Fantom Vacuum FM743 инструкция обслуживания

REPLACEMENT PAR TS HOUSEHOLD USE ONL Y IMPORT ANT SAFETY INSTRUCTIONS NAME OF EACH P ART PREPARA TION BEFORE USE USING THE VACUUM CLEANER USING THE A TTACHMENTS EMPTYING THE DUST COMP ARTMENT CLEANING THE FILTERS CLEARING BLOCKAGES IN THE SUCTION HOSE AND CLEANING THE AGITA TOR ASSEMBLY REPLACEMENT INSTRUCTIONS TROUBLESHOOTING LIMITED WARRANTY Cont[...]

IMPORT ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - T o reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use[...]

Note to user concerning attachment plug: 2 16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly . 19. Do not pick up items such as pieces of waste paper or cloth which look as though they may cause the hose to become blocked. 20. Do not[...]

Set the O N/OFF switch to " ON " to light the headlight. 3 NAMES OF EACH P ART W ARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Cleaning Utensil Headlight Handle Suction Hose A Dust Compartment Carrying Handle Duster Kno b ON/OFF Switch Release Button A Release Button B Release Button C Suction Hose[...]

Caution : Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle PREP ARA TIONS BEFORE USE Attaching th e suction hose A & attachments 4 1 2 Set the vacuum cleaner to the upright position. lnsert the handle as shown in the illustration. Handle Wa nd Crevice T ool Upholstery T ool & Dusting Br[...]

RELEASING THE POWER CORD Secure the power cord plug on the power cord. WARN ING: T o re duce the risk of e lectric shock, this appliance ha s a polarized plu g (o ne b lade is w ider than the other). This plug will fit in a po larized outlet only one way . If the plug does not fit f ully in th e outlet, reverse the plug. If it still does not fit, c[...]

ON/OFF Switch 6 USING THE V ACUUM CLEANER ON/OFF SWITCH Start or st op va cuum cleaner by pushing on the swi tch. ADJUSTING THE HANDLE Upright po sition The handle is normally locked in this The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel. Place your foot on handle release lever as shown and pull ba[...]

USING THE V ACUUM CLEANER EDGE CLEANING This vacuum c leaner is equipped with an " edge cleaning" function f or c leaning carpet edges near baseboards and stationary furniture. 7 1 2 RUG/FLOOR (T OOLS)SELECT OR The RUG/FLOOR(TOOLS)selector should only be adjusted while the vacuum cleaner is turned on and in the upright position. When clea[...]

1 2 3 USING THE A TT ACHMENTS Caution: When using one of the attachments during cleaning, set the vacuum cleaner to the upright position. Press the release button C to disconnect the handle from the vacuum cleaner . Remove the attachments from the vacuum cleaner. Caution: When removing the attachments, pull them in the directions shown in the illus[...]

1 3 2 4 1 2 1 3 2 4 1 2 Trapdoor Release Lever Duster Handle Turn the duster handle several times in the direction shown to empty the dust compartment. EMPTYING THE DUST COMP ARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning. Empty the dust compartme[...]

Remove the dust compartment.(refer to page 9) Clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter Dust Compartment Ribs Main Filter 1 1 CLEANING THE FIL TERS 2 Set the dust compartment to the parallel position.Open the trapdoor,then push the release button E and pull out the main filter. 3 Clean the main f[...]

Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect Cleaning the agitator assembly 1 2 3 CLEARING BLOCKAGES AND CLEANING THE A GIT A T OR ASSEMBL Y the power cord from the wa ll outlet before clearing any blockages in the suction hose and cleaning th e agitator assembly . Cleaning blockages Remove the bottom pl[...]

REPLACING THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below . 1 Set the vacuum cleaner to the parallel position. 2 Loosen the screws to remove the lens. 3 When removing the headlight lamp, be[...]

Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the O N/OFF swit ch to the"OFF" position a nd dis connect the po wer cord fro m the wall outlet before replacing an y of the parts be low . REPLACING THE FLA T BEL T Remove the bottom plate. (refer to page 14) Lift out the ag[...]

14 1 1 REPLACEMENT INSTRUCTIONS REMOVING THE BOTT OM PLA TE Set the vacuum cleaner to the parallel position and turn it ove r . REA TT ACHING THE BOTT OM PLA TE Insert the projection on the bottom plate into the groove on the nozzle housing and set the bottom plate in place. 4 Turn the vacuum over and place in the upright 2 2 Using a Ph i lips scre[...]

Caution: Be sure that seal on the HEPAfilter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down. 3 Insert a new HEPAfilter with the seal to the inside of the vacuum cleaner. Reattach the filter cover. Caution: Always replace the old filter with a [...]

9BF-D-P11 1-00721 0304- If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord f[...]

Zip Code ONE (1) YEAR LIMITED WARRANTY FANTOM warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use [...]