Chamberlain MR850 инструкция обслуживания

professional w ww.chamberlainanz.com MR850 MR850/MR650 Rolling Garage Door Opener Installation and Operating Instructions Owners Copy: Please keep these instructions for future reference This manual contains IMPORT ANT SAFETY information DO NOT PROCEED WITH THE INST ALLA TION BEFORE READING THOROUGHL Y www .chamberlainanz.com[...]

1 CONTENTS P AGE SAFETY INSTRUCTIONS . . . . . . . .1 CART ON INVENTOR Y . . . . . . . . . .2 TOOLS REQUIRED . . . . . . . . . . . .2 DOOR REQUIREMENTS . . . . . . . .2 PREP ARE & TEST THE DOOR . .3-4 INST ALLA TION . . . . . . . . . . . . . .5-6 CONNECT ELECTRIC POWER . . .6 ADJUSTMENT . . . . . . . . . . . . . . .7-8 INST ALL THE PROTECTOR S [...]

1. Instruction manual (this document) 2. Stop collar 3. Clamp bracket 4. Release handle, cord and risk of entrapment card 5. T ransmitters (2) 6. Wireless wall button 7. Hardware bag 8. Weight bar 9. Clamp plate 10. W arning label and risk of entrapment label C ARTON INVENT OR Y 1 TOOLS REQUIRED 2 1. Ladder 2. Adjustable wrench for U-bolts already [...]

T ESTING THE DOOR 4 Complete the following test to ensure your door is well balanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door . • Lift the door to about halfway and then release it. The door should remain spring balanced. • Raise and lower the door to determine if there are any sticki[...]

PINNING THE DOOR Note: A ballooning door may delay the safety reversal response and can compromise garage door security . • T o remedy any ballooning place self tapping metal screws or rivets where the curtain leaves the roll. Secure these through the curtain into the drum wheel at each end of the roll. • After determining the correct fastener [...]

5 Release cable R ope Manual Release Warning Label Release handle Overhand knot Optional accessory not provided • Align the extension pole holes with the drive legs. • Insert the extension poles into the drive leg and fix in place using screws provided. • Slide the reinforcing brace over the poles and fix in p lace using the screws provided. [...]

6 I NST ALLA TION PROCEDURE NOTE: The opener can be installed on either side of the door . The following instructions are for RIGHT HAND INST ALLA TIONS (as illustrated i.e. inside the garage looking out). For left hand installations, reverse the instruction terminology (eg LEFT for RIGHT etc). Preparation: • Place the opener in manual release mo[...]

7 SETTING THE LIMITS & RIGHT OR LEFT OPERA TION T ravel limits set how far your door goes up and down. Y our opener must be configured correctly for right or left hand installation to operate correctly , if not the door will rotate in the reverse direction. NOTE: The MR850/MR650 opener is factory configured for right hand installation. 13 profe[...]

8 T he force, as measured on the closing edge of the door , should not exceed 400N (40kgf). If the closing force is measured to more than 400N, the Protector System T M (IR Beams) must be installed (refer section 17). • Press the LRN button twice to place the opener into f orce adjustment mode. The indicator LED will flash q uickly . • Press th[...]

9 NOTE: This accessory must be used for all installations where the closing force as measured o n the bottom of the door is over 400N (40kgf). A fter the opener has been installed and adjusted, the Prot ect or Sys tem™ accessory can be installed. Instructions are included with this accessory . The Protector System™ provides an additional measur[...]

WIRELESS PROGRAMING (OPTIONAL ACCESSORIES) NOTE: T ransmitter(s) and wall button supplied with your opener are factory programmed. INST ALLING YOUR CM128 WIRELESS W ALL BUTT ON T o install: • Carefully pry open the CM128 and locate the two screws for mounting. • Attach to the wall using the two screws and wall anchors provided if mounting to a [...]

1 1 p r o f e s s io n a l Wireless fingerprint access system C379 Full instructions are available with this accessory . Once you have enrolled your user into the C379 you can program the unit into your opener . Using the “LRN” Button: 1. Press and release the LRN button on the opener , the orange LED will light. 2. Within 30 seconds, slide the[...]

7 8 Black Red jumper wire 3 2 5 6 4 1 7 S PECIAL FEA TURES (OPTIONAL ACCESSORIES) 1 . Solenoid roller door lock (SRDLK01) - (MR850 only) 2. 24VDC power output for external devices - (MR850 only) 3. V oltage free door monitoring output - (MR850 only) 4. The Protector System T M IR Beams - C77 5 . Motion detecting control panel - C98 6. Standby Power[...]

13 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons i n order to avoid hazard. 0 01A6621 041A681 1 041A6813 001A6528 0 41A6815 (MR850) 0 41A7282 (MR650) 041A6814 (MR850) 0 41A7292 (MR650) 001B6681 041A6778 (MR850) 0 41A6778-1 (MR650) 0 41D6637 (MR850) 041D6637-1 (MR650) 041A681[...]

14 1 2 3 4 5 8 9 10 1 1 12 13 L O C K L I G H T 6 14 7 ENROLL FAIL RET RY SEND PASS READY ENROLL ACCESSORIES 1 . Model CM128 2 Channel wireless wall button 2. Model CM844 4 Channel transmitter 3. Model C940 1 Channel transmitter 4. Model C943 3 Channel transmitter 5. Model C945 3 Channel mini transmitter 6. Model C840 Keyless entry system 7. Model [...]

15 DIAGNOSTIC CHART Symptom: One or both of the indicator lights on the IR Beams are not on s teadily . • Inspect sensor wires for an electrical short (eg. staple in wire), correct wiring polarity (black/white wires reversed), broken or disconnected wires, replace/attach as needed. • Disconnect all wires from the opener . • Remove beams from [...]

T ROUBLESHOOTING 1. The opener will not operate from either the A CTIV A TION button or the transmitters : • Does the opener have electric power? Plug a lamp into t he outlet. If it does not work, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice or snow un[...]

OPERA TION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The ACTIV A TION button Press the button until door starts to move. • The wall control, outside keyswitch or keyless entry system (if you have installed any of these accessories). • The T ransmitter or Wireless W all Control (CM128) Hold the push button[...]

Liability – Australia only Un de r no c ir cu ms ta nc es s ha ll t he S el le r be l ia bl e fo r consequential, incidental or special damages arising in connection with the use, or inability to use, the Unit. In no event shall the Seller's liability for damages or injury arising from breach of law or contract or for negligence, exceed the [...]

1 14B3630D © 2009 The Chamberlain Group, Inc TM T rademark of The Chamberlain Group, Inc. ® Registered Trademark of The Chamberlain Group, Inc.[...]