IBM ThinkCentre 9212 инструкция обслуживания

ThinkC e n tr e ™ Hard w are Rep l a c ement Gu i d e Ty p e s 92 1 2 92 1 3 [...]

[...]

ThinkC e n tr e ™ Hard w are Rep l ac ement Gu i d e Ty p e s 92 1 2 92 1 3 [...]

Second Edition (March 2005) © Copyright International Business Machines Corporation 2005. All rights reserved. US Government Users Restricted Rights – Use, duplication or disclosure r estricted by GSA ADP Schedule Contract with IBM Corp.[...]

Contents Overview . . . . . . . . . . . . . .v Safety information for replacing CRUs . . . . . .v Safety information for replacing FRUs . . . . . .v Additional information resour ces . . . . . . .v T ools requir ed . . . . . . . . . . . . .v i Handling static-sensitive devices . . . . . . .v i Chapter 1. Locations . . . . . . . . .1 Locating compon[...]

iv Hardwar e Replacement Guide[...]

Overview This guide is intended to be used by customers who are r eplacing Customer Replaceable Units (CRUs) as well as trained service personnel who are r eplacing Field Replaceable Units (FRUs). In this guide, CRUs and FRUs will often be referr ed to as parts. This guide does not include procedur es for all parts. It is expected that cables, swit[...]

To access this information, point your browser to http://www .ibm.com/pc/support/. T ools required To replace some parts in your computer , you might need a flat-blade or Phillips screwdriver . Additional tools might be needed for certain parts. Handling static-sensitive devices Static electricity , although harmless to you, can seriously damage co[...]

Chapter 1. Locations This chapter provides illustrations to help locate the various connectors, contr ols and components of the computer . To remove the cover , see “Removing the cover” on page 5. Locating components The following illustration will help you locate the various components in your computer . 1 Optical drive 2 Memory mo[...]

Locating connectors on the front of the computer This section shows the various external connectors on the computer to which you can attach external devices. 1 3 9 4 1 IEEE 1394 connector 4 Microphone connector 2 USB connector 5 Headphone connector 3 USB connector 2 Hardwar e Replacement Guide[...]

Locating connectors on the rear of the computer The following illustration shows the location of connectors on the rear of the computer . 1 Power supply diagnostic LEDs 11 USB connectors (2) 2 V oltage selection switch 12 Standard keyboard connector 3 Power connector 13 PCI Express x16 adapter connector (some mod[...]

Identifying parts on the system board The system board (sometimes called the planar or motherboard ) is the main cir cuit board in your computer . It provides basic computer functions and supports a variety of devices. The following illustration shows the locations of parts on the system board. 1 Speaker connector 12 PCI adapter connect[...]

Chapter 2. Replacing hardware Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/suppo[...]

To replace the cover , go to “Completing the parts replacement” on page 31. Removing and replacing the front bezel 1. Remove the computer cover . See “Removing the cover” on page 5. 2. To release the front bezel fr om the chassis, press the blue button at the top of the chassis and pull the bezel outward as shown. 3. To install the bezel, a[...]

3. Push the blue release lever 1 to the left and pull the blue handle 2 outward. Pivot the har d disk drive outward to the fully open position as shown. 4. Disconnect the power supply cables 1 and 2 connected to the system board. Chapter 2. Replacing hardwar e 7[...]

5. Remove the four screws at the rear of the chassis that secur e the power supply . 6. Press inward on the metal r etainer inside the chassis and remove the power supply from the computer . 7. Install the new power supply into the chassis so that the screw holes in the power supply align with those in the chassis. Note: Use only the screws pr ovid[...]

11 . Push the blue lever 1 and pivot the hard disk drive inward until it is latched into position. 12. Go to “Completing the parts replacement” on page 31. Chapter 2. Replacing hardwar e 9[...]

Replacing the system board assembly Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc[...]

7. Remove the screws 1 through 7 . 8. Slide the system board toward the fr ont of the computer to disengage it from the mounting tabs and lift it out. 9. Place the defective system board next to the new system board on a clean, flat surface. 10. Remove all memory modules from the defective system board, and install them in the same conn[...]

