Hyundai IT DW12-BFM инструкция обслуживания

Code:0120505275 Domestic Dishwasher DW12-BFM DW12-BFM ME GB[...]

Safety Is Very Important Close-up View (Control Panel) - Do not lean or sit on the door when it is open as this could over turn the dishwasher. - If the appliance malfunctions, turn off water supply to the appli- ance and disconnect the plug from the wall socket. Then, con- sult the section entitled, "Troubleshooting." If you cannot solve[...]

Close-up View (Interior) Technical Characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz 1950W Total absorber power .2. GB E F G Washing Filter Bottom Sprayer Arm Detergent and Rinse Aid Dispenser A B C D Upper Rack Rack Height Adjustor Top Sprayer Arm[...]

Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimise and customise the level of salt consump- tion so that it remains at a minimum. To adjust salt consumption, proceed as follows: - Unscrew the cap from the salt container; - The[...]

Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel the door. Loading the detergent To open the "[...]

2 1 3 4 Loading the Dishwasher Lower Rack Upper Rack Load for 12 Standard Settings Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked [...]

Turning on the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher"). - Pour in the detergent (see the section entitled, "Salt, Detergent a[...]

- It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the soak cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. Energy Savi[...]

Wash Cycle Table .8. GB Cycle Button Cycle Selection Information Description of Cycle Deter- gent Rinse Aid Very dirty dishes, pots and pans. (Not to be used with delicate items) Pre-wash of dishes, pots and pans while waiting for the load to be completed after the subse- quent meal. Pre-wash with hot water. Extended wash at 53 . Rinse with cold wa[...]

Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle[...]

Installation Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to ensure correct installation. Levelling the Applian[...]

Installation Diagram The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative[...]