Lenovo LXH-GJ17L3 инструкция обслуживания

Contents CERTIFICATIONS -------------------------------------------------------------------- 2 NOTICE ---------------------------------------------------------------------------------- 2 PRECAUTIONS ---------------------------------------------------------------- 3 SPECIAL NOTES ON LCD MONITORS --------------------------------- 4 BEFORE YOU OPERATE[...]

CE certificate This shipped version of this device complies with the requirements of the EEC directive 89/336/EEC “Electromagnetic compatib ility” and 73/23/EEC “Low voltage directive”. FCC Class B Radio Frequen cy Interference Statement WA RNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply w ith the [...]

PRECA UTIONS z Do not use the monitor near water, e.g. near a bathtub, w ashbowl, kitchen sink, laundry tub, sw imming pool or in a wet basement. z Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and c ause serious damage to the appliance. Use only a cart or stand recommended by the manufa[...]

SPECIA L NOTES ON LCD MONITORS The following symptoms are normal w ith LCD monitor and do not indicate a problem. NOTES • You may find slightly uneven br ightness on the screen depending on the desktop pattern you use. • The LCD screen has effective pixels of 99.99% or more. It may include blemishes of 0.01% or less such as a missing pixel or a[...]

INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel Base 1. During installation, place the display base the right-w ay up on a flat surface. Place upper part of the display slow ly on to the base and w ait for the click signifying that it is completely in pl ace. Securely fasten the screw w ith hands or [...]

CONTROLS A ND CONNECTORS Ad ap t e r Connecting the ad apter: Connect one end of the adapter to back of the monitor and connect the other end to the power cord. Pow er cord Connecting the power cord: Connect one end of the power cord to the AC adapter and connect the other end to the power supply (90V-264V AC Voltage). SIGNA L CABLE Connecting the [...]

A DJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’ s angle to your ow n preference. • Hold the stand so you do not t opple the monitor when you change the monitor’s angle. • You are able to adjust the monitor’s angle from -5 ° to 20 ° . -5 ° 20 ° Fig[...]

OPERATING INSTRUCTIONS GENERA L INSTRUCTIONS Press the power sw itch to turn the m onitor on or off. The other control knobs are located at front panel of the monitor (See Figure 4). By changing these settings, the picture can be adjust ed to your personal preferences. Figure 4 External Control Button EXTERNA L CONTROLS 1. Auto Config / Exit 2. ▲[...]

FRONT PA NEL CONTROL • Pow er / Pow er indicator : Press this knob to switch ON/OFF of monitor’s pow er. and display the monitor’s state. Blue — Powe r On mode. Orange — Power Off mode. • MENU/ENTER / : Activate OSD menu or function adjusts confirmation. • Contrast / ▼ : Adjust contrast or function adjustment. • Brightness / ▲ :[...]

HOW TO USE OSD The main menu will be displayed as follow s (see figure 5). If OSD window is in Chinese when pow er on, press ▲ or ▼ to choose the next window . Choose the English, then press MENU Key . for confirming. OSD window w ill display in English. 1. Press the MENU-Key . to show the OSD w indow. See figure 5. 2. Press ▲ or ▼ to selec[...]

3.1 FOCUS Adjust the picture Focus. 3.2 CLOCK Adjust the picture Clock. 4. LANGUAGE Multi-Language selection. 5. OSD TIMER Choose OSD window display time. 6. COLOR TEMPERATURE 6.1 7800K/6500K (COLOR TEMPERATURE) The color temperature for 7800K is x=0.296, y=0.311 and 6500K is x=0.313, y= 0.329. It presents tw o different color sets on the screen. Y[...]

Green monitor • The monitor has a power saving f unction that conforms to the VESA standard. When the comput er input no signal, the monitor will enter the shuts off mode. The power-saving mode can be indicated by the light-emitting diode (LED) on the front panel: Signal Power Mode Cable Picture Indicator Consumption On Attached Active Blue ≤ 4[...]

TECHNICA L SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Pow er Switch is in the ON position *Power Cord should be connected *Check the Power socket. *Replace new Pow er Cord. No picture, the LED indicator is light up *The Signal Cable should be completely connected to the computer. *If it is orange, t hen[...]

Screen image is not centered or sized properly. *Adjust pixel frequency (CLOCK) and FOCUS or press hot-key (AUTO). Picture has color defects *Adjust RGB color or select color temperature (white does not look w hite) Poor brightness or contrast *When the brightness of the screen lowers after being used for a certain period and the function of the di[...]

ERROR MESSA GE & POSSIBLE SOLUTION NO SIGNA L INPUT 1. T he computer is switched off. 2. T he computer is dormancy. CA BLE NOT CONNECTED : 1. Check that the signal-cable is pr operly connected, If the connector is loose, tighten the connector’s screws. 2. Check the signal-cable’s connection pins for damage. INPUT THE RESOLUTION OUT OF THE R[...]

A PPENDIX A SPECIFICA TIONS Type TFT Color LCD Size 43.2cm(17") LCD Panel Pixel pitch 0.264mm( H ) x 0.264mm( V ) Video R,G,B Analog Interface Separate Sync. H/V TTL H-Frequency 30kHz - 80kHz Input V-Frequency 50Hz-75Hz Display Colors 16.2M Colors Dot Clock 135MHz Max. Resolution 1280 x 1024 Plug & Play VESA DDC2B TM Input Connector D-Sub [...]

A PPENDIX B FA CTORY PRESET TIMING TABLE STANDARD RESOLUTION HORIZONTAL FREQUENCY VERTICAL FREQUENCY Dos-modo 720 × 400 31.47kHz 70Hz 640 × 480 31.47kHz 60Hz 640 × 480 37.861kHz 72Hz VGA 640 × 480 37.50kHz 75Hz 800 × 600 37.879kHz 60Hz 800 × 600 48.077kHz 72Hz SVGA 800 × 600 46.875kHz 75Hz 1024 × 768 48.363kHz 60Hz 1024 × 768 56.476kHz 70H[...]

A PPENDIX C CONNECTOR PIN A SSIGNMENT 15 6 10 11 15 Figure 6 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. Ground 3. Blue 11. Ground 4. Ground 12. DDC-Serial Data 5. Ground 13. H-Sync 6. R-Ground 14. V-Sync 7. G-Ground 15. DDC-Serial Clock 8. B-Ground 18[...]