Garmin 605 инструкция обслуживания

EDGE ® 605/705 MB GPS-ENABLED BIKE COMPUTER quick reference guide[...]

W ARNING : This product contains a lithium-ion battery . See the Important Safety and Pr oduct Information guide in the product box for important battery safety information. Buttons ➊ ➋ ➏ ➎ ➌ ➍ ➐ ➊ power Press and hold to turn the Edge on/off. Press to turn the backlight on/off. ➋ mode Press to return to the previous page. Press a[...]

➍ thumb stick/enter Move the thumb stick to scroll through menus, options, and data elds. Press in the thumb stick to select options and to acknowledge messages. ➎ start/stop Press to start/stop the timer . ➏ menu Press to open the menu page. Press and hold to lock/unlock the Edge buttons. ➐ in/out Press to zoom in/out on the map page an[...]

Step 1: Charge the Battery Y ou can charge the Edge using the AC charger or the USB cable and your computer .  NOTE: T o prevent corrosion, thoroughly dry the mini-USB port, weather cap, and surrounding area before charging or connecting to a personal computer . T o charge the Edge: 1. On the back of the Edge, pull up the weather cap from the mi[...]

be used under the mount for a better viewing angle. T o install the Edge on your bike stem: 1. Place the wedge on the bike stem, and then place the bike mount on the wedge. Make sure the release lever is on the left. Wedge Bike mount Release lever For horizontal bars: Separate and remove the top part of the mount, turn it 90 degrees, and replace it[...]

4. Slide the Edge to the left until it snaps into place. T o release the Edge: Press down on the release lever , and slide the Edge to the right. Step 3: T urn on Y our Edge Press and hold to turn on your Edge. Follow the on-screen conguration instructions. Step 4: Acquire Satellite Signals It may take 30–60 seconds to acquire signals. Go outd[...]

Heart Rate Monitor W ear the heart rate monitor directly on your skin, just below your breastplate. It should be snug enough to stay in place during your run. 1. Push one tab on the strap through the slot in the heart rate monitor . Press the tab down. 2. Wet both sensors on the back of the heart rate monitor to create a strong connection between y[...]

GSC 10 Both magnets must be aligned with their respective indication lines for the Edge to receive data. T o install the GSC 10: 1. Place the GSC 10 on the rear chain stay (on the side opposite the drive train). Loosely attach the GSC 10 using two cable ties. 2. Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie. The [...]

not enough room between the sensor arm and the spoke. The magnet must be aligned with the sensor arm indication line. 4. Loosen the screw on the sensor arm and move it to within 5 mm of the spoke magnet. Y ou can also tilt the GSC 10 closer to either magnet for improved alignment. 5. Press the Reset button on the GSC 10. The LED turns red, then gre[...]

6. When everything is aligned and working correctly , tighten the cable ties, sensor arm, and spoke magnet. Step 7: Set Y our Set Y our Proles The Edge uses information that you enter about yourself and your bike to calculate accurate ride data. T o set your user prole: Press menu > select Settings > Prole & Zones > User Pro?[...]

Step 9: Download Free Software 1. Go to www .garmin.com/edge . 2. Follow the on-screen instructions to download Garmin T raining Center ® or Garmin Connect ™ . Step 10: T ransfer History to Y our Computer 1. Plug the small end of the USB cable into the mini-USB port on the back of the Edge (under the weather cap). 2. Connect the larger end of th[...]

© 2007 Garmin Ltd. or its subsidiaries Garmin ® is a trademark of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. Garmin T raining Center ® , Edge ® , Garmin Connect ™ , GSC ™ 10, Dynastream ™ , ANT ™ , and ANT+Sport ™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used witho[...]