Furman Sound PST-10D инструкция обслуживания

1 The PST -10D Owners Manual[...]

2 Introduction Thank you for purchasing the Furman Power Station-10D Power Conditioner . For over 30 years, Furman has pioneered the development of AC power products for the most demanding audio, video, and broadcast professionals. Furman’s Series Mode Protection Plus (SMP+), Linear Filtering T echnology , and Digital-HD T elevision Ready circuit[...]

3 enclosure. Do not remove the covers. There are no user serviceable parts inside. Refer servicing to qualified personnel only . Important Safety Instructions 1. Please read and observe all safety and operating instructions before installing your Power Station-10D (PST-10D). Retain these instructions for future reference. 2. Y our PST -10D should [...]

4 7 . Y o ur P ST - 1 0D s ho ul d be s er vi ce d by q ua li fie d se rv ic e pe rs on ne l wh en : • The power supply cord or the plug has been frayed, kinked, or cut. • Objects have fallen or liquid has spilled into the unit. • The unit has been exposed to rain or other moisture. • The unit does not appear to operate normally , exhibits[...]

5 contaminating an adjacent unit. For example, a television plugged into the digital – video filtered outlets will not affect an audio receiver- controller connected to one of the PST -10D’s standard or delayed outlets. Delayed AC Outlets – T rigger Switch and 12VDC inlet: The PST-10D features (3) delayed AC outlets. T oday’s Home Theater [...]

6 T elco – Satellite – Cable Transient V oltage Surge Suppressors: The PST -10D features transient voltage surge suppression for both standard telephone lines, as well as cable and satellite lines utilizing standard coaxial connectors. As these surge suppressors are in- line , they will require an additional cable to connect from their output t[...]

7 and out going cable from the PST -10D. Connect the incoming connector to the component that formerly received the out going connector , thus by-passing the in-line protection. If the signal is present (but not when used with the PST -10D’s) then the protection circuit is damaged (assuming it worked properly before the storm or catastrophic even[...]

8 voltage in excess of 137V AC is sensed, either on initial power-up or during normal operation, the PST -10D will shut off power and this indicator will light. NOTE: If the mains power is above the high cutoff voltage and has caused the unit to remove power from its outlets, it can not restore power without the operator manually turning the unit o[...]

9 distance from the two mounting hole drilled into your wall, rack or cabinet surface. Once the screw is fastened flush with the surface, back it out approximately ½” . The screw head should push through the crossed cutout on the bottom surface of the Power Station. Next, simply allow the Power Station to move down and seat into the end of its [...]

10 Return shipping charges back to purchaser will be paid by Furman. CONNECTED EQUIPMENT W ARRANTY : Furman Sound’s Connected Equipment Warranty covers equipment that is damaged by transient voltage (an “Occurrence”) while properly connected through the Furman PST -10D to a properly wired AC power line with a protective ground in an indoor lo[...]

1 1 prong adapters, or extension cords. Any such installation voids this warranty . The Furman warranty only protects against damage to properly connected equipment where Furman has determined, at its sole discretion, that the damage resulted from an Occurrence and does not protect against acts of God (other than lightning) such as flood, earthqua[...]

12 ST A TEMENTS DO NOT CONSTITUTE WARRANTIES, shall not be relied upon by purchaser , and are not a part of the contract for sale or this limited warranty . This Limited Warranty states the entire obligation of Furman with respect to the product. If any part of this Limited Warranty is determined to be void or illegal, the remainder shall remain in[...]