KitchenAid KHGH 7510/I инструкция обслуживания

KHGH 7510/I Instructions for use 5019_719_01000_GB 16-07-2007 10:23 Pagina 1[...]

5019_719_01000_GB 16-07-2007 10:23 Pagina 2[...]

Product description and symbols 4 Using the burners 4 Practical advice on using the hob 5 Positioning the pan supports and wok suppor t 5 Hood and cabinetry clearances (mm) 6 Injectors table 6 Safeguarding the environment 8 Installation 9 Gas connection 9 Electrical connection 10 Installation 10 Adaption to a different type of gas supply 11 Replaci[...]

1. Removable pan supports 2. 1kWh auxiliary burner 3. 1.65kWh semi- fast burner 4. 1.65kWh semi- fast burner 5. Professional wok burner 6. Auxiliary burner control knob 7. Semi-fast burner control button 8. Semi-fast burner control button 9. Professional wok burner control button Control Symbols Off Maximum flame Minimum flame Product description a[...]

Read the instructions to get the best out of your hob. - Use pans with a similar diameter to the burner (see the table on this page) - Use flat bottomed pans except with the wok support. - Do not use excessive water when cooking foods and use the lid. - Ensure that pans are fully supported by the pan supports and do not protude over the edges. Y ou[...]

If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob Note: If the distance “ A ” between the wall cupboards in the kitchen is between 600mm and 730mm, the height “B” must be at least 530mm. If the distance “ A ” between the wall cupboards is greater than the w[...]

T o get the most out of your hob, please read the instructions carefully and keep them for future consultation. • These instructions are only valid in the countries whose destination symbol is shown on the serial number plate on the hob. • The packing (plastic bags, expanded polyurethane, etc) pose a potential threat to children and should be d[...]

P acking The packing material is 100% recyclable and is labelled with the recycling symbol . Please dispose of all packing responsibly and carefully . Product This appliance is marked according to the European Directive 2002/96/EC, W aste Electrical and Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly , you will h[...]

T echnical information for the installer • This appliance can be built into a 20mm to 40mm thick worktop. • If no oven is to be installed below the hob, a panel must be fitted under the hob to prevent hob damage and protect the cupboard contents. This panel must cover the whole of the underside of the hob and must be positioned so that an air g[...]

The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. • The appliance must be earthed. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch. • If damag[...]

Note: Refer to the table on page 6 to ensure the correct type of injector is to be fitted. T raditional burners (T) 1. Remove the pan supports ( A ) . 2. Remove the burners ( B ) . 3. Unscrew the injector ( C ) with a box spanner 7. 4. Replace the injector with the one for the new gas. 5. Replace burners and pan supports. Note: Before installing th[...]

T o fit the double crown wok burner: Insert in the following order: 1. burner ring ( A ); 2 . decorative covering ring ( B ); 3. external burner cap ( C ); 4. internal burner cap ( D ). Note: make sure that: 1. the locating pin for the burner ring ( A ) is inserted correctly in the slot on the burner unit. 2. that the locating pin on the external b[...]

Always disconnect the hob from the electrical power supply and wait until it cools before cleaning and/or doing maintenance work. In order to keep your hob in good condition, you must keep it clean, removing any remaining food each time you use it. Cleaning the hob surface: • the enamelled parts and the glass should be washed with lukewarm water [...]

If the hob is not working properly work through the this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interrupted and that the control knob is turned fully on. 2. the gas supply has not run out. 3. the openings on the burner have be[...]

5019_719_01000_GB 16-07-2007 10:23 Pagina 15[...]

5019 719 01000 Printed in Italy n 07/07 GB Whirlpool Europe S.r .l. Viale G. Borghi, 27 - 21025 Comerio (V A) Phone 0332.759111 - Fax 0332.759268 www .whirlpool.eu 5019_719_01000_GB 16-07-2007 10:23 Pagina 16[...]