Jammin Pro 5480002 инструкция обслуживания

USER ' S MANU AL[...]

The symbol is used to indicate that some hazardous live terminals are involved within this apparatus , even under the normal operating conditions , which may be sufficient to constitute the risk of electric shock or death . The symbol is used in the service documentation to indicate that specific component shall be replaced only by the component sp[...]

· Power Supply The apparatus should be connected to the power supply only of the type as marked on the apparatus or described in the manual . Failure to do could result in damage to the product and possibly the user . Unplug this apparatus during lightning storms or when unused for long periods of time . · V entilation Do not block areas of venti[...]

T ABLE OF CONTENTS 1 . INTRODUCTION ................................................... 2 1 . 1 General mixing console functions ................................................................. 2 1 . 2 The user ’ s manual .............................................................................. 3 1 . 3 Before you get started ...............[...]

1 . INTRODUCTION Congratulations ! In purchasing the StudioMix 10 / StudioMix 12 series micing concole you have acquired a mixing console whose small size belies its versatility and audio performance . The microphone channels feature high - end ME Mic Preamps preamps in terms of sound quality and dynamics and boast the following features . that com[...]

1 . 2 The user ’ s manual The user ’ s manual is designed to give you both an overview of the controls , as well as detailed information on how to use them . 1 . 3 . 1 Shipment 1 . 3 Before you get started Y our mixing console was carefully packed in the factory to guarantee safe transport . Nevertheless , we recommend that you careful examine [...]

Please note that all unit must be properly grounded . For your own safety , you should never remove any ground connectors from electrical devices or power cables , or render them inoperative . Please sure that only qualified people install and operate the mixing console . During installation and operation , the user must have sufficient electrical [...]

The circuitry of the British EQs is based on the technology used in the bast - known top - of - the - line consoles and providing a warm sound without any unwanted side effects . The result are extremely musical equalizes which , unlike simple equalizers , cause no side effects such as phase shifting or bandwidth limitation , even with extreme gain[...]

The P AN control determines the position of channel signal within the stereo image . This control features a constant - power characteristic , which means the signal is always maintained at a constant level , irrespective of position in the stereo panorama . P AN The LEVEL control determines the level of the channel signal in the main mix LEVEL The[...]

The FX SEND connector outputs the signal you picked up from the individual using the FX controls . Y ou can connect this to the input of an external effects device order to process the FX bus master signal . Once an effects mix is created , the processed signal can then be routed from the effects devices outputs back into a stereo input FX SEND 7 2[...]

8 If the connected effects processor receives no input signal . the FX SEND control is probably too low . This also goes for the built - in effects processor . Adjust your external effects processor to 100 % wet ( effects signal only ), before the effects signal is added to the main mix along with “ dry ” channel signals . In this instance , th[...]

9 POWER Please do not connect microphones to the mixer ( or the stagebox / wallbox ) as long as the phantom power supply in switched on . Connect the micro - Phones before you switch on the power supply . IN addition , the monitor / P A loudspeakers should be muted before you activate the phantom power supply . After switching on , wait approx . on[...]