Fisher & Paykel CG705 инструкция обслуживания

1 Gas cooktops Installation instructions and User guide GB IE CG705 models[...]

[...]

1 Contents Safety and warnings 2 Installation instructions 6 Introduction 22 Using y our cooktop 23 Care and cleaning 26 T roubleshooting 30 W arranty and ser vice 31 Impor tant! SA VE THESE INSTRUCTIONS The models shown in this manual may not be available in all markets and ar e subject to change at any time. F or current details about model and s[...]

2 Impor tant safety precautions Installation Read these instructions carefully before installing or using this product. Please make this information av ailable to the person responsible for installing the produc t as it could reduce y our installation costs. This appliance must be installed in acc ordance with these installation instructions, local[...]

3 Particular attention shall be given to the relevant requirements regarding ventilation. This product should not be sealed into the bench with silicone or glue. Doing so will make future servicing difficult. Fisher & Payk el will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in [...]

4 Safety and warnings W ARNING! Hot Sur face Hazar d This appliance bec omes hot during use. Do not touch the cooktop c omponents, burners, triv ets/pan suppor ts or the base when hot. Before cleaning , turn the burners o and make sure the whole cookt op is cool. F ailure to follow this advice ma y result in serious injur y . W ARNING! Explosion[...]

5 Impor tant safety precautions Operation Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the appliance without danger to themselv es or their surroundings. If the power supply c able is damaged,[...]

6 Installation instructions Cooktop and cut out dimensions A B C D Electrical connection is made at the middle rear Gas connection is made at the right rear G F E Cooktop and cutout dimensions (mm) CG705 A overall width of cookt op 680 B overall depth of cookt op 500 C height of chassis (below top of bench) 35 D width of chassis 550 E depth of chas[...]

7 Installation instructions Clearances A B C D E Clearances (mm) CG705 A minimum clearance from rear edge of cut out to: nearest combustible surface 60 B minimum clearance from cooktop t o: rangehood 650 C minimum clearance from side edges of cutout to: nearest combustible surface 200 D minimum clearance below top of benchtop t o: combustible surfa[...]

8 Installation instructions The appliance may be installed in a suitable r oom in accordanc e with the current laws in f orce. The appliance is designed and appr oved f or domestic use only and should not be installed in a commercial, semi-commercial or c ommunal environment. Installing the appliance in any of the above en vironments will void the [...]

9 Installation instructions 650 mm 450 mm V entilation requirements (all countries e xc ept UK) Pro viding adequate ventila tion The installer must ref er to the current local regulations . The room acc ommodating the gas cooktop must hav e adequate natural draught to allow combustion of the gas . The flow of air must come dir ectly from one or mor[...]

10 V entilation requirements (United Kingdom only) The appliance should be installed in a room or spac e with an air supply in accordanc e with BS 5440:2 2000. F or rooms with a volume of less than 5 m 3 , permanent ventilation through a fr ee area of at least 100 cm 2 will be required . F or rooms with a volume between 5 m 3 and 10 m 3 , permanent[...]

11 Installation instructions Applying the seals 1 T urn the cooktop upside down and place it on a soft sur face. 2 Spread the longer seal “ A ” around the left, rear and right sides (Fig. 3a). 3 Using a sharp cutter or a pair of scissors, cut the ex cess seal “C” and put aside (Fig. 3b). 4 Spread the seal “B” around the left, front and [...]

12 Installation instructions F astening the cooktop to the bench 1 With the cookt op turned upside down, mount the supplied front and rear clamps (F and R) and screws (S) onto the cookt op, as shown (without tightening the screws). 2 Place the cooktop into the cut out, then tighten the screws t o clamp the cooktop securely to the bench. 3 Using a s[...]

13 Installation instructions Gas installation requirements This appliance is adjusted at the factory for use on Natural gas. T o use it on LPG, it will first have to be conv erted. If the LPG conversion kit is not supplied with the appliance, contact your near est Authorised Service Centre. Installation and service regulations (United Kingdom only)[...]

14 Connecting the cooktop to the gas supply The gas connection fitting (Fig . 5) is made up of : the floating nut the elbow the washer . If using a flexible hose, make sure it does not come into c ontact with moving par ts. T o maintain the minimum 30 mm clearance requirement below the base of the cooktop , the rear of the chassis is recessed to pr[...]

15 Installation instructions When connecting the cooktop to the gas supply with rigid pipes or a fle xible hose (which must comply with BS 669 in the UK), make sure that: you use rigid pipes or a flexible hose compliant with applicable local r egulations. The flexible hose shall be of the correct construction for the type of gas being used and of t[...]

16 Installation instructions Leak-t esting and flame -testing the cookt op 1 After connecting the gas supply , check the piping and connec tions for leaks as r equired by local regulations. The presence of bubbles indicat es a leak, tighten or replace connections as appropriate , then re- check for leaks . Impor tant! Do not use any naked flame to [...]