12. Install the new system board assembly into the computer chassis by aligning the four slots in the metal plate on the bottom of the system board with the tabs in the chassis. Important Make sure to corr ectly align the metal plate on the bottom of the system board with the tabs in the chassis. Otherwise, the system boar d might be damaged when y[...]

Replacing the microprocessor Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/suppor[...]

5. Pivot lever 1 securing the heat sink until it is fully in the up position. Remove the heat sink 2 from the system boar d by carefully lifting it up and off the system boar d. Note: If you are r eplacing a defective system board you must r einstall the same heat sink. Carefully place the heat sink on its side on a clean, flat surface [...]

7. Using the vacuum pen 1 , remove the micropr ocessor from the system boar d socket by lifting it straight up and out of the socket. Important Do not touch the gold contacts on the bottom of the micropr ocessor . If you must touch the micropr ocessor , touch only the sides. Notes: a. T ake notice of the orientation of the notches 1 on [...]

9. Loosen the protective cover 3 that protects the gold contacts on the micropr ocessor 2 but do not remove it. Use the vacuum pen 1 to pick up the micropr ocessor then completely remove the cover . * XXXXXXXXX* 10. Position the microprocessor so that the notches on the micr oprocessor ar e aligned with the tabs in the micropr oce[...]

11 . Using the vacuum pen 1 , lower the microprocessor straight down into the micropr ocessor socket. Note: Install the black protective cover that was r emoved from the new micropr ocessor onto the defective micropr ocessor after the installation is complete. 12. Pivot the retaining plate 3 to the closed position and pivot the locking [...]

13. Slide the heat sink 2 into position over the microprocessor . Lower the lever 1 to secure the heat sink. Note: If you are r eplacing a defective system board, use the heat sink that was removed earlier . 14. If you are replacing the system boar d, continue at step 12 on page 12. If you are r eplacing only the micropr ocessor , conti[...]

Replacing a memory module Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/support/.[...]

Replacing a PCI adapter Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/support/. 1[...]

5. Pivot the blue adapter latch to the closed position to secure the adapters. 6. Go to “Completing the parts replacement” on page 31. Chapter 2. Replacing hardwar e 21[...]

Replacing a hard disk drive Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to the W orld W ide We b at http:[...]

4. Slide the hard disk drive out of the hard drive bay by pulling the blue handle. 5. Remove the defective hard disk drive from the blue bracket by flexing the bracket. 6. To install the new hard disk drive into the blue bracket, flex the bracket and align the pins 1 through 4 on the bracket with the holes in the har d disk drive. Do no[...]

7. Insert the new hard disk drive into the hard drive bay with the cir cuit board side facing downward. 8. Connect the power and signal cables to the new hard disk drive. See “Identifying parts on the system board” on page 4. 9. Press the blue tab 1 to pivot the drive into the computer . Route the cables so that the hard disk drive bay ca[...]

Replacing an optical drive Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/support/[...]

5. Install the optical drive into the bay until it snaps into position. 6. Connect the signal and power cables to the drive. 7. Go to “Completing the parts replacement” on page 31. 26 Hardwar e Replacement Guide[...]

Replacing the diskette drive Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/suppor[...]

Replacing the keyboard Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/support. 1. [...]

Replacing the mouse Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/support/. 1. Re[...]

Replacing the internal speaker Attention: Do not open your computer or attempt any repair befor e reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer . To obtain copies of the Quick Reference or HMM , go to http://www .ibm.com/pc/supp[...]

Completing the parts replacement After replacing a failed part, you need to install any other r emoved parts, install the computer cover , and reconnect any cables, including telephone lines and power cords. Also, depending on the part that was r eplaced, you might need to confirm the updated information in the Setup Utility program. See ″ Starti[...]

4. Reconnect the external cables. Plug the power cord into the computer then into a properly gr ounded power receptacle. See “Locating connectors on the fr ont of the computer” on page 2 and “Locating connectors on the rear of the computer” on page 3. 5. If you are replacing the system boar d, you must update (flash) the BIOS, see “Updati[...]

[...]

 Part Number: 39J7726 Printed in USA (1P) P/N: 39J7726[...]