Lennox Hearth SWS160 инструкция обслуживания

INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference W ood St [...]

2 CONGRA TULA TIONS! When you purchased your new wood stove, you joined the ranks of thousands of individuals whose answer to their home heating needs reflects their concern for aesthetics, efficiency and our environment. We extend our continued support to help you achieve the maximum benefit and enjoyment available from your new wood stove. Tha[...]

3 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the instal- lation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves during installation to avoid injury from sharp edges on the stove an[...]

4 This manual describes the installation and operation of these non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested and constructed in accordance with the requirements of UL 1482, ULC S627 and HUD standard[...]

5 This appliance is not designed to be operated in a negative pressure. In very airtight homes with large kitchen exhaust fans, furnace cold air returns, fresh air exchange systems and any other air system in close proximity to the heating appliance may create a negative pressure in the same room as the heating appliance. This can create dangerous [...]

6 WA RNING: BE ABSOLUTE L Y SURE THE DIST ANCE BETWEEN THE HEA TER AND THE SURFACE OF ANY COMBUSTIBLE CONSTRUC- TION IS NOT LESS THAN SHOWN IN THE FIGURES ON P AGE 7. Floor Protection USA - The floor in front and under the heater must be protected with noncombustible material. The covering must extend 16” in front of the door opening of the heat[...]

7 Diagram B: Side View-Alcove & Parallel Installation Diagram A: T op View-Parallel Installation K B A E C D *L K Floor Protection Floor Protection Floor Protection G G F F 72" Min. H I M J I J H † E † E L 4 8 ” Ma x im u m De p th Diagram C: T op View-Corner Installation N P T PIPE INST ALLA TION A B (1) C D (1) E† F (1,4) G (4) 6[...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Shown with T ubinox™ Stainless Steel Liner components (see Page 28 for ordering information) Chimney T ermination Cap Chimney T ermination Rain Cap Masonry Adaptor Length 90° T ee Storm Collar Roof Flashing Flashing Ceiling Support Assembly Slip Adaptor Chimney Connector 6” x 24” 24-gag[...]

9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Manufactured Home Installations (ref. Figure 7 ) This appliance is approved for installation into a manufactured (mobile) home in the USA ONL Y! Installation should be in accordance with the Mobile Home Construction and Safety Standard, Title 24 CFR, Part 3280 (in Canada CAN/CSA Z240 MH), or ,[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Chimney Connector Systems and Clearances from Combustible Walls for Residential Heating Appliances (NFPA 211) Refer to Figure 8 System A. Minimum 3.5 in. (90 mm) thick brick masonr y wall framed into combustible wall with a minimum of 12 in. (305 mm) brick separation from clay liner to combus[...]

11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Figure 10 Figure 9 T o install the “Outside Air Kit,” position the clip so that the nut is directly above the hole punched in the back of the heatshield (See Figure 11 ) . Install the outside air adapter box on the stove by sliding it into the air channel located between the bottom heatsh[...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 14. All horizontal runs of pipe should be as short as possible and are requ ired by NFP A No. 211 to have an upwar d pitch or rise in the same direction the smoke travels of no less than 1/4” to the linear foot. The connector pipe must meet minimum clearances in any direction to walls or ot[...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 5. If required, install the Outside Air Kit (cat. no. 71112) as per the following instructions. T o locate the hole in the hearth for outside air mark and cut a 4” (102 mm) hole in the hearth. The hole’ s center should be 3” (76 mm) directly for ward from the center of the flue outlet [...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 1. Check that all chimney pipe joints are securely fastened. 2. Check that the heater is securely fastened to the floor (if ap- plicable). 3. Make sure the intake vent has clear access to outside air (if ap- plicable). 4. Make sure the outside air vent has been sealed properly to keep rodent[...]

15 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Brick Sizes A = 4-1/4” x 9” B = 2-1/4” x 8-7/8” D = 2-1/4” x 9” E = 1-1/2” x 8-7/8” F = Full Brick (4-1/2” x 9”) G = 1-1/2” x 9” Figure 14 3. Next, you will install the baffle blanket. It will be installed with the 11” dimension from the front to rear of the firebo[...]