17 Installation instructions T able for the choice of injectors Cat: II 2H3+ Gas type: G20 Auxiliary (A) 1,00 0,30 72 (X) Semi-rapid (SR) 1,75 0,45 97 (Z) Rapid (R) 3,00 0,75 1 15 (Y) T riple ring (TR) 3,50 1,50 135 (T) BURNERS NOMINAL POWER (H S - kW) REDUCED POWER (H S - kW) Ø INJECTOR (1/100 mm) GAS PRESSURE (mbar) 20 Gas type: G30/G31 Auxiliar[...]

18 Installation instructions Con ver ting the cooktop t o a different gas type Impor tant! Only a suitably qualified and registered person may conv er t the cooktop to a different gas type. T o convert from one gas type to another , you need to replace the injectors, and then adjust the minimum gas rate setting. Replacing the injectors 1 Remove the[...]

19 Installation instructions Electrical connection Impor tant! This appliance must be earthed. Installation must be carried out acc ording to the manufacturer ’ s instructions. Incorrect installation may cause harm and damage to people, animals or property , for which the manufacturer accepts no responsibility . If the installation requires alter[...]

20 Installation instructions F or the United Kingdom and the Republic of Ireland only: The appliance must be connected to a 220-240V~50 Hz supply by means of a suitably earthed three-pin socket and should be protected by a 3A fuse in the plug. If the appliance is supplied without a plug, fit a rewir eable 13A three -pin plug fitted with a 3A fuse. [...]

21 Installation instructions Final checklist TO BE C OMPLETED BY THE INST ALLER Have y ou installed the clamps? Have y ou clamped the cooktop to the bench secur ely? Have you used the supplied washers? Have y ou leak-tested all c onnections? Is the cooktop set for the c orrect gas type and pressure? Are the injector sizes correct for the gas type? [...]

22 Introduction About your new cookt op Thank you f or buying a F isher & Pa ykel gas cooktop. Once it is installed and ready t o use, you will want to know everything about it to make sure you get excellent r esults right from the star t. This guide introduces y ou to all its special featur es. We r e commend y ou read the whole guide before u[...]

23 Gas burners The k nob (F ig. 13) controls the flow of gas through the saf et y valve. Using y our cooktop Fig .13 CG705 Burner knob Never cook or leav e the knob between maximum and O (off ). Y ou can choose to cook at any heat between minimum and maximum OFF (closed valve) Minimum Maximum Using the burners 1 Choose the control knob for the burn[...]

24 Using y our cooktop If the flame is irregular If the flame is yellow or irregular , check that the burner par ts, including the burner cap , are: clean and dry positioned correctly as shown in the ‘Car e and cleaning’ section. See also ‘ T roubleshooting ’ . Fig .15 Cleaning the ignitor and probe If a burner does not light Check that: th[...]

25 Using y our cooktop Burners Minimum Maximum Auxiliary 12 cm 14 cm Semi-rapid 16 cm right front: 22 cm left rear: 24 cm Rapid 24 cm 26 cm T riple -ring wok 26 cm 28 cm Maximum diameter for woks 36 cm Matching cookwar e to burner Use flat-bottomed pans, and make sur e they match the size of the burner , as shown in the following table . A small po[...]

26 Car e and cleaning Impor tant! Before any cleaning or maintenance , make sure that: all the burners are turned off the cooktop is disconnected from the po wer supply all parts of the cooktop are cool enough to safely t ouch. General advice Clean the cooktop after every use – do not allow stains to become burnt on. See the cleaning chart follow[...]

27 Car e and cleaning Cleaning chart What? Soiling examples How? I mportant! Stainless steel base fingerprints food stains hard water spots Soak stubborn stains under a hot soapy cloth, rinse and dry thoroughly . Hard water spots can be removed with household white vinegar . Use non-abrasive stainless steel cleaners. Regular use of a stainless stee[...]

28 Car e and cleaning Replacing the auxiliary, semi-r apid, and rapid burners Ensure that the burner assembly is: unable to rotate stable and level correctly aligned. Cap Fig . 19 Correct line-up of auxiliar y , rapid and semi-rapid burner parts Ignitor Flame spreader Fig . 20 Replacing the auxiliar y , rapid and semi-rapid burner c ap Flame failur[...]

29 Car e and cleaning Fig . 22 Correct positioning of cap and ring - triple- ring wok burner Cap Ring Fig . 23 Incorrect and correct positioning of cap and ring - triple-ring wok burner Ignitor Fig . 21 Fitting the burner spreader to the housing. Probe Replacing the triple -ring wok burner Ensure that the burner assembly is: unable to rotate stable[...]

30 T roubleshooting Problem Possible solutions A burner does not light Check the cooktop is plugged in and the electricity is switched on. Check the gas supply valve is turned on and the supply to the house is working. Y ou should hear the gas when you turn a burner on. If you use bottled gas, check the gas bottle is not empty . The ignitors may be[...]

31 W arranty and ser vice Before y ou call for ser vice or assistance ... Check the things you can do yourself . Refer to the installation instructions and your user guide and check that: 1 your product is correctly installed 2 you are familiar with its normal operation. If after check ing these points you still need assistance , please refer to th[...]

[...]

[...]

34 Copyright © F isher & Paykel 2008. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at an y time. Y ou should therefore check with your Dealer to ensure this booklet cor[...]