Genie M-4500 инструкция обслуживания

Owner’ s Manual contains installation, operating, maintenance, & warranty instructions. For residential use only . This product complies with the 325 regulations effective January 1,1993. Marantec America Corporation 675 Heathrow Drive Lincolnshire, IL 60069 U.S.A. 1-888-622-2489 • www .marantecamerica.com Digital Intelligence for the Garag[...]

© Copyright 2003 All Rights Reserved. 1. INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. ADV ANCED FEA TURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. IMPORT [...]

3 Congratulations on purchasing your Marantec ® Professional Series Garage Door Opener System, the most inno- vative opener available today . This stylishly designed digital opener with a wide range of accessories is engineered to provide the smoothest, quietest and safest operation to compliment any home. Advanced technology results in the opener[...]

4 Stepladder Pencil T ape Measure Drill and Drill Bits Adjustable Wrench Wire Cutters Ratchet and Sockets (1/2”, 7/16”) Phillips Screwdriver Flat-Tip Screwdriver 7/16” Wrench The instructions will refer to the tools shown below for proper installation, adjustment, and maintenance of the garage door opener . Additional tools may be required de[...]

5 5. GARAGE AND DOOR (cont’d) Sectional Door with Curved T rack One-Piece Door with Horizontal T rack One-Piece Door with Jamb Hardware without T rack One-Piece Door with Pivot Hardware without T rack Check the type of door construction you have. The information contained in the figures below will be referred to later in the manual for proper ins[...]

6 Items shown not actual size. Warranty Card GARAGE DOOR OPENER SAFETY LABELS AND LITERA TURE Straight Door Arm RAIL ASSEMBL Y (packed in separate carton) POWER HEADS The following items are included with your Garage Door Opener . All hardware components located in GDO carton. The accessories are packaged with their respective hardware in separate [...]

7 7. IMPORT ANT INST ALLA TION INSTRUCTIONS IMPOR T ANT INST ALLA TION INSTRUCTIONS TO REDUCE THE RISK OF SEVERE INJUR Y OR DEA TH: 1. READ AND FOLLOW ALL INST ALLA TION INSTRUCTIONS. 2. Check with the door manufacturer to determine if additional reinforcement is required to support the door prior to installation of the garage door opener . 3. Inst[...]

See Fig. 12 See Fig. 11 Header Door Width Vertical Center Line Horizontal Line for Header Bracket Height Horizontal Reinforcement Bracket Fig. 10 Identify a sound structural support on header wall above garage door for header bracket mounting. See Fig. 11. If appropriate header does not exist, replace or install a new support using a 2x4 or 2x6 boa[...]

9 ■ Mark pilot holes location on header through holes where lag screws will be inserted. IMPORT ANT : See Fig. 11 for which header bracket holes to use. ■ Drill 3/16" pilot holes into header , and install bracket with lag screws (5/16 x 1-5/8 ” ) provided. ■ T ighten lag screws firmly . NOTE: Follow the same procedure if header (shown [...]

Correctly seated pin. Incorrectly seated pin. NOTE: Rail comes fully preassembled with straight door arm already attached. ■ Unpack one-piece preassembled rail. ■ Leave straight door arm taped inside rail for safe and convenient installation — it will be untaped and used later . ■ Position door opener head with control panel facing front of[...]

11 ■ Support opener head slightly off the floor . ■ Lift the opposite end of the rail up to the header bracket. ■ Position rail end-stop within the openings in the header bracket. Insert header clevis pin ( 1/4 ” dia.) through rail end-stop and header bracket, then attach cotter ring to end of pin. (See Fig. 19A) ■ Once rail is attached t[...]

12 ■ Position opener head so that rail is lined up with center line of open door . ■ Line up hanger brackets (not provided) with ceiling joists or framing to locate where brackets are to be fastened. See Fig. 22. ■ Mark location for 5/16" lag screws (not provided), and drill two 3/16" pilot holes. ■ Fasten hanger brackets to joist[...]

13 ■ Make sure door is fully closed. ■ Remove tape from rail holding straight door arm (sectional door only) and allow door arm to hang freely . ■ Pull the manual release cord on the trolley to disconnect trolley from chain or belt connector . Slide trolley to posi- tion it about 4" away from the door . A. SECTIONAL DOORS: ■ Position c[...]

14 T o provide the maximum amount of protection, the photo eye must be mounted between 3"and 5" above the floor . See Figs. 28 and 29. MOUNTING PHOTO EYE DIRECTL Y TO WALL: ■ Locate installation position. See Fig. 28. ■ Mark and drill 1/16" pilot hole into wall. (If mounting to drywall instead of wood, drill 3/16" pilot hole[...]

15 ■ Locate position where top mounting screw will go. Mark location on wall. ■ Drill 1/16" pilot hole into wall. (If mounting to drywall, drill 3/16 ” pilot hole and use anchors provided). ■ Insert top screw into wall. DO NOT TIGHTEN FLUSH WITH WALL. Leave screw head out approximately 1/8" from wall. See Fig. 31 – 1 (Front). ?[...]

16 Uncoil the gray antenna wire and position per diagram. Fig. 34. IMPORT ANT NOTE: ■ Do not lengthen or shorten the antenna wire. ■ Make sure the antenna wire is directed away from system power cord and any other power sources. ■ Avoid fastening the antenna wire directly to any metal surfaces. If stapling to joists or drywall, make sure stap[...]

17 receiver module. (See section 10-16, p. 20). T o reduce the risk of electric shock, your opener is provided with an insulated power cord with a 3-prong grounding plug. The cord must be connected to a standard grounding outlet. If there is no outlet available at the location, you must have a qualified electrician install an approved ground- ed ou[...]

