Eclipse - Fujitsu Ten AVN5510 инструкция обслуживания

Contents Contents Components Installation Diagram Before installation Installation Connections 2 For your safety in using the AVN5510 3 5 Names and functions of terminals 6 Installing the GPS antenna Installing the main unit 13 16 DVD Navigation System with 7" Wide TFT Display and DVD Multi-Source Receiver INST ALLA TION MANU AL Connecting the[...]

- 2 - Components Components Check that all of the following components are present Check that all of the following components are present GPS antenna components GPS antenna x 1 10 Waterproof cushion x 1 11 Ground plate x 1 12 Body protective sheet x 1 13 When installing the main unit, some vehicle models may require the use of items that need to be[...]

- 3 - Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the AVN5510. They show safe and correct ways to handle the main unit to prevent personal injury to you and others and avoid damage to property. Before reading through the manual, take time to read through and learn the important information listed i[...]

- 4 - • • This main unit must be operated only as on-board main unit, or it may cause electrical shock or injury. • • Do not play distorted sounds for long periods of time; the speakers may overheat and cause a fire. • • Once installation and wiring have been completed, return the brakes and electrical equipment such as lights, horn, ha[...]

- 5 - Installation Diag Installation Diag r r am am GPS antenna (When installing inside the vehicle) 10 GPS antenna (When installing outside the vehicle) 10 • • If installing the GPS antenna inside the vehicle, the location and the slope of the vehicle's windshield will determine the accuracy of the GPS antenna to receive the GPS signal. I[...]

- 6 - • • Never cut the insulation on the power wire or use it to power any other equipment. If the rated current capacity of the power wire is exceeded, fire and electric shocks may result. • • The wires should be secured with tape or a similar securing method to prevent any obstructions while driving. If they get wound or entangled around[...]

- 7 - Wire colors and connection points f or connection wires , and 4 3 2 Never connect the power supply to the speaker wires (No.7 and No.8), otherwise it will cause damage to the main unit. Caution B+ (Yellow) Connect where power is constantly available, regardless of the ignition key's position. ACC (Red) Connect where the power comes on wh[...]

- 8 - English Español Français Italiano Nederlands Svenska English VTR output terminals Connect to the monitor with video input. Genuine steering remote control terminal Connect to the vehicle steering remote control. ※ Compatible vehicle models for installation : Vehicles with voltage detection-type steering remote control. Ask your dealer for[...]

- 9 - Vehicle component adapter wires Vehicle harness From main unit - Example of using vehicle adapter wires - - V ehicle connections - Power supplies for combined equipment Español Français Italiano Nederlands Svenska English • • You will need to purchase the necessary vehicle component adapter wire for the vehicle so that the power supplie[...]

- 10 - Notes on installation • • Check the vehicle speed pulse signal, parking brake signal, and reverse signal carefully before making the connections. If the wires are incorrectly connected, accidents or problems with correct operation may result. • • The label on the vehicle speed pulse signal wire contains a protection circuit, so do no[...]

Route the parking brake signal wire to the main unit. - 11 - Foot-operated parking brake Hand-operated parking brake - A connecting the point for parking brake signal (example) - Attach a splicing connector at this location. Reverse signal wire Reverse lamp Reverse signal wire - A connecting point for the reverse signal (example) - • • Be sure [...]

- 12 - System connection e System connection e xample xample • • Install and connect all of the peripheral units before connecting them to the main unit. • • Do not remove any of the protective caps (RCA, etc.) unless in use. • • Be sure to wrap the connection wires with tape (PVC tape) to insulate them. Tip • • Never cut the insula[...]

- 13 - Tip Installing the GPS antenna Installing the GPS antenna Notes on installation • • Do not install the antenna in places (such as front pillars and roof panel) that are shielded from the sky. • • The GPS antenna should be installed in a level position where the signals will be as unobstructed as much as possible, such as on the vehic[...]

- 14 - - Installation inside the vehicle (example) - Choose an installation location on the dashboard which is flat and has a clear view of the sky. 1 Install the ground plate to the dashboard. 2 Install the GPS antenna to the ground plate. 3 Ground plate 12 Secure the GPS antenna. 4 Route the GPS antenna wire along the crevice between the front wi[...]

- 15 - - Installation outside the vehicle (example) - Choose an installation location where the GPS antenna can be attached securely. 1 Remove the backing paper from the body protective sheet and attach the sheet to the vehicle. 2 Install the GPS antenna on top of the body protective sheet. 3 Body protective sheet (clear) 13 Route the GPS antenna w[...]

Remove the pocket and any other accessories from the center cluster to make room for the main unit. 1 Remove the mounting brackets for the pocket. 2 Attach the brackets to the main unit. 3 Install the main unit in the vehicle. 4 Be careful not to forcefully push on the main unit's display or buttons during installation. This may result in dama[...]