Electrolux 193733 инструкция обслуживания

SELF-PROPELLED ROT AR Y LA WN MOWER W ARNING: This lawn mower is equipped with an internal com bus tion engine and should not be used on or near any un im proved forest-covered, brush-covered or grass-cov ered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arre[...]

2 Safety Rules ................. 2-3 Assembly ...................... 4-7 Operation .................... 8-15 Storage ..................... 25-26 T roubleshooting ........ 26-27 SAFETY RULES T ABLE OF CONTENTS IMPORT ANT : This cutting machine is capable of amputating hands and feet and throwing ob- jects. Failure to observe the following safety ins[...]

26 CYLINDER • Remove spark plug. • Pour one ounce (29 ml) of oil through spark plug hole into cylinder . • Pull starter handle slowly to dis trib ute oil. • Replace with new spark plug. BA TTER Y (IF EQUIPPED) Disconnect the battery from the engine connector and charge battery 48 hours. OTHER • Do not store gasoline from one sea son to an[...]

4 CAUTION: Do not operate this lawn mower without the discharge guard or an entire approved grass catcher in place. These guards are for your protection and are required by the American National Standards Institute and Consumer Prod- ucts Safety Com mis sion. CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in[...]

24 MODELS WITH GEARCASE-MOUNTED BEL T KEEPER AND NO DEBRIS SHIELD: • Remove drive cover . • Remove spring and belt keeper . • Remove belt from gearcase pulley . • Route the other end of the new drive belt through hole in housing. • Return mower to upright po si tion. • Install new belt on gearcase pulley . • Reinstall belt keeper and [...]

6 CAUTION: Under normal usage, the catcher material is subject to de te ri o ra tion and wear and should, therefore, be checked frequently for replacement. Any replacement catcher should be checked to ensure compliance with original man u fac - tur er's spec i fi ca tions. CAUTION: Do not run lawn mower with out the discharge guard (rear door[...]

22 MODELS WITH GEARCASE-MOUNTED BEL T KEEPER AND NO DEBRIS SHIELD: • Remove drive cover and belt keeper . • Remove belt from gearcase pulley . • T urn lawn mower on its side. See engine manual for proper direction of turning over the engine. • Remove blade and blade adapter . • Remove belt from pulley of blade adapter . • Install new be[...]

8 Remote throttle control FA S T SLOW CHOKE (ST ART) OPERA TION The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or performing any ad just ments or repairs. We recommend standard safety glasses or a wid[...]

20 Debris shield Drive belt Belt retainers DEBRIS SHIELDS WITH BEL T RET AINERS: Belt Drive cover PUSH DOWN Pulley OR: Debris shield Drive belt Belt retainer Engine pulley 3 POSITION “QUICK” The handle on your lawn mower has three (3) height positions - adjust to height that suits you. • Squeeze the bottom ends of lower handle towards each ot[...]

10 “COMBI-CUT” MOWERS Y our lawn mower was shipped ready to be used as a mulcher . T o convert to bagging or discharging: REAR BAGGING • Open rear door and remove mulcher plate. Store mulcher plate in a safe place. • Y ou can now install grass catcher. • T o convert to mulching or discharging operation, install mulcher plug into rear disc[...]

18 DRIVE WHEELS Check drive wheels each time before you mow to be sure they move freely . The wheels not turning freely means trash, grass cuttings, etc. are in the drive wheel area and must be cleaned to free drive wheels. If necessary to clean the drive wheels, check both drive wheels. • If after cleaning, the drive wheels do not turn freely , [...]

12 “AUTOW ALK” DRIVE CONTROL • Self-propelling is controlled by hold ing the operator presence control bar down to the handle and pulling the drive con- trol lever(s) rearward to the handle. The farther toward the handle the lever(s) are pulled, the faster the unit will travel. • Forward motion will stop when either the operator presence co[...]

16 ➀ Spray lubricant ➁ See “ENGINE” in Maintenance section. MAINTENANCE Check f or Loose F asteners Clean / Inspect Grass Catcher * Check Tires Check Driv e Wheels *** Clean Lawn Mo wer **** Clean under Drive Cov er *** Check Driv e Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Batter y ** Check Engine Oi[...]

14 Recoil starter handle Operator presence control bar MODELS WITH RECOIL ST ART ER • Pull starter handle quickly . Do not allow starter rope to snap back. BEFORE ST ARTING EN GINE Read the engine manual packed with your mower . FILL ENGINE WITH OIL Y our lawn mower is shipped without oil in the engine. • Be sure mower is level and area around [...]

