Electrolux 316495008 инструкция обслуживания

Use & Care Guide Installation Instructions Vent Hood 316495008 - 09/2007[...]

2 Finding Information Purchase date Electrolux model number Electrolux serial number (see picture for location) Please read and save this guide Thank you for choosing Electrolux , the new premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction and product quality throughout the service life of [...]

3 Safety Important Safety Instructions Read all instructions before using this appliance. Save these instructions for future reference. Do not attempt to install or operate your appliance until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a WARNING or CAUTION based on the risk type. This [...]

4 Safety TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:* 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. 2. NEVER PICK UP A FLAMING P[...]

5 Unpack hood and check contents. You should receive: 1 - Hood 1 - Decorative Flue Assembly 1 - Support Frame 1 - Parts Bag containing: 1 - Support Frame Bracket 1 - Discharge Collar 4 - Mounting Screws (6 x 70) 16 - Mounting Screws (3,9 x 9,5mm Pan Head) 4 - Washers D.6.4mm 6 - Serrated Washers 1 - Wiring Box Cover 1 - Wire Clamp 1 - Installation [...]

6 Installation 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may be required for best performance with longer duct[...]

7 Installation 1. At hood location, install 2 X 4 cross framing between ceiling joists using dimensions shown. 2. Finish the ceiling surface. Be sure to mark the location of the ceiling joists and cross framing. 3. Secure the support frame bracket to joists and cross framing with four screws provided (6x70mm) and four washers (D. 6.4mm). Make sure [...]

8 Installation Prepare the hood NOTE On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation. Fix the electrical mounting plate with (2) 3.9x9.5mm screws and (2) serrated washers. Fig. 3. FIG. 3 DUCTED CONFIGURATION Mount the discharge collar abo[...]

9 Installation Connect decorative flue 1. Secure the upper flue to the upper support frame with the mounting screws (3.9x9.5mm). Fig. 8. 2. Insert the lower flue moving it completely towards the top and fix it temporarily with a tape. Fig. 9. LOWER FLUE UPPER FLUE MOUNTING SCREWS (3.9x9.5mm) FIG. 8 FIG. 9 TAPE Install the hood Fix the hood to the s[...]

10 Installation (DUCTED AND NON-DUCTED HOODS) 1. To remove the GREASE filters, pull the metal latch ta b outside and unlock the filter. 2. To install the GREASE filters, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation. (NON-DUC[...]

11 The grease filters should be cleaned when the filter reset switch will be illuminated. Use a warm detergent solution. Grease filters are dishwasher safe. See “INSTALL FILTERS” section for removal and installation instructions. Once the grease filters are cleaned and installed, press in and hold the “filter reset switch” for approximately[...]

12 Operation Controls Dead-front mode Stand-by mode In dead-front mode, press any key for enter in stand- by mode. If the hood is in stand-by mode, after 10 seconds on return automatically in dead-front mode. Light switch Press any key for enter in stand-by mode. Push the light switch once to turn the lights ON to a dim level. Push a second time to[...]

13 Remove the grease filters. Open the fuse box. Replace with the same type of fuse (5x20mm, 4A, 125V). Fuse Key : 5304455332 FUSE BOX This range hood requires four halogen bulbs (max 20W, 12V, Type T3 bulb, G4 Base). Halogen Bulb Key : 5304454951 Halogen bulbs Operation ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON[...]

14 This range hood must be properly grounded. Improper grounding can result in a risk of electric shock. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. Turn off electrical power at service entrance before wiring. Wiring 1. Remove the (2) screws of the upper flue and mov[...]

15 Warranty Information In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc. We authorize no person to change or add to any of our obligations under this warranty. Our obligations for service and parts under this warranty must be performed by us or authorized Electro[...]

04307839/2S[...]