Linksys SS210 инструкция обслуживания

INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference A F ren c[...]

2 General Safety Precautions 1. If this solid-fuel room heater is not properly installed, a house fire may result. For your safety , follow the installation direc- tions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves during installation to avoid injury from sharp[...]

3 T able of Contents General Safety Precautions ................................................................. 2 T esting Information ........................................................................... 4 Draft Requirements ........................................................................... 4 Selecting the Proper Venting System ..[...]

4 T esting Information This manual describes the installation and operation of the Per - former™ S210 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested and constructed in accordance with the require- m[...]

5 Negative Pressure Warning This appliance is not designed to be operated in a negative pres- sure. V ery airtight homes with large kitchen exhaust fans, or homes with furnace cold air returns located in close proximity to the wood stove or fireplace insert may create negative pres - sure in the same room as the heating appliance. This can create [...]

6 Clearances to Combustibles WARNING: BE ABSOLUTEL Y SURE THE DIST ANCE BE- TWEEN THE HEA TER AND THE SURFACE OF ANY COM- BUSTIBLE CONSTRUCTION IS NOT LESS THAN SHOWN ON THE DIAGRAM BELOW . Floor Protection USA - The floor in front and under the heater must be protected with a minimum of 3/8” thick noncombustible material. The cover - ing must e[...]

7 A B D L †E †E K C H I J Floor Protection FLOOR PROTECTION I M F F T Floor Protection G G K 48 ” Ma x . De p t h Di a g ra m C : T op Vi e w Co r n er Cl ear a nc e , S t o ve a nd F lu e t o W all NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 6” Ø Flue Collar PIPE INST ALLA TION A B (1) C D (1) E† F (1,4) Si n g le W a l l Re s[...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Heatshield Mounting Holes Air Channel Front Figure 2 Figure 1 Outside Air Kit Installation T o install the “Outside Air Kit,” position the clip so that the nut is directly above the hole punched in the back of the heatshield (See Figure 3 ) . Install the outside air adapter box on the stov[...]

9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Stove Installation 1. If not previously installed, install floor protection and move the heater into the desired location. 2. Pos it io n the sto ve on your floo r pro tec ti on in the exac t loc at ion where it is to be located, making sure all minimum clearanc es are met. 3. If you are ins[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 5. If required, install the Outside Air Kit (P/N 71112) as per the following instructions. T o locate the hole in the hearth for outside air mark and cut a 4” (102 mm) hole in the hearth. The hole’ s center should be 3” (76 mm) directly forward from the center of the flue outlet or loc[...]

11 Post Installation Checks 1. Check that all chimney pipe joints are securely fastened. 2. Check that the heater is securely fastened to the floor (if applicable). 3. Make sure the intake vent has clear access to outside air (if applicable). 4. Make sure the outside air vent has been sealed properly to keep rodents out (if applicable). 5. Be sure[...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 3. Included with the stove are two 15-1/4”x 11-1/2”x 1/2” thick ceramic fiber blankets. Install one blanket above the baffle brick and to each side of the support bracket. Make sure that the blankets are fully to the rear . 4. Next, install the front baffle bricks #33-38 under the ce[...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Operating Hints 1. Burn only dr y , well-seasoned wood for maximum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products. 2. Y our stove is designed to operate with the door closed! Operate only with the door shut tightly at all times excep[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 4. Light the paper and allow sufficient time for the kindling to become fully engulfed in flames. Close the door . Y our door may or may not need to be left slightly open during this process , depend ing on your stove mod el and chimne y draft. Once the kindling is burning well, larger piec[...]

15 Operating T echniques and Hints Rece nt devel opm ents in wood burni ng techn olo gy have made wood burning a cleaner and more convenient way to heat your home. Overall efficiency in a wood burning appliance is a combination of combu stio n effici ency and heat tran sfer efficie ncy . Whether heating your entire home or just a room or two, yo[...]

16 Maximizing Y our Stove’ s Overall Efficiency It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebo x for thorough combust ion. The best method for determi ning if you have sufficient temperatures is to watch the brick lining in your firebox. When you fir[...]

17 Experiment with different loading configurations to achieve longer burns. T ry loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides. Hot coals or half burned wood should be brought towards the front of the firebox. T[...]

18 T roubleshooting Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys nor - mally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) . If your stove is not drafting properly , your chimney[...]

19 Do’ s and Don’ts DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and scr[...]

20 Replacement Parts - Models SS210 Contact an Authorized Lennox Hearth Products dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance and safety hazards. BL O W ER P AR T S H5 6 5 8 Fa n B lad e ( F S B7 0 0 ) H5 6 5 7 Fa n C age (F S B 70 0 ) H5 6 6 0 Bl o we r P o we r Co r [...]

21 Replacement Parts - Models ST210 PE D ES T ALS (R E QU I R ED ) 71 1 13 P e d es t al 71 1 14 As h D r a we r P e d es t al OR LE G S ( R EQ U I RE D ) 70 0 00 Ol y mp i c S c ul p t ur e d B l ac k 70 0 01 Ol y mp i c S c ul p t ur e d G o ld 70 0 02 Ol y mp i c S c ul p t ur e d N i ck e l 70 0 07 Ol y mp i c S c ul p t ur e d B r us h ed G ol[...]

22 Accessories Models SS210 Accessories Models ST210 PE D E ST ALS ( RE Q U IR E D ) Ca t . N o . De s c ri p ti on 71 1 1 3 P e d es t al 71 1 1 4 A s h D r aw er P ed e s ta l OR L EG S ( REQ U IR E D ) 70 0 0 0 O l y mp i c Scu l pt u r ed B la c k L e g s ( 4 per pk g . ) 70 0 0 1 O l y mp i c Scu l pt u r ed G ol d Le g s ( 4 p er p kg . ) 70 [...]

23 Notes[...]

Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,215M REV . C 05/2008 Lennox Hearth Products reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. 24 WARRANTY Y our [...]