Longshine LCS-WA3-50 инструкция обслуживания

IEEE 802.1 1n Wireless Series Wi reless Access Point User Manual[...]

Wireless 11n Access Point 1 FCC Certifications Federal Communication Commission Interference St atement This equipment has been tested and found to comply with the limit s for a Class B digit al device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential inst[...]

Wireless 11n Access Point 2 CE Mark W arning This equipment complies with the requirement s relating to electromagnetic comp atibility , EN 55022 Class A for ITE, the essential protection requirement of Council Dir ective 2004/108/EC on the approximation of the laws of the Member S tates relating to electromagnetic comp atibility and R&TTE Dire[...]

Wireless 11n Access Point 3 Content s Unpacking Information ········································································································ 4 Chapter 1 Introduction to Wireless Access Point ···············?[...]

Wireless 11n Access Point 4 Unp acking Information Thank you for purchasing the product. Before you start, please check all the content s of this package. The product p ackage should include the following: 1. One Wireless Access Point with one antenna 2. One Power Adapter 3. Four Rubber Feet 4. One Quick installation Guide 5. One resource CD, inclu[...]

Wireless 11n Access Point 5 Chapter 1 Introduction to Wireless Access Point 1.1 General Description Easily constructing your LAN, this wireless access point off ers a wireless interface and eliminates your effort busying cabling form one computer to another. With being compliant to IEEE 802.11n specification, this wireless access point supports dat[...]

Wireless 11n Access Point 6 1.3 The Front Panel The front panel of the Wireless 1 1n Access Point: Name St atus Indication Green Power On Dark Power Off St atus System Resetting default Blink Green a few times Blink Green one time System Reboot Blink Green WPS Connecting WPS Dark System S tability Off The wireless function is disabled Flashing The [...]

Wireless 11n Access Point 7 1.4 The Rear Panel The rear panel of the Wireless 1 1n Access Point is shown below .  LAN(1~2): Through these port s, you can connect the AP to your PCs and the other Ethernet network devices.  DC IN: Plug the circle end of the power adapter firmly into the rear p anel of the Wireless AP , and the other end put int[...]

Wireless 11n Access Point 8 second way is to attach it to the wall. If you select a wall-mount option, please follow the steps below: 1. Select a location with access f or cables and a power outlet. 2. Unplug the unit. Place it upside down on a flat surface and mark the two holes for anchors. 3. Installing the wall mount anchor (not supplied) into [...]

Wireless 11n Access Point 9 Chapter 2 Inst alling and Using Wireless Access Point This chapter provides a step-by-step guide to the inst allation and configuration of the Wireless AP . We suggest you go over the whole chapter and t hen do more advanced operation. 2.1 Connecting this AP to y our network This Chapter provides a step-by-step guide to [...]

Wireless 11n Access Point 10 2.2 Configuring the IP address of your computer In order to communicate with this Wireless AP , you have to configure the IP addresses of your computer to make it compatible with the device. 1. The default network setting of the device: IP address : 192.168.1.2 54 Subnet Mask : 255.255.255.0 Note: if you connect this AP[...]

Wireless 11n Access Point 11 2. Right-click on Local Area Connection item and click on Properties . 3. Choose Internet Protocol (TCP/IP) and click Properties .[...]

Wireless 11n Access Point 12 4. Y ou can’t choose “Obtain an IP address automatic ally” to get IP address automatically in this configuration. Choose “Use the following IP address” to specify IP addresses manually . Please click the OK button after your configuration.[...]

Wireless 11n Access Point 13 Chapter 3 Management 3.1 S t arting the WEB-Based Management Interface The device uses WEB as the management interface. Y ou can use a browser to access the management interface easily . Please follow the steps listed below . 1. Open the Internet WEB browser . 2. T ype 192.168.1.254 into the URL WEB address location and[...]

Wireless 11n Access Point 14 Items Information Uptime The period that you turn the device on. Firmware version The current firmware version of the device. Build Time The build time of the device originally . Mode Shows if the device is operating in AP or WDS mode. Band The band that the wireless AP opera ting. SSID The name of this wireless network[...]

Wireless 11n Access Point 15 Wireless 3.2.1 Basic Settings This page is used to configure the p arameters for wireless LAN clients which may connect to your Access Point. Here you may change wireless encryption settings as well as wireless network parameters. Y ou can set up the configuration of your Wireless basic settings and monitor the Wireless[...]

Wireless 11n Access Point 16 Network T ype When you configure this device in Client mode, this drop-down list allows users to change the network type into infr astructure mode or ad-hoc mode. Ad-Hoc mode: connects two computers directly without the use of a router or AP . It is also know as a peer-to-peer network. Infrastructure Mode: the wireless [...]

Wireless 11n Access Point 17 1. Multiple APs This is the window that pops up after clicking the button. Select one of the AP, and then click the button “Show”, “Active Wireless Client Table” window pops up. 2. Active Wireless Client Table This is the window that pops up after clicking the button.[...]

Wireless 11n Access Point 18 3.2.2 Advanced Settings Y ou can set advanced wireless LAN parameters of this AP . We recommend not changing these parameters unless you know what changes will be on this AP . Items Information Fragment Threshold This value should remain at its default settin g of 2346. If you experience a high packet error rate, you ma[...]

