Hans Grohe Metris 31102XX1 инструкция обслуживания

Metris 31102XX1 Metris 31103XX1 Installation Instructions / W arranty[...]

2 Installation Considerations This faucet requires a 1 1 0 V electr ical outlet which must be installed by a pr ofessional electrician in compliance with all applicable local codes. This faucet includes a transformer that must be used. Do not attemp t to hardwire t his f aucet. This faucet cannot be used with a continuous ow water heater . For b[...]

3 Installation Flush the hot and cold supplies thoroughly before install- ing this faucet. Place the faucet in the hole on the mounting surface (1). T ighten the mounting nut (2). Install the adapters and filters on the stops (3). Install the supply lines (4). Be careful not to twist the supply lines, or they may become loose from the faucet, causi[...]

4 T ur n the water on to the faucet (1). Peel the protective film from the sensor (2). W ait 15 seconds, the place a hand in front of the sensor (3). The water should turn on automatically . Model 31102 only : Pivot the temperature control lever for ward to make the water cooler (4). Model 31103 only: Set the temperature T ur n the water off at the[...]

5 Cleaning: Block the sensor for 5 seconds (1). This will turn the water off for approximately 90 seconds, so that the sink may be cleaned (2). Faucet Maintenance Reset the faucet: Remove the set screw with a 2.5 mm Allen wrench. Block the sensor for 2 seconds. W ait 10 seconds (1), then replace the set screw (2).[...]

6 W ait 15 seconds (3). Place a hand in front of the sensor (4). The water should turn on. Clean the filters and aerator If the flow of water is reduced, the aerator and/or the filters must be cleaned. T o clean the aerator: Block the sensor for 5 seconds to temporarily shut off the water (1). Unscrew and remove the vandal resistant aerator using t[...]

7 T o clean the filters: T ur n the water off at the stops. Disconnect the supply hoses from the adapters. Remove and clean the filters. Note: Remove and inspect the check valves yearly .[...]

8 Replacement Parts 1 aerator 95383000 2 solenoid valve 98854000 3 fixation set 97812000 4 connection hose 98809000 5 check valve 96456000 6 electronics 96905000 7 AC adapter 97690000 8 transformer 97689001 9 8 x 2 o-ring 98112000 Important note : the check valves should be removed and inspected yearly . 1 2 3 4 5 6 7 8 9[...]

9 Cleaning Recommendation for Hansgrohe Pr oducts Modern lavator y faucets, kitchen faucets, and showers consist of ver y different materials to comply with the needs of the market with regard to design and functionality . T o avoid damage and returns, it is necessar y to consider certain criteria when cleaning. Cleaning Materials for Faucets and S[...]

10 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY [...]

11 give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in cour t against us under the Magnuson- Moss W arranty Act. PRODUCT INSTRUCTIONS AND QUESTIONS Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing, al[...]

US - Installation Instructions • Part No. 90590123 • Revised 5/2009 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770 360-9880 • Fax 770 360 9887 www .hansgr ohe-USA.com[...]