Electrolux DI 8610 инструкция обслуживания

DI 8610 CHDI 8610 Cooker Hood Operating and Installation Instructions[...]

55 Printed on recycled paper AEG - putting words into action Contents Safety warnings 56 For the User 56 For the Installer 56 Description of the Appliance 58 Extractor version 58 Recirculation V ersion 58 Hood Operation 59 Control device for grease and charcoal filters 60 Grease filter LED (D) 60 Charcoal filter LED (E) 60 Resetting the saturation [...]

56 Safety warnings For the User • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. • Also, when frying, keep the deep fry[...]

57 heaters and gas fires, in the same room. • Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approximately 500-600 cm 2 large to avoid the possibility of a depression being created during operation of the hood. [...]

58 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory). • Y ou will need an original AEG charcoal filter for this function (A vailable from your local AEG Service Force Centre). Extractor version • The air is discharged to th[...]

59 Hood Operation • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappe[...]

60 Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (in the case of recirculation version with charcoal filter). On delivery , the hood is not supplied with an charcoal filter , so the saturation indicator will be disabled. If the hoo[...]

61 Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild detergent. • Never use corrosive, abrasive or flammable cleaning products. • Never insert pointed objects in the motor ’ s protect[...]

62 Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • T o do this you will need an original AEG charcoal filter (available from your local Service Force Centre). • Cleaning/replacing the charcoal filter for UK The charcoal filters cannot be cleaned, we recommend that they sho[...]

63 W arning • Failure to observe the instructions on cleaning the unit and changing the filters could cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe t[...]

64 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply . Check that a fan speed has been selected The cooker hood is not working Check that: ef fectively .. The fan speed is set high enough for the[...]

65 T echnical assistance service (not for UK) Y ou are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr .) 3. The manufacturing number (F-Nr [...]

66 T echnical Specifications Dimensions: Height x Width x Depth (in cm) 80-106,5 x 100 x 65 Maximum absorbed power: 250 W Motor absorption: 1 x 170 W Lighting: 4 x20 W Length of the cable: 150 cm Mounting accessories included 1 Reduction flange Ø 150-125 1 Deflector 6 Wood-screws 6 x 70 mm 6 Wall plugs Ø 10 mm 10 Nuts 8 Metal-screw 3 x 9 mm 14 Me[...]

67 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary t[...]

68 Installation - Fig. 6-7-8 Expansion plugs are provided to secure the hood to most types of ceilings. However , a qualified technician must verify suitability of the materials in accordance with the type of ceiling. The ceiling must be strong enough to take the weight of the hood. During electrical connection ensure the power supply is disconnect[...]

69 2a 3 4 4 4 4 4 4 6 6 7 7 7 7 8 8 2a 5 7 9 10 10 10 10 11 11 14,5 273 273 244 214 190 6 12 2b 2b Fig. 6[...]

70 • For extractor versions (13A), connect the other end of the exhaust pipe to the flue. For filter versions (13F), fit deflector F to the support and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector . • Fit the nuts with fixing hooks (14) supplied inside the top an[...]

71 15 15 15 15 15 16 16 15 15 13F F 13A 15 14 Fig. 7[...]

72 19 18 18 18 18 18 18 18 18 18 18 M X 17 17 19 20 X 20 Fig. 8[...]

LI1R5C AEG Hausger ä te GmbH Postfach 1036 D-90327 N ü rnberg http:// www .aeg.hausgeraete.de http ://www .aeg.co.uk © Copyright by AEG[...]