Electrolux EHG60412 инструкция обслуживания

user manual Gas hob EHG60412[...]

Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information 2 Installation 4 Product description 8 Operating instructions 8 Helpful hints and tips 9 Care and cleaning 9 What to do if… 10 Technical data 11 Environment concerns 12 Subject to change without notice SAFETY INFORMATION Warning! These instru[...]

• Use only the accessories supplied with appliance. • Be careful when you connect the appli- ance to the near sockets. Do not let elec- tricity bonds touch the applian ce or hot cookware. Do not let electricity bonds tangle. Installation • You must read these instructions. The manufacturer is not responsible for any injury to perso ns and pet[...]

with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical in- stallation which lets you disconn ect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. • If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in [...]

components as show n in the diagram . Screw the parts together without using ex- cessive force. 1 2 3 1 End of shaft with nut 2 Washer 3 Elbow Connection to the gas supply should be with either rigid or semi -rigid pipe, i.e. steel or copper. The connection should be suitable for con- necting to R 1/2 (1/2 BSP male thread). When the final connect i[...]

• Always use a correct ly installed shock- proof socket. • Make sure that there is an access to the mains plug after installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check tha[...]

Important! The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies, in accordance with the current regulations. Replacement of the connection cable To replace the connection cable use only H05V2V2-F T90 or equiva lent type. Make sure that the cable section is applicable[...]

PRODUCT DESCRIPTION 2 1 6 5 4 3 1 Semi-rapid burner 2 Semi-rapid burner 3 Control knobs 4 Spark generator button 5 Auxiliary burner 6 Rapid burner Control knobs Symbol Description no gas supply / off position Symbol Description ignition p osition / maximum gas supply minimum gas supply OPERATING INSTRUCTIONS Ignition of the burner Warning! Be very [...]

If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after mini- mum 1 minute. The spark generator can start automat- ically when you sw itch on the mains, after installation or a power cut. It is normal. Turning the bu rner off To put the flame out, turn the knob to the symbol . Warning! [...]

After cleaning, dry the appliance with a soft cloth. The stainless steel can become tarnished if it is too much heated . Refer to this you must not c ook with potstones, earthenware pans or cast iron plates. Do not use alumi - nium foil to prevent damage the top during operation. Removing the dirt: 1. – Remove immediately: melting plas- tic, plas[...]

If there is a f ault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre. If you operated the appliance incorrect- ly, or the installa ti on was not carried out by a registered engineer, the visit from the customer se rvice technicia n or d[...]

Gas connection: R 1/2 " Category: II2H3+ Gas supply: G20 (2H) 20 mbar Appliance class: 3 By-pass diameters Burner Ø By-pass in 1/100 mm. Auxiliary 28 Burner Ø By-pass in 1/100 mm. Semi-rapid 32 Rapid 42 Gas burners BURNER NORMAL POWER RE- DUCED POWER NORMAL POWER NATURAL GAS G20 (2H) 20 mbar LPG (Butane/Propane) G30/G31 (3+) 28-30/37 mbar kW[...]

electrolux 13[...]

14 electrolux[...]

electrolux 15[...]

397194901-B-4 82010 www.electrolux.com/shop[...]