Lennox Hearth WS инструкция обслуживания

Report No. 317-F-1 1-5 IN S T AL L A TI O N AN D O PE R A TI O N M AN UA L Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WHA T TO DO IF YOU SMELL GAS • Do not light any appliance. • Do not touch any electrical switches; do not use any phone in your building. • Immediately ca[...]

2 • Children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns or clothing ignition. • Y oung children should be carefully super vised when they are in the same room with the heater . • Do not place clothing or other flammable material on or near the heater . • Any safety screen or g[...]

3 2.0 GENERAL INFORMA TION This appliance is a high efficiency , unvented, flame effect gas heater . It provides radiant and convected warmth both efficiently and safely utilizing the latest type catalytic convertor burner technology . The appliance does not require a flue system of any type as the catalytic converter cleans the flue products [...]

4 6.0 BURN-IN PERIOD On initial light up of a new appliance, the ‘newness’ will burn off within the first few hours of operation. During this period some smoke may be emitted from outlet grill, this should be no cause for concern. Accord- ingly , the room should be well ventilated with all windows and doors open during this period. Depending o[...]

5 8.0 COMBUSTION AND VENTILA TION AIR This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventil ation air . The heater may be located in unusually tight construction provided the space is unconfined, or if confined, is provided with two permanent openi[...]

6 9.0 SITE REQUIREMENTS This appliance is designed to be wall-hung. Do not recess any part of the appliance into the wall. This appliance may be installed in any room in a home except bedrooms or bathrooms - or areas where large amounts of steam are likely to be generated. It should be noted that heaters create warm air currents. These currents mov[...]

7 Non-concealed gas connections may be made using the entry points on the base of the firebox. A concealed gas connection may be made using the knockout hole in the center back of the firebox. Select the most appropriate entry point and knock out the relevant hole. No more than 59" of 1/4" diameter pipe must be used to avoid unnecessary[...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE Figure 3 - Wall Fixing T emplate FPO After having selected the final mounting position of the appliance, taking into account the site requirements as specified in these instructions, the integrity of the wall, and the feasibility of the proposed supply pipe routing, the firebox of appliance [...]

NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 9 It is recommended that the burner height, where possible, should be approximately 4 ft. from the floor . This will give the best viewing position. When selecting the height, ensure that the clearance to the ceiling is 32" minimum, as specified on Page 6 . After selecting the final mounting[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 14.0 CHECKING THE BURNER There are no imitation fuel bed components, such as logs or rocks, to install. The appliance features a ribbon burner which is designed to produce a continuous band of flame over its length. The burner should be visually inspected to ensure it is free from any foreign [...]

11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 16.0 CHECKING THE GAS CONNECTIONS T urn on gas supply and test for gas leaks using a gas leak test solution (also referred to as bubble leak solution). NOTE: using a soapy water solution (50% dish soap, 50% water) is an effective leak test solution, but it is not recommended, because the soap [...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 18.0 SP ARK GAP Figure 8 - Proper Spark Gap 1/8" to 3/16" Spark Gap 19.0 BRIEFING THE CUSTOMER W ARNING Do not add log s or orn ame nts suc h as pin e co nes , ver mic uli te or rock wo ol. Using thes e adde d ite ms can ca use so oti ng. All instructions must be left in the possessi[...]

13 W ARNING Any chan ge to this heat er or its con tro ls can be dan ger ous . W ARNING No adju stm ent s are to be mad e to the OD S pi lot sy st em . T am pe ri ng wi th th is sys te m ca n be ex tr em el y haz ard ous . W ARNING Y ou mus t kee p co ntr ol ar eas , bur ner s an d cir cul at- ing a ir pass age way s of ap pli anc e c lea n. Fa ilu[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 21.0 CA T AL YSTS W ARNING Do not blo ck the ca tal ys ts or the app li an ce out le t gri ll . Blo cka ge may cause high car bon monox ide level s and /or b rea kag e o f t he gla ss fac ia pan el. Figure 9 - Catalysts and Outlet Grill It is recommended that the catalysts are inspected for si[...]

15 FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTL Y , A FIRE OR EXPLOSION MA Y RESUL T CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lit with a piezo spark igniter . When lighting the pilot, follow these instructions exactly . B. BEFORE OPERA TING [...]

16 24.0 TROUBLESHOOTING GUIDE PROBLEM CORRECTIVE ACTION Igniter sparks but pilot does not light • No gas to Pilot, check the gas line connections. • Air not fully purged. Purge supply or wait longer . • Spark grounding to metal work, reset gap correctly . • Blocked pilot, clean out internally . Pilot lights but then goes out • Severe rest[...]

17 WARNING CLEARANCES FROMCOMBUSTIBLEMATERIALS F860041/A The following clearances must be maintained at all times. Failure to do so may result in the risk of a fire. For full information refer to the instruction manual provided with the heater. Note : Zero clearance from bottom of heater frame required for hard combustible floors. Minimum 4” cl[...]

18 26.0 POSITIONING OF FIELD REMOV ABLE P ARTS Glass Door Removal: Remove the four (4) screws indicated, then lift door off. Figure 12 W ARNING Fai lur e to pos iti on the par ts in acc ord anc e wi th thes e di agr ams or fai lu re to use onl y par ts spe ci fi- cal ly app rov ed wit h this he ate r may res ult in pro per ty dama ge or per son al[...]

19 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 27.0 SPECIFICA TIONS X-FIRE-WIDESCREEN Surround Kits Cat. No. Model Description S h ip . Wt . Ship. Volume H7228 X - FI RE -W S- L Limestone Surround 71 l b. 6 . 15 c u. f t. H7229 X - FI RE -W S- G Granite Surround 7 1 l b. 6 .1 5 c u. f t. Product Reference Information Cat. No. Model S h ip [...]

20 Printed in U.S.A. © 2008 Lennox Hearth Products P/N 506023-05 REV . A 11/2008 Lennox Hearth Products reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. WARRANTY Y our ga[...]