Kenmore 146.1613211 инструкция обслуживания

Use & Care Guide Manual de Uso y Cuidado English / Espafiol Models/Modelos: 146.16132110/146.16133110 I(enmore @ @ @ ??ril g _ prop_ I ° P/N 40200104 Sears Brands Management Corporation Hoffman Estates, IL 60179 U.S.A. www.kenmore.com www.sears.com[...]

If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. 1. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance. 2. An LP cylinder not c[...]

2 For Your Safety ... Grill Service Center... Product Record Information ... Installation Safety Precautions ... Safety Symbols ... Kenmore Grill Warranty... Use and Care. Parts List... Parts Diagram... Before Assembly ... Assembly... Troubleshooting... 2 2 2 2 3 •.. 4-10 ...11 • .12 ... 13-16 • 17-22 • 23-25 Repair Protection Agreements Co[...]

° NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. ° Never fill a cylinder beyond 80% full. • If the information in the two points above is not followed exactly, a fire causing death or serious injury may occur. • An overfilled or improperly stored cylinder is a hazard due to possible gas release from the sa[...]

LP Tank Exchange Connecting Regulator To The LP Tank • Many retailers that seii griiis offer you the option of replacing your empty LP tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their cylinders. Exchange your tank only for an OPD safety feature-equipped tank as desc[...]

Hold coupling nut and regulator as shown for proper connection to LP tank valve. Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP tank. 3.Compieteiy open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There [...]

For Safe Use of Your Grill and to Avoid Serious Injury. • Do not let children operate or play near grill. • Keep grill area clear and free from materials that burn. • Do not block holes in sides or back of grill. • Use grill only in well-ventilated space. NEVER use in enclosed space such as carport, garage, porch, covered patio, or under an[...]

Turn controls and gas source or tank OFF when not in use. CAUTION If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with The valve open, gas will contiune to flow out of the burner and could accidently ignite with risk of injury Searing Burner Match[...]

SPIDER ALERT! IMPORTANT: Always ensure that the venturi burner tubes are clean. A venturi burner tube has a narrow area in which spiders tend to build nests. If you notice that your grill is getting hard to light or that the flame isn't as strong as it should be, take the time to check and clean the venturi's. Spiders or small insects hav[...]

Indirect Cooking Poultry and large cuts of meat cook slowly to perfection on the grill by indirect heat. Place food over unlit burner(s); the heat from tit burners circulates gently throughout the grill, cooking meat or poultry without the touch of a direct flame. This method greatly reduces flare-ups when cooking extra fatty cuts because there is [...]

Key 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 Qty Part Number Sideburner Lid Rotate Rod, Sideburner Lid Sideburner Grid Sideburner Ignitor Wire, Sideburner Sideburner Base Right Side Shelf Fascia, Right Side Shelf Electronic Ignition Module Control Knob Impulse Control Line Gas Valve, Main Burne[...]

/ ___ .................................................................................. 12 _ 1613_.4200104[...]

READ AND FOLLOW THE INSTRUCTIONS BELOW TO CORRECTLY UNPACK GRILL PARTS FROM SHIPPING BOX. Step 1: Once you open the top of the shipping box, slice down its four edges with a box cutter. Take out the Hardware Pack, two grill side panels, back panel and bottom shelf. Next remove the door bracket, back rail and warming rack. Take the left and right do[...]

Step 2. With the aid of an assistant, turn grill head over on its side as shown in the first figure below, and remove the top styrofoam piece. Lay the styrofoam piece flat on the floor. With the aid of an assistant, lift the grill head out of the bottom styrofoam piece. Place the grill upright on the other styrofoam piece as shown in the second fig[...]

Step 3. Open grill lid, and take out the small boxes packed within the grill head. Remove all packing materials, and remove all parts from boxes as shown in the figures below. if!if: _ t / 16132-40200104 * 15[...]

