Haier WQP12-EFM инструкция обслуживания

Domestic Dishwasher WQP12-EFM WQP12-EFMS Code: 0120505622 GB[...]

NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential for safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC of 19 February 1973 (Low Voltage) and subse- quent modifications; - 89/336/EEC of 3 M[...]

Close-up View (Interior) A B C D Upper Rack Rack Height Adjuster Top Spray Arm Lower Rack E F G H Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Technical characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220V-240V~ 50Hz 2100[...]

Salt Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended fo[...]

Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table ". The detergent dispenser is located on the inside panel of the door. Loading the detergent To open cover [...]

Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need[...]

Turning on the Appliance Starting a wash cycle - Make sure that the plug of the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section "Loading the Dishwasher"). - Pour in the detergent (see the section "Salt, Detergent and Rinse Aid"). [...]

- It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odours from form ing and food from caking onto the dishes, you can run the soak cycle. - Choose the right wash cycle: the choice depends on the type of dishware, cookware and utensils being washed and how dirty they are. Energy Sa[...]

Wash Cycle Table Cycle Cycle Selection Information Description of cycle Detergent Rinse Aid Heavy Duty Normal Wash EN 50242 Rinse Soak Very dirty dishes, pots and pans (not to be used with delicate items). For dishes that need to be rinsed and dried only. Pre-wash with hot water. Extended wash at 55 ° C. Rinse with cold water. Rinse with hot water[...]

Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is advisable to remove the larger food particles trapped in the filter after each wash cycle b[...]

fig.1 Installation Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall, and the sides along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or left to facilitate proper installation. Levelling the Appliance Onc[...]

Installation Diagram The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative[...]