Broil King SSG-36 инструкция обслуживания

R-3848 Page 1 A VER TISSEMENT S'il y a une odeur de gaz: 1. Coupez l'admission de gaz de l'appareil. 2. Éteindre toute flamme nue. 3. Ouvrir le couvercle. 4. Si l'odeur persiste, appeler immédiatement votre compagnie de gaz ou votre département des incendies. OUTDOOR COOKING APPLIANCE SSG-36-1 EFFECTIVE DA TE APRIL, 2003 INST[...]

Page 2 R-3848 • Read instructions before lighting. • Open lid during lighting. • If ignition does not immediately take place, turn the burner valve handles to OFF, wait 5 minutes, and repeat the lighting procedure. • Minimum clearance from sides and back of unit to adjacent combus- tible construction below top of unit, 6 inches from sides a[...]

R-3848 Page 3 4. The use of the propane from the cylinder allows the OPD to reset itself for the next fill. 5. Connects to all standard or quick-connect couplings. 6. The Overfill Protection Device affects incoming liquid propane flow only. Does not affect normal propane gas discharge when properly connected to the appliance regulator. 7. All propa[...]

Page 4 R-3848 IMPORTANT INFORMATION ABOUT YOUR NEW TYPE-1 GRILL CONNECTION Read all grill and related product literature before connecting or using your grill, and please read the following information completely before attempting to connect your grill to a propane cylinder. Keep these instructions in a safe place. You may need to refer to them whe[...]

R-3848 Page 5 Figure 3 Figure 4 The cardboard box within your grill contains the following parts: (Figure 4) 1 box of ceramic plaques (70) 4 grill plates 1 grill plate handle (see page 14, part number 19) 2 elevated cooking racks 1 side burner grate 1 side burner lid 6 burner knobs 1 rotisserie knob 1 chip tray 1 - 5" thermometer for front lid[...]

Page 6 R-3848 Figure 5 Air Shutter Adjustment Be careful as the burners may be very HOT! The air shutters are located behind the valve cover. There is an access area at the bottom of the valve cover where you can adjust the air shutter, with your fingers. A yellow flame indicates insufficient air. Open the air shutter to allow more air to the burne[...]

R-3848 Page 7 USING YOUR SUPERB GRILL 9. If grill burner does not light, turn all knobs to "OFF" and have a qualified service technician check grill. 10. Turn all knobs to "OFF" and shut off gas supply when not in use. If the grill burner will not light after several tries, refer to Troubleshoot- ing section of this manual. Figu[...]

Page 8 R-3848 Figure 7 1. Since these grill plates transfer heat so quickly, evenly, and efficiently, you may opt to cook on lower heat settings which may actually result in fuel savings. 2. For best cleaning results, preheat the grill for approximately 10 minutes and then use a brass bristle brush to clean the grill plates. 3. Most cooking will be[...]

R-3848 Page 9 Rotisserie (Figure 8) The (2) rotisserie burners, each rated at 12,000 BTUH, are an infrared type which provide intense searing radiant heat. This intense heat is perfect for searing in the natural juices and nutrients found in quality cuts of meats. When lit, the rotisserie burners will reach cooking temperatures in about 3 minutes. [...]

Page 10 R-3848 Stainless Steel The Superb gas grill is made from stainless steel. There are many different stainless steel cleaners available. Always use the mildest cleaning meth- ods first, scrubbing in the directions of the grain. To touch up noticeable scratches in the stainless steel, sand lightly with dry 100 grit emery paper or scotch bright[...]

R-3848 Page 11 Figure 11 Removing Rotisserie Burners and Rotisserie Burner Orifices (Figure 12) 1. Turn OFF gas supply to grill. 2. All grill parts must be cool before attempting to clean. 3. Remove (1) screw from each rotisserie burner electrode. 4. Pull forward on the electrode to expose approximately 3 inches of the electrode wire. 5. If you are[...]

Page 12 R-3848 HOW TO ORDER REPAIR PARTS ... All parts listed in the Parts List have a part No. When ordering parts, first obtain the Model No. from the nameplate on your equipment. Then determine the Part No. (not the Index No.) and the Description of each part from the appropriate illustration and list. Be sure to give all this information ... Gr[...]

R-3848 Page 13 PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide. Index Part No. Number Description Index Part No. Number Description 1 SSG-140 STEAMER LID ASSEMBLY 1A SSG-126 HANDLE - STEAMER LID 2 R-4005 SHOULDER SCREW (STEAMER) (2 REQ’D) 3 R-3987 THERMOMETER - STEAMER 4 SSG-040 STEAMER BOD[...]

Page 14 R-3848[...]