Shoulder Straps Lap-Belt Guide ISOFIT TM Connectors Base Y oke Side Slot Lock-off Cover Harness Adjuster Harness Release Button Buckle Pull Rings Recline Release Handle Belly Pad HUGS TM Comfort Pads Chest Clip Hook & Loop Fastener Hook & Loop Fastener[...]

B 3 From rear of seat, r emove c- clips from HUGS straps. (See Figure B) 4 Unhook the shoulder straps from the yoke. (See Figure C) 5 Pull all straps through the shell and cover , to the front of the seat. 6 Thread the harness straps through the appropriate harness height slots. (See Figure D) 7 Reattach harness straps to the yoke. (See Figure C) 8[...]

Use this simple guide to check your seat belts and determine the safest position for your Expressway . Use the gray shaded area on the side of this page to determine the best position for the Expressway . Hold the page against your vehicle seat (as shown above) with the gray area toward the back of the seat. Now check to see if the lower seat belt [...]

Incompatible Seating Positions Important Notes 10 11 Use the Expressway only in vehicle seats which face forward! Do not use this seat on vehicle seats facing sideways or backwards! Forward-facing vehicle seats MUST be used with this child seat. Side-facing or rear -facing seats in vans, station wagons or trucks CANNOT be used wih the Expressway . [...]

12 13 Installation: ISOFIT TM Connectors Installation: ISOFIT TM Connectors IMPORT ANT : Before installing the Expressway in your vehicle, make sure that the shoulder slots are at the correct level for your child. See "Checking Harness Height" on page 6). 1 Place the child seat, with har- ness tightened, facing away from you on the vehicl[...]

14 15 Installation: Lap & Shoulder Belt Installation: Lap & Shoulder Belt Shoulder Lap IMPORT ANT : Before installing the Expressway in your vehicle, make sure that the shoulder slots are at the correct level for your child. See "Checking Harness Height" on page 6). 1 Place the child seat forward fac- ing on the vehicle seat and p[...]

16 17 Installation: Lap Belt Only Installation: Lap Belt Only C IMPORT ANT : Before installing the Expressway in your vehicle, make sure that the shoulder slots are at the correct level for your child. See "Checking Harness Height" on page 6). 1 Place the Expressway facing forward on the vehicle seat and pull the harness tight. 2 Pass the[...]

4 Locate an acceptable position in your vehicle to anchor the teth- er . There are two possible locations as illustrated below . a. The tether is attached to a metal anchor located on the speak- er shelf of your vehicle. b. If your vehicle has more than two rows of seats, the tether is routed directly over the backr est of the vehicle seat and atta[...]

Checking Buckle Position 20 21 NOTE: This section does not apply when ISOFIT is used. The position of the vehicle belt buckle can affect the stability of your Expressway . In an accident this could prevent your Expressway from protecting your child as well as it should. If, when the lap belt is properly tightened, the buckle lies in the position ma[...]

two pieces of the buckle together - they connect like parts in a puz- zle - and insert them together into the buckle. Y ou should hear a click to indicate that the buckle is securely fastened. 8 Gently pull up on the harness straps to tighten the lap section of the harness, which should fit low down on your child's body . 9 Slowly pull the Adj[...]

Y our Expressway is certified for use on an aircraft, using tradi- tional seat belt routing. Most airlines in the U.S. and Canada will allow you to use a child seat if it is labeled for use on aircraft and fits properly in the aircraft seats. Prior to travel, contact your airline about their specific policy concerning the use of child seats. • In[...]

Cleaning the Harness and Child Seat Shell DO NOT - T ake apart or attempt to take apart any of the harness when cleaning the harness and seat. It is unnecessary and dangerous to do so. DO NOT - Use solvents, detergents or cleaning fluids as these may weaken the harness and seat. DO - Only use mild soap and warm water . Cleaning the Cover The cover [...]

This Child Restraint was manufactured by Britax Child Safety , Inc. Britax Child Safety , Inc. ("Britax") warrants this product to the origi- nal retail purchaser as follows: LIMITED ONE-YEAR W ARRANTY This product is warranted against defective materials or workman- ship for one year from the date of original purchase. Pr oof of pur- cha[...]