CDA FF820 инструкция обслуживания

Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .care@cda.eu W : www .cda.eu FF820 Freestanding Full Height Larder Fridge Manual for Installation, Use and Maintenance[...]

2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appliance is not designed to be used by people (in[...]

3 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (L ow voltage) and requirements of EMC Directive 2004/108/EEC. This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electri[...]

4 Before First Use Y ou must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior . The fridge may have an odour to it at first use.[...]

5 • Do not splash water onto the top or back of this appliance. • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator . W arm food should be allowed to cool to room temperature before being put into the refrigerator . • Nothing should rest against the internal rear wall of the refrigerator , as this wi[...]

6 Control P anel D A B C A On/O key B Increase temperature key C Decrease temperature key D High humidity function key E High humidity indicator fig. 1 Switching the fridge on and o T o switch on the fridge for the first time, press and hold the On/O key (A) for three seconds. The fridge will beep twice, and will run at the factory prese[...]

7 high humidity indicator will show on the display and the fridge will beep twice to confirm the setting. T o switch the high humidity function o , press and hold the high humidity key for three seconds. The high humidity indicator on the display will switch o and the fridge will beep twice to confirm the setting. Please note: The temperatu[...]

8 fig. 2 Defrosting the Fridge The fridge is self-defrosting. The defrosted water is collected in the evaporating tray at the back of the appliance. Adjusting the shelves The fridge shelves can be moved according to the storage requirements within the fridge section. T o move the shelf , lift up the front section and then pull it outwards. T o rep[...]

9 Care and Cleaning Always disconnect the appliance from the power supply before any cleaning or maintenance. • The refrigerator should be cleaned using a solution of bicarbonate of soda and lukewarm water . • Do not use abrasive products or detergents. After washing, rinse and dry thoroughly . • Clean the shelves and balconies separately by [...]

10 T roubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CD A Customer Care to prevent unnecessary service calls and potential cost. The appliance is not working • Check there is power to the appliance: • The house fuses are intact and the fuse in the plug has not blown. • The the[...]

11 There is water in the lower part of the refrigerator compartment • The drain hole in the channel at the back of the compartment is clear . Please note: The LED lighting cannot be replaced without a service call. If the light fails, contact CD A Customer Care. Error Codes The display will show error codes if there is a fault with the appliance.[...]

12 Installation And V entilation This appliance must never be installed close to heat sources i.e. heating elements, cookers or in damp places The diagram shows the ventilation requirements for your product. Failure to provide adequate ventilation can lead to increased running costs and premature failure and may invalidate the warranty provided wit[...]

13 R eversing the Door W e recommend you seek the help of another individual to support the doors whilst performing this operation. 1. Carefully remove the two hinge cover plates and two cover caps from the control panel. 2. Remove the control panel, ensuring that the wires are not damaged. W e recommend you secure the control panel with masking ta[...]

14 opposite side, leaving the screwhead appro ximately 3mm proud of the appliance. 6. Remove the lower hinge and reposition the lower hinge pin as shown in figure 5. 7 . R eposition the lower hinge on the opposite side as shown in fig 7 . 8. Reverse the upper hinge pin as shown in fig 6. 9 . Locate the door on the lower hinge pin, then locate th[...]

15 Electrical Information W arning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. T o change a fuse in this type of plug, follow the steps below: 1. R emove the fuse cover and fuse. 2. Fit replacement 13A fuse, A ST A approved to BS 1362 type, into the fuse cover . 3. R eplace f[...]

16 As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- • The wire which is coloured GREEN and YELLO W must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELL O W . • T[...]

17[...]

18 NO TES[...]

19 NO TES[...]

Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu[...]