Wireless 11n Access Point 19 Aggregation To aggregate lots of packets into a big one before transmitting packets. This can reduce control packet overhead. Short GI Indicates that the 802.11g network is using a short slot time because there are no legacy (802.11b) stations present RF Output Power Select the signal strength for the wireless network. [...]

Wireless 11n Access Point 20 1. Security Mode -- WEP Items Information Encryption Select a security encryption mode for this AP . Authentication ee options for selecting: Open System, There provide thr Shared Key , Auto Key Length Select 64-bit or 128-bit as the key encryption length. Key Format Select ASCII 1 or Hex 2 to setup the key value. crypt[...]

Wireless 11n Access Point 21 2. Security Mode – WPA / WPA 2 Items Information Authentication Mode There are two items, “Enterprise (RADIUS)” and “Personal (Pre-Shared Key)”. Y ou can select the mode by clicking the item. WP A Cipher Suite Select the WP A Cipher Suite to be TKIP or AES. Pre-Shared Key Format T o decide the format, select P[...]

Wireless 11n Access Point 22 3. Security Mode – WPA-Mixed Items Information Authentication Mode There are two items, “Enterprise (WP A-Radius)” and “Personal (Pre-Shared Key)”. Y ou can select the mode by clicking the item. WP A / WP A2 Cipher Suite Select the WP A/WP A2 Cipher Suite to be TKIP or AES. Pre-Shared Key Format T o decide the[...]

Wireless 11n Access Point 23 3.2.4 Access Control T o restrict th e clients of Access authentication of S tations, set up the control list in this p age. Items Information Wireless Access Control Mode Click on the drop list to choose t he access control mode. Y ou may select “Allow listed” to allow those allowed MAC addresses or select “Deny [...]

Wireless 11n Access Point 24 3.2.5 WDS Settings When you use this device as WDS or AP+WDS mode, “WDS Setting” function can be operated. Wireless Distribution System allows the AP to communicate with other APs wirelessly . T o make it work, you must ensure that these APs and the Router are in the same channel. Ple ase add these APs MAC address a[...]

Wireless 11n Access Point 25 table and click on to connect to other wireless network nearby . The button can be used to scan nearby AP again. 3.2.7 WPS Settings The primary goal of Wi-Fi Protected Setup (Wi-Fi Simple Configuration) is to simplify the security setup and management of Wi-Fi networks. This AP supports the configuration set up using PI[...]

Wireless 11n Access Point 26 Configuration of easy setup WPS connection. Y ou can simply click th e button in this GUI p age. After click on the button, please run the client’ s WPS and push the PBC button within 2 minutes. Client PIN Number Personal Identification Number (PIN) method. Users have to fill in the PIN code of enrollee device and cli[...]

Wireless 11n Access Point 27 Items Information IP Address The IP of your AP LAN port (default 192.168.1.254). Subnet Mask Subnet Mask of you LAN (default 255.255.255.0). All devices on the network must have the same subnet mask to communicate on the network. Default Gateway Enter the IP Address of the AP in your network. DHCP DHCP st ands for Dynam[...]

Wireless 11n Access Point 28 3.5 System Log This System Log page shows the information of the current activities on the AP . T o enable system log function: 1. Mark the “Enable Log” checkbox. 2. T o see all information of the system, select the “system all” checkbox. T o see wireless information only , select the “wireless” checkbox. T [...]

Wireless 11n Access Point 29 3.6 Upgrade Firmware Sometimes a new firmware may be issued to upgr ade the system of this device. Y ou could upgrade the firmware you got in this page . T o upgrade the firm ware, please click on the button, locate the firmware in your computer and then click the button to execute. 3.7 Save/Reload Setting The Save/Relo[...]

Wireless 11n Access Point 30 3.8 Password T o set up the Administrator Account information, enter the Username, New p assword, and reenter the password on the text box. Don’t forget to click the to save the configuration. 3.9 System T ime Setting This page allows users to configure the time of the AP . T o specify manually , fill in the blanks in[...]

Wireless 11n Access Point 31 Appendix A: Product Specifications St andard IEEE 802.1 1n draft 2.0, IEEE 802.1 1g, IEEE 802.1 1b, IEEE 802.3, IEEE 802.3u Interface LAN: 2 ports 10/100 Mbp s Ethernet, RJ-45 1* fixed antenna (S tandard 2 dB) 1* reset to factory default button 1* WPS button Antenna Antenna type: Dipole Antenna connector type: Fixed Cab[...]

LONGSHINE Technologie (Europe) GmbH Post A ddress: P.O.Box 1460 D-22 904 A hrensburg Tel: ++49-(0)-4102-4922-0 House Address: A n der Strusbek 9 D-22 926 Ahrensburg Fax: ++49-(0)-4102-40109 WEB: http://w ww .longshine.de E-MA IL: sales@longs hine.de Geschäftsführer: Dresdner Bank USt-IdNr.: Registergericht: Dr. Rong-Jye Lu BLZ 200 800 00, Kto.-Nr[...]