CyberPower UP1200 инструкция обслуживания

User’s Manual Utility Series UPS UP1200 ADDITIONAL INST ALLA TION TIPS CAN BE F OUND A T : www .cyberpowersystems.com/support.htm[...]

2 T ABLE OF CONTENTS IMPORT ANT SAFETY WA RNIN GS …………….…………………… ………………….………1 INST ALLING YOUR UPS SYSTEM …………………….………………………………….……2 - UNP ACKING…… …… …………………………………… ………… …………..2 - HARDWARE INST ALLA TION G[...]

UP1200 Guaranteed Uninterruptible Power Syst em 3 IMPORT ANT SAFETY W ARNINGS (SA VE THESE INSTRUCTIONS) This manual contains import ant instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation and operation of the unit. R ead this manual[...]

4 INST ALLING YOUR UPS SYSTEM UNP ACKING Inspect the UPS upon receipt. The box should contain the following: (1) UPS Unit; (1) User ’s Manual for UPS; (1) Warranty Registration Card; (1) PowerPanel TM Software Disk; (1) User ’s Manual for PowerPane l TM ; (1) Serial Interface Cable (DB-9); (1) Serial-to-USB cable; (1) T elephone Cable HARDW ARE[...]

UP1200 Guaranteed Uninterruptible Power Syst em 5 ◆ Pow er Sw itch Press the power button to turn the UPS ON or OFF ◆ Power On Indicator This LED is illuminated when the utility condition is normal and the UPS outlets are providing “clean power”, free of surges and spikes ◆ Using Battery Indicator This illuminates during utility failure, [...]

6 BA TTERY REPLACEMENT AND STORAGE Contact your dealer or call the number in this manual for information on battery replacement. The order numbers for the battery are as follows: BA -UP 1200 for UP1200 CA UTIO N! Read and follow the IMPORT ANT SAFETY INSTRUCT IONS before servicing the battery . Ser vice the battery under the s upervision of person [...]

UP1200 Guaranteed Uninterruptible Power Syst em 7 8. Install the replacement battery by connecting the red wire to the positive (+) terminal of t he battery and connecting the black wire to the negative (-) terminal of the battery . 9. Slide the battery back into the compartment. 10. Replace the cover and the 4 retaining screws. 1 1. Recharge the u[...]

8 TROUBLESHOOTING Problem Possible Cause Solution Batteries are not ful ly charged. Recharge the batte ry by leaving the UPS plugged in. The UPS does not perform expected runtime. Battery is slightly worn out. Contact CyberPower Sy stems at tech@cyberpow ersystems.com The on/off sw itch is designed to prevent damage by rapidly turn ing it off an d [...]

UP1200 Guaranteed Uninterruptible Power Syst em 9 TECHNICAL SPECIFICA TIONS Model UP1200 Capacity (V A) 1200V A Capacity (W atts) 670W Input Input V oltage Range 100V ac – 140V ac Frequency Range 57 – 63 Hz Output On Battery Outpu t V oltage Simulated Sine W ave at 120V ac +/- 5% On Battery Outpu t Frequency 60 Hz +/- 1% Transfer T ime (Ty pica[...]

10 DEFINITIONS FOR ILLUMINA TED LED INDICA TORS Power On Using Battery Wiring Fault Circuit Breaker Ala r m Condition On Off Of f Set Off Normal Off On On/Off Set Tw o Beeps Utility Failure- The UP S is providing battery power to the Battery-Power Supplied outlets. Off On On/Off Set Rapid Beeps Utility Failure- The UPS is providing battery power. T[...]

UP1200 Guaranteed Uninterruptible Power Syst em 11 LIMITED W ARRANTY AND POWER CONTROL GUARANTEE In purchasing UP1200 in the United St ates or Canada, the original end user receives a Limited W arranty and CyberPower's Po wer Control Guarantee from Cyber Po wer Systems (USA), Inc. (for ease of reading, referred to as "CyberPower"). T[...]

12 Any Implied W arranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to the period of ownership by the Initial Customer . This provision shall NOT create any Implied W arranty or Merchantability or of Fitness fo r a Particular Purpose that would not otherwise apply to the Product.[...]

UP1200 Guaranteed Uninterruptible Power Syst em 13 The Limited W arranty does no t cover Connected Equipment, but as is explained below , to be covered under the Power Control Guarante e, the Connected Equipment must have been damaged due to a failure of the Product. The Connected Equipment must have been damaged due to a defect in materials or wor[...]

14 If the damage to Connected E quipment is covered by the Power Control Gu arantee, CyberPower will (in addition to Limited W arr anty remedies for the CyberPo wer Product itself) repair (or pay the costs of repair) or replace the Connected Equipment or , at the option of CyberPower , as permitted by law , pay to the Initial Customer the "Agr[...]

UP1200 Guaranteed Uninterruptible Power Syst em 15 The Limited Warranty and the Power Control Guarantee Do Not Apply Unless The Initial Customer: 1. Has properly connected the Product and the Connected Equipment to pr operly wired and grounded outlets (including compliance with el ectrical and safety codes of the most current electrical code (ANS/N[...]

16 The application of the United Nations Convention of Contracts for the International Sale of Goods is expressly excluded. Contact Information: CyberPower's address is 5555 12th Ave East, Suite 1 10, Shakopee, MN 55379 and its phone number is (952) 403-9500 or (877) 297-6937 (toll free) . CyberPower is the warrantor under this Limited Warrant[...]