Fisher-Price 79619 инструкция обслуживания

w w w . f i s h e r - p r i c e . c o m Bouncer Cover’n Play ™ Model Number: 79619 Please keep this instruction sheet for future reference , as it contains important information. Adult assembly is required . T ool r equired for assembly: Phillips Screwdriv er (not included). Requires one “D” (LR20) alkaline battery (not included).[...]

2 W arning T o prevent serious injury and/or falls: • Ne v er use on any ele v ated surf ace , since child’ s mov ement ma y cause bouncer to slide or tip ov er . • Ne v er use as a carrier or lift while child is seated. • Alwa ys use the restraint system. • Ne v er leav e child unattended. • Ne v er use as a car seat. • Ne v er use w[...]

Parts 3 #8 x 3 / 4 " Screw - 2 3 T oys To y B a r Pad Footrest Seat Back Tu b e Retainer Retainer Right Base Wire Left Base Wire Base T ube Shown Actual Size[...]

• Locate the soothing unit on the f ootrest. • Insert a coin into the batter y c ompar tment door and pry the batter y compartment door off. • Insert one “D” (LR20) alkaline batter y , as indicated inside the battery compartment. Be sure to place the battery on top of the ribbon. • Replace the battery compar tment door and be sure it sn[...]

• Place the base tube on a flat surface as shown. • Position the left and right base wires as sho wn. Note the location of the colored tabs on the left and right base wires. • F it the left base wire into the base tube. • F it the right base wire into the base tube. Assembly Base T ube Left Base Wire Colored T abs Right Base Wire 1 5 This p[...]

• Position the f ootrest so that the soothing unit is upright. • While flexing the base wires towar d each other , hook the footrest onto the ends of the base wires. • Push the f ootrest down completely to the tabs on the base wires. • Make sure the colored tabs on the left and right base wires are visible through the base tube holes (see i[...]

• Position the seat back tube abo ve the base assembly . • F it the seat back tube completely onto the base wires. Assembly 3 7 Seat Back T ube Base Wire Base Wire[...]

• F it a retainer to the outside of the seat back tube, as shown. Mak e sure the socket in the retainer is upright. • Insert a screw through the hole in the seat back tube, base wire and into the inside of the retainer . • Tighten the screw with a Phillips screwdriv er . Do not over-tighten. • Repeat this procedure to assemble the other r e[...]

• Position the pad abo ve the frame with the blanket toward the soothing unit. • F it the upper pocket on the back of the pad onto the seat back tube  . • Lift the footrest. Fit the low er pocket on the back of the pad onto the footrest  . Low er the footrest. • Attach the pad fastener to the fast ener on the soothing unit  . Assem[...]

• F it the toy bar plugs into each retainer socket. • Unfasten a strap on the to y bar . • Wrap the str ap around a toy ring and re-fasten the str ap. • Repeat this procedure to attach the other tw o toys to the toy bar . • The toy bar is r emovable. Simply pull to remove. Assembly 6 10 To y s Plugs To y B a r Strap Retainer Socket Retain[...]

11 Set-Up & Use T o prevent serious injury and/or falls: • Ne v er use on any ele vated surf ace, since child’ s mov ement ma y cause bouncer to slide or tip ov er . • Ne v er use as a carrier or lift while child is seated. • Alwa ys use the restraint system. • Ne v er leav e child unattended. • Ne v er use with a child able to sit [...]

Loosen T o tighten the restr aint: • F eed the anchored end of the belt up through the buckle to form a loop  . • Pull the free end of the belt  . • Repeat this procedure to tighten the other belt. T o loosen the restraint: • F eed the free end of the belt up through the buckle to form a loop  . Enlarge the loop by pulling on the e[...]

4 13 Set-up & Use • Pull the blanket down complet ely . • F old the blanket under the footrest wire. • T uck the blank et into the pocket on the underside of the pad. Storing the Blanket • F old blanket up on baby ’ s lap. Blanket[...]

The pad is machine washable. Wash it separat ely in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remov e promptly . The frame , toy bar and toys ma y be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse the soothing unit. Care 14[...]

FCC Note (United States Only) Note: This equipment has been tested and f ound to comply with the limits for a Class B digital device , pursuant to P ar t 15 of the FCC Rules. These limits are designed to provide reasonable prot ection against harmful interference in a residential installation. This equipment generates , uses and can radiate radio f[...]

Fisher-P rice, Inc., a subsidiar y of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2001 Mattel, Inc. All Rights Reser ved. ® and ™ designate U.S. trademarks of Mattel, Inc. Printed in China 79619pr-0920 Questions? W e ’ d like to hear from you! Call F isher-Price ® C onsumer Relations, toll-free at 1-800-432-KIDS, 8 AM – 6 PM EST Monday thr[...]