HP (Hewlett-Packard) N8400 инструкция обслуживания

HP Scanjet N8400 series User Guide[...]

Copyright and licen se © 2007 Copyright Hewlett-Packard Development Company, L.P. Reproduction, adapta tion or translation without prior written permission is prohibited, except as allowed un der the copyright laws. The information contained herein is subject to change without notice. The only warranties for HP products and services are se t forth[...]

Contents 1 Scanner ove rview What you can do with the scanner................................ ................................... ..........................3 Scanner hardware................................................................................................ ............... .......4 Scanner front pan el buttons..........................[...]

Maintain the automatic document feed er (ADF)........................ ...............................................18 Clean the paper path........................ ............................................ ......................................1 8 Clean the ADF wi ndow............ ................................................................[...]

1 Scanner overview This user guide covers what you need to know about using the H P Scanjet N8 400 series scanner. • What you can do with the scan ner • Scanner hardware • Scanner software • Where to get a dditional in formation • Accessibility What you can do with the scanner The following ta ble summarizes the scanne r features. Many of[...]

Scanner hardware 1 Front panel 2 Automatic document feeder 3 Power button Scanner front pan el buttons Use the but tons on the scanner fr ont panel to st art a scan, select a destina tion for a sca n, and configure some scanner se ttings. 1 Power Save button 2 Quick start buttons 3 Copy buttons 4 Scan Document To buttons 5 Tools but ton 6 Cancel bu[...]

The quick start buttons a re labeled 1 , 2 , 3 , and 4 . You can u se these but tons to scan with specific HP Smart Docum ent Scan profiles, such as: • Scan a document to a sea rchable PDF • Send a scan directly to an e-mail program • Scan a document for edita ble text NOTE: Use the HP Scanner Tools U tility, available fro m the Tools ( ) but[...]

Tools butto n Use the Tools button to open the HP Scanner Tools Utility where you can assign profiles to quick start buttons, choose whic h profiles are selectable from the scanner front panel, and view informa tion about scanner settings, status, and maintenance. Cancel but ton Press the Cancel button to cancel a scan in progress, or to cancel a s[...]

The Main Window is d isplayed when you open t he HP Smart Document Scan software. Use this window to comp lete the following tasks: • Start a scan: Load t he original in the document feeder, select a profile, and then click Scan . The scan will be comple ted using the setti ngs associated with the sel ected profile. • Work with profiles: Create[...]

Use the Maintenance tab to view the scanner usage and maintenance history and to run a test scan pass. Where to get additional information Several sources of informa tion describe using the scanner and the scanning soft ware. Setup and Support Guide Use the printed Set up and Support Guide th at came with the scanner t o set up and connect the scan[...]

HP Scanner Tools Utility help The HP Scanner Too ls Utility help expl ains the scanner setti ngs, information about scanner status and main tenance, how to assig n functionality to quick start buttons, and how to choose the pr ofiles that you can sel ect from the scanner fron t panel. To open HP Scanner Tools Utility hel p, press the Tools bu tton [...]

2 Scan and Copy The followi ng topics describe how to scan or copy originals using the scanner and the scanner software. • Basic scanning steps • Basic copying steps • Load originals • Scan from the scann er front panel button s • Scan from HP Smart Do cument Scan Software • Scan from other software pro grams • Scan with one but ton p[...]

Load originals • Place an original on the scanner glass • Load paper into th e document feeder Place an original on the scanner glass Place items that do not meet the specificat ions for the automatic do cument feeder (ADF) directly onto the scanner glass. Minimum size: Any size Maximum size: 215.9 mm x 355.6 mm (8.5 inche s x 14 inches) Place [...]

NOTE: For information on how to enable lo ng-page support, see Long pages . To load paper int o the document fee d er, follow t hese steps: 1. Insert a multiple pa ge document with the printed first page of the document faci ng up and with the t op of the document into the feeder. 2. Adjust the paper guides to center the origin al. Make sure the pa[...]

Scan from other software programs You can scan an image or docume nt directly into a sof tware program if the program is ISIS or TWAIN compliant . Generally, the program is compliant if it has a menu option such as Acquire , Scan , Import New Object , or Inser t . If you a re unsure whether the program is compliant or what the option is, see the d [...]

