BTC BCO4816IM инструкция обслуживания

Combo Drive CD-R 48X/CD-RW 24X/DVD 16X User’s Manual[...]

CLASS 1 LA SER PRODUCT APPA REIL A LA SER DE CLASSE 1 LASER KLA SSE 1 LUOKAN 1 LA SERLAITE PRODUIT LASER CATEGORIE 1 DANGER INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN A TTENTION RADIATION DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. E[...]

FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC Warning Statement This equipment has been teste[...]

Table of Contents INTRODUCTION 1 F EATURES 1 S YSTEM R EQUIREMENTS 2 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 5 S OFTWARE D ESCRIPTION 6 DVD R EGION C ODING 6 OPERATION & CONNECTION 8 F RONT P ANEL 8 R EAR V IEW 9 TECHNICAL DATA 11 TROUBLESHOOTING 13[...]

COMBO DRIVE 1 INTRODUCTION Features Welcome to a multimedia world of CD-ReWritable technology and DVD-ROM capabilities. This high-performance combo drive combines CD-RW and DVD- ROM in one single drive which frees up precious bay space and presents you abundant function. It reads CDs of a ll types at maximum 48X speed, and DVD-ROMs at 16X speed max[...]

COMBO DRIVE System Requirements For IBM compatible PCs, the sy stem requirements recommended are as follows: ♦ PC sufficient to run Windows 95/98/Me or WindowsNT/2000/XP ♦ Pentium II, Celeron 400MHz & above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ [...]

COMBO DRIVE 3 INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices , but it is recommended that you separate IDE ports for your hard driv e and your Combo drive. This will ensure that your hard drive?[...]

COMBO DRIVE MAST ER CSEL SLAVE JUMPER Improper or conflicting setting will c ause the unit not detected by your system. Hardware Installation 1. Turn off the power to your computer system and all peripheral devices. 2. Disconnect all cables and connectors from the back of your computer, and then remove the cover from the computer. 3. Insert the Com[...]

COMBO DRIVE 5. If you have a sound card that can be connected to this drive, you can also connect the drive (as Audio-Out) and the sound card (as Audio-in) with a 4-pin audio cable. If your mainboad is integrated with built-in sound system, plug the 4-pin audio cable into the CD-IN connector on the mainboard as Audio-in. 6. Re-attach the cover of t[...]

COMBO DRIVE 6 Software Description Burning Software The bundled mastering software gives you the complete solution for making audio/data CDs right from your desktop. It allows you to copy files from your computer to a reco rdable compact disc. In addition, the audio CDs you create can be played in your home or car CD player. For the CD-RW media, yo[...]

COMBO DRIVE 7 systems with DVD-Video capability. You can only play DVD-Video discs with the same region code as your DVD-Video Playback system. As for DVD-ROM drives, one kind of the DVD-Video Playback system, there are 2 types: RPC Phase 1 (as RPC1) : RPC1 drives do not have built-in hardware support for region management. DVD-ROM drives of this k[...]

COMBO DRIVE 8 OPERATION & CONNECTION Front Panel 1. Headphone Jack By plugging in the stereo mini jack here, you can listen to an audio disc directly playing from the drive with headphones. 2. Headphone Volume Control This rotary knob adjusts the volume level of the headphone output. Turning the wheel to the right will increase the audio volume[...]

COMBO DRIVE 4. Disc Tray This is the tray for the disc. Plac e the disc in the tray, then press the Close/Eject button or gently push the tray to close it. 5. Emergency Eject Hole When the Eject/Close button can’t wo rk properly and the disc tray can’t be opened, you can insert a paper clip or other small rod into this hole for manual ejection.[...]

COMBO DRIVE 10 2. Analog Audio Output Connector This connector allows you to connect the drive to your sound card with a 4-pin audio cable. 3. Device Configuration Jumper Set the jumper to Master, Slave or Cable Select according to your system configuration. 4. IDE Interface Connector Plug one end of the 40-pin IDE cable here to join the 40-pin IDE[...]

COMBO DRIVE 11 TECHNICAL DATA Performance Transfer rate Read: CD-ROM: 7200kb/sec (up to 48X) CD-RW: 4800kb/sec (up to 32X) DVD-5: 21632kb/sec (up to 16X) DVD-9: 13520kb/sec (up to 10X) Write: CD-R: 7200kb/sec (up to 48X) CD-RW: 3600kb/sec (up to 24X) Data buffer 2MB Writing modes TAO (Track at once), DAO (Disc at Once), SAO (Session at once), Multi[...]

COMBO DRIVE 12 Compact Disc Disc Size 80mm and 120mm discs Disc Data Capacity DVD-ROM: Single layer – 4.7GB Dual layer – 8.5GB (one side) CD-ROM: 74min – 650MB – Mode 1 80min – 700MB – Mode 1 Disc Format Supported Write Read CD-DA   CD-ROM   CD-ROM XA   CD-EXTRA   Video CD   Photo CD   CD-I   CD[...]

COMBO DRIVE 13 TROUBLESHOOTING To help you get more familiar with t he Combo Drive, the following FAQ lists some common problems you might encounter. Please read it for reference before you request RMA support from your dealer. Q1. The drive cannot be recognized. (1) It’s possible the drive hasn’t been connected properly. Please check whether t[...]

COMBO DRIVE 14 Q5. The drive can’t read former session(s) of the CD-R disc w hich has been w ritten tw ice or more times. Before writing CD-R discs with data copy, remember to choose “Import session” so as to read the former sessions. Q6. There is noise w hile reading. If the disc used is eccentric or there are labels stuck on the di sc surfa[...]

COMBO DRIVE 15 (2) More capacity of hard disk is needed if using hard disk as temporary buffer. (3) Place the disc correctly. (4) The blank disc needs full format first if using packet writing software. Q11. “Buffer underrun” alw ays occurs while w riting discs. Here are some suggestions: (1) Close the screen saver & TSR (Terminate and Stay[...]

3100551550 Version 1.0 April 2003[...]