Dacor MO инструкция обслуживания

Installa tion Instr uc tion s Dis cove r y W al l O ven For use with models: EO, MO and PO Part No. 65433 Rev . G Preliminary - For Review Only No Scheduled Release Date[...]

All specifications are subject to change without notice. Dacor ® assumes no liability for changes to specifications. © 2007 Dacor , all rights reserved.[...]

1 Planning the Installation ................................................... 6 Selecting the Location ...................................................... 6 Cabinet Cut-Out ............................................................... 6 Cabinet Cut-Out (continued) ............................................ 8 Electrical Specifications .....[...]

2 Impor tant Safety Instructions Read the accompanying use and care manual 1. before operating this appliance. Keep packaging materials away from children. 2. Plastic sheets and bags can cause suffocation. If you receive a damaged product, immediately 3. contact your dealer or builder . Do not install or use a damaged appliance. Do not install or u[...]

3 Model Identification EO230xxx A = MODEL tYPE Epicure Oven = EO Millennia Oven (vert. trim) = MOV Millennia Oven (horiz. trim) = MOH Preference Oven = PO B = CONFIGURA tION Single Oven = 1 Double Oven = 2 C = SIZE 27 Inch = 27 30 Inch = 30 D = FINISH Finish Options Epicure: Stainless Steel, Black Chrome T rim = SBC Stainless Steel, Chrome T rim = [...]

4 Product Specifications Model Number K L M N P Q R S EO127 27” (686mm) 27 15/16” (710mm) 23 3/8” (594mm) 2 5/16” (59mm) 7 3/8” (187mm) 6 3/8” (162mm) 26 3/8” (670mm) 25 3/8” (644mm) PO127 MOV127 MOH127 EO130 30” (762mm) 28 3/8” (721mm) PO130 MOV130 MOV130 EO227 27” (686mm) 51 3/32” (1298mm) 49 1/2” (1257mm) 25 3/8” (644[...]

5 Product Specifications Single W all Oven Dimension Double W all Oven Dimension “R” “N” “P” “Q” “M” 1 1/16” (27mm) 66” (1676mm) Flexible Conduit “K” “L” 1 1/4” (32mm) “S” “M” “L” 1 1/4” (32mm) “P” “N” 1 1/16” (27mm) “R” 66” (1676mm) Flexible Conduit “K” “Q” “S”[...]

6 “C” 9 5/8” (244mm) Recommended (May be altered) 1 ¾“ (45mm) Clear to T op of Drawer for Heat Exhaust “B” “A” 4“ T ypical T oe Kick (Shown) Recommended Electrical Location 3/4” (19mm) Support Platform 1“ (25mm) Clear to T op of Drawer for Heat Exhaust “C” “A” “B” 31 1/4” (794mm) Recommended (May be Altered) 1 ?[...]

7 1 ¾” (45mm) Min. to Combustible Floor “A” “B” “A” “B” 1 1/2” (38mm) T ypical Counter 4“ T ypical T oe Kick (Shown) Alternate Electrical Locations 3/4” (19mm) Support Platform 4“ (102mm) Min. Between Cutout 3/4” (19mm) Support Platform Recommended Electrical Location 1“ (25mm) Min. to Combustibles 36” (914mm) T ypi[...]

8 Planning the Installation Cabinet Cut-Out (continued) Suppor t Platform W ARNING The top surface of the support platform must be installed flush with the cutout in the front of the cabinet or wall and any trim. Failure to install the platform properly may cause the exhaust vent to deform and/or become obstructed. An obstructed exhaust area may ca[...]

9 Planning the Installation Electrical Specifications IMPORt ANt Preheat times and cavity temperature recovery times • will be increased slightly if operating on less than a 240 V ac circuit. This appliance is provided with electrical connec- • tion leads in a flexible metal conduit. These leads may be a smaller gage than the standard hou[...]

10 Installation Instructions Before proceeding, turn off power to the circuit to which 1. the oven will be connected at the circuit breaker or fuse box. Position the oven directly in front of the cabinet cutout. 2. Feed the appliance conduit into the electrical junction 3. box and attach it using a UL approved strain relief. Depending upon local co[...]

11 Installation Instructions Connecting to a Three Wire Electrical System - Where Local Codes Per mit W ARNING Do not connect the green appliance conduit wire to the neutral (white) junction box wire unless local building codes permit. Separate the wires coming out of the appliance conduit. 1. Connect the green and white wires from the appliance 2.[...]

12 Installation Instructions Final Installation W ARNING A minimum of two people are required to safely • install this appliance. Do not attempt to disengage the hinge catches with • the door removed from the oven. The hinge springs could release, causing personal injury . Do not lift or carry the oven door by the door handle. • On d[...]

13 Raise the door so that it is at a 15° angle from the front 3. of the oven. Hold the door with one hand on each side. Lift the door up and out. Install the Oven in the Cabinet W ARNING Use an appliance dolly to move the appliance when • installing it or removing it from the wall for service. Use of an appliance dolly will minimize the risk [...]

14 Grasp the oven door on opposite sides and hold it at a 1. 15° angle from the front of the oven. See facing page. Slide the hinges into the hinge openings, resting the 2. bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand 3. while pushing in on each of the bottom corners of the door . Push [...]

15 Installation Instructions Door Installation Installation Checklist W ARNING T o ensure a safe and proper installation, the follow- • ing checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the hom- • eowner . The importance of proper[...]

16 Notes[...]

[...]

Dacor ● 1440 Bridge Gate Drive, Diamond Bar , CA 91765 ● T el: (800) 793-0093 ● F AX: (626) 403-3130 ● www .Dacor.com[...]