3 Set up scan profiles An HP Smart Document Scan Software p rofile contains setting s for scanning, processing, and saving or sending scanned documents. You can set up profiles for use wi th the Scan Document To button on the scanner front panel. The profiles provide a fast, eff icient way to scan. You can config ure each profile to perfo rm specif[...]

3. In the Profile name box, type the name you want or accept the default name. NOTE: The first 16 characte rs of the profile name can be displayed on the scanner front p anel. It is a good idea to include the informati on that dist inguishes this profile at th e beginning of the profile name. TIP: You might wan t to set up the new pro file based on[...]

To choose the profiles th at are displayed on the scanner front panel, follow these steps: 1. To open the HP Scanner Too ls Utility, do one of the following: • Double-click the HP Scanner Tools Utility icon on th e computer desktop. • Press the Tools ( ) button on the scanner fro nt panel. • Click Start , point to Programs or All Programs , p[...]

4 Care and maintenance This section presents informat ion about how to care for and mai ntain the scanne r. • HP Scanner Tools Uti lity Maintenance t ab • Order maintenance an d scanning supplies • Clean the scanne r glass • Maintain the automat i c document feeder (AD F) • Remove the automat ic document feeder from the scanner Occasional[...]

3. Clean the glass by u sing a soft, lint-free cloth that has been sprayed with a mild glass cleaner. CAUTION: Use only glass cleane r to clean the scanner glass. Avoid cleaners that contai n abrasives, aceto ne, benzene, and carbon tet rachloride, all of which can damage the scanner glass. Avoid is op ropyl alcohol beca use it can leave streaks on[...]

5. Click the Clean button to fe ed the cloth through th e scanner. CAUTION: Wait two minutes for the components to dry before proceedi ng to the next step. 6. Place up to five pages of printed paper in the AD F. Scan and view the results. 7. If streaks still appe ar, repeat steps 3 through 6. The cleaning cl oth can be cycled through the ADF up to [...]

4. Locate the clear scan windo w inside the ADF and clean it with an HP paper-path cleaning cloth. 5. Locate the white strip on the inside of the access door and clean it. 6. Replace the ADF a ccess door: a . Position the door over the ADF opening. b . Press the door int o place until it both si des click shut. 7. Clean the clea r scanning strip on[...]

To clean the feed roller, follow t hese steps: 1. Press the Power switch to the off position, and th en disconnect the USB cable and power cable from th e scanner. 2. Open the ADF hatch. 3. Lift the green le ver to raise the feed roller to the vertical po sition. Maintain the automatic document feeder (ADF) 21[...]

4. Inspect the separa tion pad that i s located below t he feed roller for wear and da mage. 1 New separation pad 2 Worn separation pad 3 Damaged separation pad NOTE: The feed ro ller replac ement kit in cludes extra se paration pa ds. If the separation pad sho ws wear betwe en feed roller replacements, t hen replace the separation pad as described[...]

8. Close the ADF hatch, a nd then reco nnect th e USB cable an d power ca ble to the scanner. 9. Press the Power switch to the on position, an d then update th e scanner maintenance history: a . Press the Tools ( ) button on the scanner front panel to open on the HP Scanner Tools Utility. Click the Mainte nance tab. b .I n t h e Feeder Maintenance [...]

3. Raise the scan ner lid to the ope n position. CAUTION: Do not attempt to u ninstall the ADF in the closed position. The ADF must be uninstal led in the opened position. Keep fin gers away from th e ADF hinges. 4. Grasp the ADF by th e sides. 5. Lift the ADF upwards whi le slightly tilting it awa y from you unti l the hing e posts are pulled out [...]

5 Troubleshooting This section contai ns solutions for common problems with the scanner. • Scanner error messages • Scanner initializa tion or hardware proble ms • Scanner operation p roblems • Scanner buttons are not working correctly • Automatic docum ent feeder (ADF) prob lems • Contact HP Su pport For additional troubleshooting, see[...]

Scanner Error Message Reco very Pro cess Clean Out Open Replace the ADF access door by pos itioning the door ove r the ADF opening and pressing the door into place until both sides click. Duplex Error Follow these steps to resolve the e rror: 1. Close the program you are using to scan. 2. Press the Power switch to the off position. 3. Check the sca[...]

Scanner Error Message Recovery Process 04 Follow these steps to resolve the error: 1. Check the USB connection between the scanner and the computer. For more help, see Che ck the cables . 2. Verify that the scanner is correctly enumerated on the host. If not, try uninstalling and then reinstalling the software. For more information, see the HP Scan[...]