14 Recoil starter handle Operator presence control bar MODELS WITH RECOIL ST ART ER • Pull starter handle quickly . Do not allow starter rope to snap back. BEFORE ST ARTING EN GINE Read the engine manual packed with your mower . FILL ENGINE WITH OIL Y our lawn mower is shipped without oil in the engine. • Be sure mower is level and area around [...]

16 ➀ Spray lubricant ➁ See “ENGINE” in Maintenance section. MAINTENANCE Check f or Loose F asteners Clean / Inspect Grass Catcher * Check Tires Check Driv e Wheels *** Clean Lawn Mo wer **** Clean under Drive Cov er *** Check Driv e Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Batter y ** Check Engine Oi[...]

12 “AUTOW ALK” DRIVE CONTROL • Self-propelling is controlled by hold ing the operator presence control bar down to the handle and pulling the drive con- trol lever(s) rearward to the handle. The farther toward the handle the lever(s) are pulled, the faster the unit will travel. • Forward motion will stop when either the operator presence co[...]

18 DRIVE WHEELS Check drive wheels each time before you mow to be sure they move freely . The wheels not turning freely means trash, grass cuttings, etc. are in the drive wheel area and must be cleaned to free drive wheels. If necessary to clean the drive wheels, check both drive wheels. • If after cleaning, the drive wheels do not turn freely , [...]

10 “COMBI-CUT” MOWERS Y our lawn mower was shipped ready to be used as a mulcher . T o convert to bagging or discharging: REAR BAGGING • Open rear door and remove mulcher plate. Store mulcher plate in a safe place. • Y ou can now install grass catcher. • T o convert to mulching or discharging operation, install mulcher plug into rear disc[...]

20 Debris shield Drive belt Belt retainers DEBRIS SHIELDS WITH BEL T RET AINERS: Belt Drive cover PUSH DOWN Pulley OR: Debris shield Drive belt Belt retainer Engine pulley 3 POSITION “QUICK” The handle on your lawn mower has three (3) height positions - adjust to height that suits you. • Squeeze the bottom ends of lower handle towards each ot[...]

8 Remote throttle control FA S T SLOW CHOKE (ST ART) OPERA TION The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or performing any ad just ments or repairs. We recommend standard safety glasses or a wid[...]

22 MODELS WITH GEARCASE-MOUNTED BEL T KEEPER AND NO DEBRIS SHIELD: • Remove drive cover and belt keeper . • Remove belt from gearcase pulley . • T urn lawn mower on its side. See engine manual for proper direction of turning over the engine. • Remove blade and blade adapter . • Remove belt from pulley of blade adapter . • Install new be[...]

6 CAUTION: Under normal usage, the catcher material is subject to de te ri o ra tion and wear and should, therefore, be checked frequently for replacement. Any replacement catcher should be checked to ensure compliance with original man u fac - tur er's spec i fi ca tions. CAUTION: Do not run lawn mower with out the discharge guard (rear door[...]

24 MODELS WITH GEARCASE-MOUNTED BEL T KEEPER AND NO DEBRIS SHIELD: • Remove drive cover . • Remove spring and belt keeper . • Remove belt from gearcase pulley . • Route the other end of the new drive belt through hole in housing. • Return mower to upright po si tion. • Install new belt on gearcase pulley . • Reinstall belt keeper and [...]

4 CAUTION: Do not operate this lawn mower without the discharge guard or an entire approved grass catcher in place. These guards are for your protection and are required by the American National Standards Institute and Consumer Prod- ucts Safety Com mis sion. CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in[...]

26 CYLINDER • Remove spark plug. • Pour one ounce (29 ml) of oil through spark plug hole into cylinder . • Pull starter handle slowly to dis trib ute oil. • Replace with new spark plug. BA TTER Y (IF EQUIPPED) Disconnect the battery from the engine connector and charge battery 48 hours. OTHER • Do not store gasoline from one sea son to an[...]

2 Safety Rules ................. 2-3 Assembly ...................... 4-7 Operation .................... 8-15 Storage ..................... 25-26 T roubleshooting ........ 26-27 SAFETY RULES T ABLE OF CONTENTS IMPORT ANT : This cutting machine is capable of amputating hands and feet and throwing ob- jects. Failure to observe the following safety ins[...]

SELF-PROPELLED ROT AR Y LA WN MOWER W ARNING: This lawn mower is equipped with an internal com bus tion engine and should not be used on or near any un im proved forest-covered, brush-covered or grass-cov ered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arre[...]