16 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Be sure to clean plated accessories with a household type cleaner and a ver y soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO ST ART OR REKINDLE A SOLID FUEL FIRE!! 2. Fully open the primar y draft control by pulling the 1” pl[...]

17 W ARNINGS The blower must be plugged directly into a properly grou nded three- pron g rece ptac le, 120 V AC, 60 Hz, single phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance. Installation must be in accordance with National Elec- trical Code, ANSI/NFP A 70 - latest edition. In [...]

18 It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebox for thorough combustion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox. When you first light your stove, the bricks will turn a dark b[...]

19 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. DOOR HINGES: If door hinges need lubricating, use an anti-seize com- pound (never use oil) available from your Lennox Hearth Products dealer . DOOR LA TCH: If your door latch fails to latch tightly and the gasket is in good condition, place a length of pipe (cheater bar) over the inside porti[...]

20 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Draft Requirements on Page 4 ). If your stove is not drafting properly , your chimney is the problem. Al[...]

21 DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and scrap lumber that has be[...]

22 FRONT DOOR P ARTS LIST Item # Ca t. N o De scr i pt ion 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upper Hinge Pin E-Clip 4 H5628 Lower Hinge Pin 6 H5640 Glass Gasket Kit (8’ 4”) 7 H5577 Set of 6 screws and 6 washers for door assembly 8 H5654 Spring Handle / Nickel H5653 Spring Handle / Gold 9 71067 T radi[...]

23 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODELS S160 AND SWS160[...]

24 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODELS S160 AND SWS160 Door Parts Blower Parts 7 13 1 2 3 4 5 6 8 1 2 3 4 5 9 10 8 14 11 6 7 12 25 29 31 28 27 26 32 30[...]

25 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODELS S160 AND SWS160 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 22 24 18 20 21 23 Leg and Leg Parts[...]

26 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODELS S160 AND SWS160 15 18 15 18 19 16 17 19 Ash Drawer Pedestal and Pedestal[...]

27 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Product Reference Information Cat. No. Description Ship. Weight Ship. Volume H 7 8 8 4 S1 60 T -B , S to v e / T ra di ti o n a l B l a c k D o o r / N i c k e l N a m e p l at e 3 1 3 l b . 1 8 . 9 1 c u . f t . H 7 8 8 3 S1 60 A- B , S t o ve / A r c h Bl a c k D o o r / N i c k e l N a m e[...]

28 ACCESSORIES - MODELS S160 AND SWS160 Secure Black™ Single Wall Stove Pipe 6” SW Pipe and Accessories Cat. No. Model Description Pc. / Container 6SWL6 6SWL6 LENGTH 6” X 6” 100 6SWL12 6SWL12 LENGTH 6” X 12” 5 6SWL24 6SWL24 LENGTH 6” X 24” 10 6SWL36 6SWL36 LENGTH 6” X 36” 2 6SWL48 6SWL48 LENGTH 6” X 48” 5 6SWL T 6SWL T TELES[...]

29 ACCESSORIES - MODELS S160 AND SWS160 Secure T emp® Factory-Built Chimney 6” Secure T emp ASHT and Secure T emp G-ASHT Cat. No. Model Description Pc. / Container Lengths and Fittings 6L8 6L8 LENGTH 6” X 8” 1 6L12 6L12 LENGTH 6” X 12” 1 6L18 6L18 LENGTH 6” X 18” 1 6L24 6L24 LENGTH 6” X 24” 1 6L36 6L36 LENGTH 6” X 36” 1 6L48 [...]

30 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. SAFETY / LISTING LABEL - ENGLISH 2011 2012 2013[...]

31 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. SAFETY / LISTING LABEL - FRENCH[...]

32 Y our Appliance’ s Model Number _______________________________________ Y our Appliance’ s Serial Number ________________________________________ The Date On Which Y our Appliance Was Installed __________________________ Y our Dealer's Name _________________________________________________ WARRANTY Y our wood appliance is covered by a l[...]