Scanner has stopped working co rrectly If the scanner stops scanning , follow these steps. After each step, start a scan to see if the scanner is working . If the problem persists, proceed with the next step. 1. A cable might be loose. Ensure that both the USB cable and powe r supply are properly connected. Use the cable th at was included with th [...]

Scanner l amp stay s on The scanner lamp should t ime out and turn off automat ically after a period of inactivity (about 15 minute s). This is the Power Save mode. If the scan ner lamp remai ns on after a lo ng period of inactivity, turn o ff the scanner, wait 30 seconds, and then turn the sc anner back on. Scanner does no t scan right away Make s[...]

Scanned images are not straigh t The item mig ht have shifted when you closed the lid. Straighten the origin al on the scanner glas s, and then sc an again. Verify that the docu ment feeder guides are cen tered on the scanner and set to an appropriate widt h for the original b eing scanned. Make sure the paper guides touch the edges of the origin a[...]

Scanner buttons are not working correctly • Buttons do not wo rk • An unexpected program opens w hen a button is p ressed • Wrong profile is used when a quick start but ton is pressed Buttons do not wo rk After each step, press a button to see if it is working correctly. I f the problem persists, proceed with the next step. 1. The buttons mig[...]

Automatic document f eeder (ADF) problems Use this sectio n to help resolve issu es that might occu r when scanning from the ADF. • Paper jamming, skewing, misfeeds, or multip le-page feeds • Paper does not feed from the ADF • The bottom of the scann ed image is cut off • The scanned images ha ve streaks or scratches • An item loaded i n [...]

The scanne d image s have st reaks or scratch es After each step, try anothe r scan to see if the streaks or scratches are st ill apparent. If so, then try the n ext step. For info rmation on clea ning the scan ner, see the Care and maintenance section. 1. Check that the o riginals are clea n and unwrinkled. 2. Clean the scann er glass. 3. Use a cl[...]

3. Lift the green l ever to raise the feed roll er to the vertical posit i on, and then gently remove the jammed page. 4. Lower the green l ever to return the feed roller to the workin g position, and t hen close the ADF hatch. Pre ss down firmly on both sides until you hear a click. 5. Put the inp ut tray on the ADF. Reload the unscanned pa ges in[...]

Clear a jam at the end of the pape r path 1. Remove any lo ose pages fro m the ADF inpu t tray. 2. Gently pull the jammed page out of t he ADF in th e opposite dire ction from which the page fed into the ADF. 3. If the jammed pa ge still cannot be removed, lift the l id to its fully open position , loosen the jammed page from the roller on the unde[...]

Remove a paper ja m within the ADF 1. Remove any loose pages from the ADF input tray. 2. Open the scanner lid. 3. Locate the ADF access door on the underside of the ADF. 4. Press the tabs on the d oor, and then pull th e door toward you until it detaches f rom the ADF. 5. Remove any paper insid e the ADF. 6. Replace the ADF access do or by position[...]

6 Advanced technical features Experienced document management pr ofessionals might be interested in the following scan features. These features are available from any d ocument TWAIN or ISIS application that allows you to modify the scan setti ngs in its user in terface. • Long pages • Color dropout • Misfeed (Multipick) Detection Long pages [...]

To disable the Misfeed (Multipick) Detection feature in an HP Smart Document Scan Software profile, follow these steps: 1. Open the HP Smart Document Scan Software. 2. Select a scan profile, and then click Edit . 3. On the Scan tab of the Profile Settings dialog box, click Advanced Settings . 4. On the More tab of the Properties dialog box, clea r [...]

Index A accessibility 9 ADF clean window 19 cut-off images 32 feeding, troubleshoot 32 jams 33 maintain 18 maintenance 18 skewed pages 32 streaks, troubleshoot 33 applications scan from 13 B black scans, troubleshoot 29 buttons troubleshoot 31 C clean ADF window 19 feed roller 20 paper path 18 scanner glass 17 cleaning cloth 18 Color dropout 37 cop[...]

import and export 16 select 10 set up 14 programs scan from 13 Q quick start buttons assign profiles 15 troubleshoot 31 R replace feed roller 23 reset the scanner 27 S scan files too large 30 from HP Smart Document Scan Software 12 from other programs 13 select profiles 10 with one button press 13 scan profiles troubleshoot 31 scanner lamp, trouble[...]