CAREFULLY READ AND PERFORM ALL ASSEMBLY iNSTRUCTiONS ON THE FOLLOWING PAGES. Tools Required: • Adjustable wrench (not provided) • Screwdriver (not provided) • 7/16" Combination wrench (not provided) • The following hardware is provided in a blister pack for convenient use. M4XIO screw Qty: 20 pcs M5XIO screw Qty: 4 pcs M6X13 screw Qty:[...]

MBX15 screw M6 lock washer QW: i6 pcs M4XIO screw Qt¥:2 pcs 16132-4020010[...]

Cart [] To attach side panels, align side panel leg holes with leg holes on each side of bottom shelf. Left side panel has match holder attachment. [] Attach left and right side panels to sides of bottom shelf with (4) M6x13 screws, M6 lock washers and M6 flat washers (Dia 16). (A) [] Attach back panel to bottom shelf and two side panels with (6) M[...]

Front Doors [] Remove the (4) M4xlO screws pre-assembled to the door handle ends, and use them to attach handles to doors. [] Insert the lower door pin into the hole on the bottom shelf. Push down the upper door pin, align it beneath hole in door pin bracket, and release pin so that it inserts in hole. [] Repeat this for the other door. [] Note: If[...]

Grill Head to Cart This step requires two people to lift and position grill head onto cart. Remove the tie wraps securing regulator hose to underside of grill head. Pull hose and igniter wires out to side of grill head. [] Carefully lower the grill head onto the cart. Make sure the regulator hose and igniter wires are hanging outside the cart. Open[...]

Left Side Shelf [] Slide 4 hooks onto push bar in orientation shown below. (A). Hook ends must face away from grill in operation position. (D). Remove the (2) M5xl0 screws, M5 lock washers and M5 flat washers pre-assembled to the push bar ends, and use them to attach push bar to shelf. (A) [] Attach fascia to left side shelf with (2) M5xl0 screws, [...]

Right Side Shelf [] Remove sideburner grate from sideburner before assembling and attaching the right side shelf. [] Attach fascia to right side shelf with (2) M5xl0 screws, M5 lock washers and M5 flat washers. (A) [] Hang right side shelf onto the brackets on right side of firebox. [] Attach shelf to firebox as follows: - From inside to outside of[...]

Sideburner [] Loosen side burner in side shelf. (B). To loosen, unscrew and remove two front screws and washers holding sideburner in place. (A). Note: Do not loosen electrode screw. [] Remove knob and bezel from sideburner control valve. To remove, pull knob straight out from valve stem. Unscrew bezel from valve face and set the two screws aside. [...]

Heat Diffusers, Cooking Grate and Warming Rack [] Place heat diffusers over burners by inserting tabs into slots in front and back of firebox.The diffuser with the extended heat shield must be placed on the far right, with the shield facing to the right. (A) [] Place cooking grates onto grate rests. [] Insert warming rack into brackets at top of fi[...]

Grease Cup Clip, Grease Cup and LPtank Hang grease cup clip from bottom of firebox and place grease cup into grease cup clip. Feed the regulator and hose through the hole in the right side panel. [] LP tank is sold separately. Use only with an OPD (Overfill Protection Device) equipped LP tank. Fill and leak check before attaching to grill and regul[...]

EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Gas leaking from cracked/cut/burned hose Gas leaking from LP cylinder Gas leaking from LP cylinder valve Gas leaking between LF cylinder and regulator connection Fire coming through control panel Grease fire or continuous excessive flames ab[...]

Troubleshooting (continued) Burner(s) will not light using ignitor. (See Electronic Ignition Troubleshooting also) Burner(s) will not match light. ELECTRONIC IGNITION: • No spark, no ignition noise. • No spark, some ignition noise. • Sparks, but not at electrode or at full strength. • See Section I of Electronic Ignition System. • See Sec[...]

Troubleshooting - Electronic Ignition SECTION I No sparks appear at any electrodes when control knob turned to HI: no noise can be heard from spark module. • Battery not installed properly. • Dead battery. • Button assembly not installed properly. • Faulty spark module. • Check battery orientation. • Has battery been used previously? ?[...]

[...]

[...]

[...]

Your Home For troubleshooting, product manuals and expert advice: www.managemylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. Fo[...]