18 The control panel is located under the control panel cover . Open the control panel by slightly pulling on the cover cutout, then allowing the cover to drop open. The hinges enable the cover to remain in place while you set the adjustments. On control panel you will find 3 buttons labeled “ P ” , “ + ” , and “–” which allows you to[...]

Up Force 19 Open T ravel Limit Setting Adjustment Close T ravel Limit Setting Adjustment OPEN TRA VEL LIMIT (Fig. 39): LED #2 should be blinking. Y ou can now set the open travel limit. T o move the door to its fully opened position, press and hold the “ + ” button until the door is in position that you desire. Then release this button. If the [...]

20 Clear Path between Photo Eyes Photo Eye Receiver (Red Indicator Light on) Photo Eye T ransmitter (Green Indicator Light on) Infrared Beam Photo Eye Receiver (Red Indicator Light Off) Photo Eye T ransmitter (Green Indicator Light On) Obstruction Breaking Infrared Beam Object directly in Path between Photo Eyes 2x4 Board Laid Flat Rotation about V[...]

21 IMPOR T ANT SAFETY INSTRUCTIONS TO REDUCE THE RISK OF SEVERE INJUR Y OR DEA TH: 1. READ AND FOLLOW ALL INSTRUCTIONS CAREFULL Y. 2. Never let children operate or play with door controls. Keep the remote control away from children. 3. Always keep the moving door in sight and away from people and objects until it is completely closed. NO ONE SHOULD[...]

T ransmitter with Active Code New T ransmitter L R L R L R Light Blinks Light Blinks Light Off Light Illunimates Continuously Press First and hold Press Second and hold Keep Pressed Release when Light Illunimates Continuously Midi 2-Channel T ransmitter Mounting Plate Visor Clip Fully Assembled 22 TRANSMITTER MOUNTING: The transmitters can be conve[...]

Y our opener can be activated via any of the following, depending on which accessories your opener system has: ■ Remote Control T ransmitter ■ Wall Control Panel ■ Doorbell-T ype Pushbutton ■ Keyless Entry (optional accessory p.28) REMOTE CONTROL TRANSMITTER: ■ T o open or close garage door , press and hold button (Midi transmitter has an[...]

24 TO SHORTEN CHAIN RAIL LENGTH: ■ Loosen chain tension as much as possible. ■ Remove screws from sprocket holder and rail end-stop. ■ Slide chain and all rail parts out of rail from header end. See rail exploded view , Fig. 55 on p. 25, for disassembly details. ■ Measure and cut off excess rail from header end by 1 ” increment only . ■[...]

1 2 10 7 5 3 4 Header End Powerhead End 9 8 Item Part # Description 1. ——— Rail 2. 8030339 Sprocket holder assembly 3. 8030432 Roller holder with tension bolt assembly 4. 8008503 Rail end-stop 5. 8030234 Chain connector 6. ——— Chain with position tab Item Part # Description 7. 8030177 T rolley assembly (7 ’ door) 8030178 T rolley asse[...]

26 1 2a 3 6 5 7 2b 2 2a 1 2 12 11 13 14 15 14 2 11 2c 16 10 9 4 5 4 8 15. SYSTEM P ARTS (cont ’ d) M-4700 Power Head Assembly Fig. 56 Item Part # Description 1. 8030589 Lamp Lens 2. 8030329 Wire Harness Assembly 2a. 0047269 Lampsocket w/Wire Harness 2b. 8002875 T erminal Block 2c. 8009963 V aristor 3 ——— Chassis Assembly 4 8054389 Reference[...]

15. SYSTEM P ARTS (cont ‘ d) 27 13 6 7 2b 2 1 12 11 2 14 16 8 14 2 11 15 2c 3 2a 10 9 4 5 4 M-4500 Power Head Assembly Item Part # Description 1. 8030590 Lamp Lens 2. 8030328 Wire Harness Assembly 2a. 0047268 Lampsocket w/Wire Harness 2b. 8002875 T erminal Block 2c. 8009963 V aristor 3 ——— Chassis Assembly 4 8054389 Reference Switch 5 60379[...]

28 The following accessories are designed to provide added convenience, satisfaction and value to your door opener system. Accessories are available from your dealer . If you have difficulty locating available accessories, please contact us directly at the number listed on page 32 of this manual. 16. ACCESSORIES Fig. 58 WALL CONTROL P ANEL ■ Prov[...]

29 LIKEL Y CAUSE AND SOLUTION ■ Does opener have electric power? Plug a lamp into the electric outlet to see if lamp turns on. If not, check fuse box or circuit breaker (some outlets are controlled by wall switch). ■ Have you disengaged all locks on door? If not, do so. ■ Has snow or ice built up under door? Door may be frozen to ground. Remo[...]

LED DISPLA Y AFTER PRESSING “P” ■ Remove obstruction from path of door , or realign photo eyes. Refer to page 20. 6 ■ Photo eye became obstructed during downward door travel. ■ Door can be operated normally . Recheck adjustments if adjustment settings were not completed. Refer to page 19. 7 ■ Adjustments setting interrupted before compl[...]

T o ensure continued safe operation and extended life of your opener system, periodic checking for proper operation is necessary . Occasional maintenance and readjustment of your system may also be needed. 19. MAINTENANCE AND ADJUSTMENTS Good maintenance of your garage door is an imperative requirement. Not only will it prolong the life of the door[...]

32 PROFESSIONAL SERIES GARAGE DOOR OPENER SYSTEM PROFESSIONAL PRODUCT WARRANTY M-4700 : —Parts Lifetime Warranty* (Labor not included) M-4500 : —Parts (15) Y ear Warranty* (Labor not included) COVERAGE: Any defect in material and or workmanship from personal, normal household use in accordance with the Owner‘s Manual. WARRANTY OWNERSHIP: The [...]