Crestron electronic TPS-IMPC инструкция обслуживания

Crestron TPS-IMPC Interface Module Operations Guide[...]

This document was prepared and written by th e Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of th eir respective owners. ©2003 Crestron Electronics, Inc.[...]

Crestron TPS-IMPC Interface Module Contents Interface Module: TPS-IMPC 1 Introduction ...................................................................................... 1 Features & Functions ............................................................. 1 Specificat ions ......................................................................[...]

[...]

Crestron TPS-IMPC Interface Module Interface Module: TPS-IMPC Introduction Features & Functions The TPS-IMPC is an interface modul e designed for, and included with the Crestron  TPS-3000, TPS-5000, and TPS- 6000 tilt touchpanels. The sleek design of the touchpanel base le ft little room for all the connectors that define the touchpanel&apos[...]

Interface Module Crestron TPS-IMPC Physical Description The TPS-IMPC, shown in the following diagram, is supplied with the TPS-3000, TPS-5000, and TPS-6000 ti lt touchpanels. The module is housed in a black enclos ure with a silk-screened top panel. An AC adapter port, network connector, and video input connectors are located on one side of the uni[...]

Crestron TPS-IMPC Interface Module NTSC/PAL VIDEO The NTSC/PAL video input consists of three connectors; two BNC connectors for unbalanced video signals and one 6-pin mini-connector for twisted pair wiring of balanced video signals. The video signal is connected to these ports and requires a TPS-3000 or installation of the TPS-VID-1 or TPS-VID-2 vi[...]

Interface Module Crestron TPS-IMPC CAUTION: If power is provided to the TPS-IMPC from the +24VDC on a Cresnet connector or the PW-2420RU, power must not be applied to the power input on the touchpanel base. NOTE: When power is supplied through this connector, Crestron recommends disconnecting the +24 VD C on the Cresnet connector (if it is connecte[...]

Crestron TPS-IMPC Interface Module CAUTION: The 10-pin RJ-45 net/video connector cable supplied by Crestron is a custom cable and is th e only one that should be used. The end of the cable has a metal shield that is required to protect the equipment. Using non-Crestron cables will result in damage to the product. AUDIO (To Panel) AUDIO 1 This 8-pin[...]

Interface Module Crestron TPS-IMPC AUDIO INPUT Pinouts PIN DESCRIPTION S Shield R + Right Positive R - Right Negative L + Left Positive L- Left Negative S Shield MIC OUT The port mates with a three-pin connector (supplied) and produces line level differential output. Descriptio n of the pinouts is shown in the following table. MIC OUT Pinouts PIN D[...]

Crestron TPS-IMPC Interface Module Industry Compliance As of the date of manufacture, the TPS-IMPC has been tested and found to comply with specifications for CE marking and st andards per EMC and Radiocommunications Comp liance Labelling (N11785). Setup Network Wiring CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to do [...]

Interface Module Crestron TPS-IMPC must be taken into consideration. If network units are to be daisy-chained on the run, the power factor of each network unit to be daisy-chained must be added together to determine the power factor of the entire chain. The length of the run in feet and th e power factor of the run should be used in the following r[...]

Crestron TPS-IMPC Interface Module TPS-5000 or TPS-6000 touchpanel a nd a video window object resides on a page within the uploaded Crestron VisionTools ® Pro-e (VT Pro-e) project. NOTE: When connecting the net/video cable from the interface module to the touchpanel, exceeding a cable length of 30 feet will significantly degrade the video signal. [...]

Interface Module Crestron TPS-IMPC Problem Solving Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. TPS-IMPC Troubleshooting TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Touchpanel is not receiving power. Confi[...]

Crestron TPS-IMPC Interface Module TPS-IMPC Troubleshooting (continued) TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION Incorrect video format selection. Select the proper video input configuration in the touchpanel configuration SETUP MENU. Incorrect VT Pro-e project file loaded. Make sure that video window object resides in project, re- compile, and [...]

Interface Module Crestron TPS-IMPC Future Updates As Crestron improves functions, adds new features, and extends the capabilities of the TPS-IMPC, additi onal information may be made available as manual updates. Thes e updates are solely electronic and serve as intermediary supplements pr ior to the release of a complete technical documentation rev[...]

Crestron TPS-IMPC Interface Module Return and Warranty Policies Merchandise Returns / Repair Service 1. No m erchandise may be returned for cr e dit, exchange, or service without prior authorization from CRESTRON. To obt ain warranty service for C RESTRON products, cont act the fact ory and req u est an RMA (R eturn Me rchandise Authorization) numb[...]

Interface Module Crestron TPS-IMPC 14 • Interface Module: TPS-IMPC Operations Guide - DOC. 6162 This page intenti onally left blank.[...]

Crestron TPS-IMPC Interface Module Operations Guide - DOC. 6162 Interface Module: TPS-IMPC • 15 This page intenti onally left blank.[...]

Crestron Electronics, Inc. Op erations Guide - DOC. 6162 15 Volvo Drive Rockleigh, NJ 07647 06.03 Tel: 888.CRESTRON Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.[...]