Haier HW-09LM13 инструкция обслуживания

No.0010515220 HW-07LM13 HW -07LM03 HW -09LM13 HW -09LM03 HW -12LM13 HW -12LM03 WINDOW TYPE ROOM AIR CONDITIONER OPERA TION MANUAL Please read this operation manual before using the air conditioner . Please keep it attentively .[...]

2 Contents Contents ............................................................................... 2 Part Name .............................................................................. 3 Operation Guide ................................................................ 4-5 Maintenance ............................................................[...]

P ar ts Name 3 Machine body Operation panel Front panel Air inlet (indoor side) Air outlet (indoor side) Air inlet (outdoor side) Display panel Air filter (inside) Machine body Power plug MINI COOL MAX COOL LOW F AN HIGH F AN HIGH COOL LOW COOL WAIT THREE MINUTES BEFORE REST ARTING[...]

4 Oper a tion Guide When the mode selection switch is turned to " HIGH F AN " or "LOW F AN" , the air conditioner will only blow out air without cooling. If the mode selection switch is turned from cooling mode to fan mode, do not turn it back until at least 3 mi nutes have elapsed. <1> <2> <3> <4> <5&[...]

Oper a tion Guide In cooling mode, after you turn thermostat switch counter-clockwise, do not turn it back until at least 3 minutes have elapsed. Otherwise, the fuse may blow due to overload. Do not exceed the selection range. This switch controls the preset indoor temperature to make the air conditioner start or stop automatically , so as to reduc[...]

Maintenance Air filter cleaning (before cleaning, turn off the power) Air filter cleaning Cleaning of the air filter T ake out the air filter When dirt accumulates on air filter , air circulation will be blocked, which causes poor cooling. It is advisable to clean air filter every two weeks for longer operation. 1.Press the concave parts on both si[...]

Cautions Power cord: Be sure to use the exclusive power cord. Change installation place: If air-con need to be changed to another place please contact the dealer , who sold you the unit. (Refer to P12 for choosing these two modes.) Maintenance 7 Bottom plate hole Back hole Outlet pipe fitting Fig.1 Rubber lid Fig.2 Rubber lid Back hole outlet pipe [...]

After unit stops, don't restart it until 3 min. have elapsed. Don't be exposed to cold air for a long time. Proper temperature Avoid opening doors and windows unless necessary . Use curtain or blind Direct sunlight may reduce cooling effect, always use window curtain. Keep heat source away from air conditioner . Set temp . a little bit hi[...]

T r oubleshooting Doesn't work Is plug firmly inserted? Is there power failure? Readjust power supply . No cool air or poor cooling Is thermostat switch wrongly adjusted? Readjust the thermostat. Is there any direct sunlight in the room? Use curtain or blind. Are doors or windows left open? Shut doors and windows. Are there any obstacles block[...]

Go away! Baby has gone sleep, better to adjust suitable temp. Don't hang clothes in the vicinity of air inlet. This will decrease cooling effect and cause abnormal operation. T emperature should be set properly when there are infant, child, the aged or disabled in the room. Before operating mode selection switch, check that if the air inlet or[...]

The enclosed accessories of the conditioner are: 1. The air-conditioner is better installed in shadow or in a place with short period of sunshine. In case the air-conditioner is installed at the point exposed directly to the sunshine, it should be protected from the direct sunlight as possible in order to avoid the long time of direct sunlight othe[...]

Installa tion Guide 12 1. Make the wall hole or window hole (see Fig.1) . 2. Fix the prefabricated iron frame to stable position by expansible screws. 3.T ake out the conditioner and accessories from the package . 4. 5. If you need to lead the condensed water to indicated position, please purchase a piece of plastic pipe , set it on the outlet pipe[...]