CDA HCG520 инструкция обслуживания

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style HCG500 / HCG520 gas hobs Manual for Inst allation, Use and Maintenanc e[...]

Important The CDA Gr oup Ltd cannot be held r esponsible for injuries or losses caused by incorr ect use or installation of this product. Please note that CDA reserv e the right to invalidate the guarant ee supplied with this product following incorr ect installation or misuse of the appliance or use in a commer cial envir onment. This appliance is[...]

Using your hob Fig. 1 2 3 1 4 5 6 7 8 Gas burners: 1 . Rapid burner 3.0kW 2. Left Semi-Rapid burner 1 .75kW 3. Right Semi-Rapid burner 1 .75kW 4. Auxiliary burner 1 .0kW Contr ol panel: 5. Right Semi-Rapid burner contr ol knob 6. Left Semi-Rapid burner c ontrol knob 7 . Rapid burner contr ol knob 8. Auxiliary burner contr ol knob This appliance is [...]

Igniting the Burners T o ignite the burner s, follo w these instructions: 1 . Lightly press the control knob (shown on the right) and turn the knob anti- clockwise to the maximum position. Pr ess and hold the control down t o begin the igni tion pr ocess (a cli cking sound will be hear d). 2. Once the burner is lit, adjust the burner power to the r[...]

T otal rated gas input : 7 .5kW Mains electrical voltage: 230 – 240V ac T otal rated electrical consumption: <1W If your Hob is not w orking 1 . Check that the mains supply has not been swit ched off. 2. Check that the fuse in the spur has not blown. 3. Ensure that the burner components ar e not excessively soiled as this can lead t o ignition[...]

DOUBLE POLE SWIT CHED FUSE SPUR OUTLET USE A 3 AMP FUSE Mains Electricity Connection THIS APPLIANCE MUST BE C ONNECTED T O THE MAINS SUPPL Y BY A CO MPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWIT CHED FUSE SPUR OUTLET AND PRO TECTED BY A 3A FUSE. W e r ecommend that the appliance is connected by a qualified electrician, who is a member [...]

Room V olume (m 3 ) 5 6 to 1 0 6 to 1 1 1 1 or more Air V ent Requir ed (cm 3 ) 1 00 50 No permanent vent r equired if a door opens to the outside None requir ed Gas Supply Requir ements IMPOR T ANT : THIS APPLIANCE SHOULD BE FITTED BY A GAS S AFE REGIS TERED FITTER OR O THER SUIT ABL Y QUALIFIED PERSON. • This inst allation must comply with the [...]

Natur al Gas to LPG Con v ersion This hob can be converted from natural gas to pr opane operation at a nominal inlet pressure of 37mbar , or butane operation at a nominal inlet pressur e of 28/30mbar . This conver sion must only be carried out by a competent person (i.e. a Gas Safe r egister ed fitter). Instructions to fit r eplacement injector s[...]

Fitting the Hob Unpacking the hob: T ake care not to lose or mishandle an y parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 1 85mm away from any adjacent vertical surfaces, e.g. a t all cupboar d end panel. This ma y be reduced to 1 00mm if the adjac ent surfac e is resistan[...]

How t o install the hob: Overall dimensions of the hob: Width: 585mm Depth: 500mm W orktop cut-out dimensions: Width: 550mm Depth: 4 70mm 1 . Make the requir ed hole in the worktop. Befor e doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the requir ed clearance. The cut-out (Fig.4) shows a 65mm[...]

Not es :[...]

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style T o c ontact our Customer Car e Department, or for Service, please contact us on the det ails below .[...]