Genie 3627336241 инструкция обслуживания

For 7’ 6” Doors. Extension Kit is available for 8’ Doors Included Wall Console MUST be installed prior to Operation of this Garage Door Opener. Safe-T-Beam ® S afety R e ve rs e Sy stem MUST be Installed and the F orce Co ntro ls M UST be Pro pe rly set to cl ose d oo r. This Eq uipment meets or exceeds all F e de r a l , S ta te an d U L 3 [...]

2 For Help, call 1-800-35-GENIE or visit www.geniecompany.com * Model Number and Serial Number are located on Motor Cover inside the lens. See Power Head Assembly Exploded View on page 15 IT IS CRITICAL THAT ALL SAFETY WARNINGS MARKED CLEARLY IN BOTH THE MANUAL AND POSTER ARE READ, UNDERSTOOD AND FOLLOWED. t h e G e N i e C o m p a N y l i m i t e [...]

For Help, call 1-800-35-GENIE or visit www.geniecompany.com 3 oVeRView of poteNtial haZaRDS Overhead doors are large, heavy objects that move with the help of springs under high tension and electric motors. Since moving objects, springs un d er t en s io n , a n d e l ec t ri c mo t or s ca n c a us e in j ur i es , yo u r s a fe t y a n d t h e s [...]

4 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Figure 1 Note Door Type 6(&7,21$/'2257256,21635,1*6 6(&7,21$/ '225(;7(16,21635,1*6 21(3,(&('22575$&./(66 m e a S u R e G a R a G e D o o R h e i G h t A Measure door height (floor to top of door) using a tape measure. B T[...]

Door Center Line Figure 5 Check Power Head location 11’ Grounded outlet 10’ (7’-6” door) (8’ door) 5 For Help, call 1-800-35-GENIE or visit www.geniecompany.com C Check wall for a stud or a solid header at your mark: (If checking a finished wall, a stud finder may be helpful). • If location is above Header, a 2” x 6” board must be s[...]

6 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Figure 8 Recommended Tools Go to Assembly and Installation Poster for full Installation Instructions. R e C o m m e N D e D t o o l S A Tools ( Figure 8 ): B Additional tools to make installation easier: • Slotted and phillips screw-driver bits • Stud finder • Sheet-metal cutting s[...]

7 For Help, call 1-800-35-GENIE or visit www.geniecompany.com a D j u S t i N G l i m i t S w i t C h e S a N D f o R C e C o N t R o l S Adjustment 1: A Pre-set Force Controls to midpoint between Hi and LO ( Figure A-1 ). B Adjust the Close Limit Switch: ( Figure A-2 ). • Press Wall Console to close garage door. – If door does not close comple[...]

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com NOTE The door must contact the 2” x 4” board before the Carriage activates the Close Limit Switch. If not, readjust the Close Limit Switch. S e t t i N G C o N t a C t R e V e R S e f u N C t i o N Adjustment 2: NOTE Limit Switch and Force Adjustments must be completed before checkin[...]

9 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Learn Code Button Figure MA-2 Learn Code Button and Indicator Light A Install two 60 Watt light bulbs (not included) into Light Sockets ( Figure MA-4 ): • Rough service, 130 Volt bulbs are recommended. B Install Lens into slots in Motor Cover. C Install Genie Emergency Release Kit ( GE[...]

10 For Help, call 1-800-35-GENIE or visit www.geniecompany.com A Monthly: • Door springs and door hardware: – Oil door roller, bearings, and hinges using silicone lubricant or light oil. • Balance Door. – Close door. – Release Magnetic Carriage Assembly f r om Rail Assembly b y pulling down o n Emergency Release Knob. – Raise door manua[...]

11 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Opener System Self-Diagnostic Troubleshooting • SeeStatus Light onFigure MA-2,page 9) You See Problem What to Do Reference 1 BLINK, Motor Drive • Reset Opener—unplug (or disconnect power), wait 5 seconds, plug Pause Board back in (reapply power), and activa[...]

12 For Help, call 1-800-35-GENIE or visit www.geniecompany.com General Troubleshooting (Always Check the Status LED Light) Problem What To Do Opener does not run 1 . Check power source. from Remote Control A. If Opener is connected to an outlet : • Plug a working lamp into outlet used for Power Head. • If lamp glows, power source and outlet are[...]

13 For Help, call 1-800-35-GENIE or visit www.geniecompany.com General Troubleshooting (Always Check the Status LED Light)(Continued) Problem What To Do Remote Control has less • Relocate Remote Control inside car. than 25’ operating range • Ensure Remote Control is pointing toward garage door when pressing Control Button. • Replace Remote [...]

14 For Help, call 1-800-35-GENIE or visit www.geniecompany.com Item Part Name Q u an t i ty Item Part Name Required 1 Power Head Assembly (main carton) 1 2 1/4”-20 x 13/16” Hex Head Shoulder Bolt (blue bag) 2 (yellow shoulder bolt) 4 Rail Assembly, 3 piece (main carton) 1 4A First Rail Section (main carton) 1 4B Middle Rail Section (main carton[...]

15 For Help, call 1-800-35-GENIE or visit www.geniecompany.com h a R D w a R e e x p l o D e D V i e w NOTE Opener will not function unless Safe-T-Beam® System is installed and Force Controls are properly set.[...]

16 For Help, call 1-800-35-GENIE or visit www.geniecompany.com ® No C.O.D. shipments. Please include check or money order, made payable to The Genie Company. Do not send cash. Allow 3-4 weeks for delivery. 1-800-354-3643. Please have part number and credit card ready. Mail Order Form to: Genie Company, 22790 Lake Park Blvd, Alliance, Ohio 44601. W[...]