Lumex Syatems 763400A инструкция обслуживания

O O p p e e r r a a t t o o r r s s M M a a n n u u a a l l GF0500067REV A05 L o w Air L oss T herap y Mattress Replacement S y stem Model # 763400A P P l l e e a a s s e e r r e e a a d d t t h h e e m m a a n n u u a a l l b b e e f f o o r r e e u u s s e e[...]

Contents Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Product Description . . . . . . . . . . . . . . . . . . . . . . . . .[...]

2 IMPORT ANT SAFEGUARDS READ ALL INSTRUCTIONS BEFORE USING DANGER - T o reduce the risk of electrocution: 1. Always unplug this product immediately after using. 2. Do not use while bathing. 3. Do not place or store product where it can fall or be pulled into a tub or sink. 4. Do not place in or drop into water or other liquid. 5. Do not reach for a[...]

3 1. Introduction This manual should be used for initial set up of the system and for reference purposes. 1.1 General Information LumexAir systems use most advanced technologies and mattress materials to deliver the best quality , comfort and whisper-quiet operations to you and your customers. Most systems in LumexAir are recommended for prevention[...]

4 2. Product Description 2.1 Pump and Mattress System 1. Mattress 2. Pump unit 3. Air tube connector 4. Control Panel The system consists of a high volume airflow blower and numerous large air loss holes on the mattress to achieve the true low air loss therapy . It also provides excellent ventilation and keeps patients dry from humidity . The 10 in[...]

5 3. Installation 3.1 Unpacking The pump unit and mattress are packaged in a separate box to secure its contents inside. Unpacking these boxes to remove the pump unit and mattress and check for any damage, which may have occurred in shipping. If there are damages, please contact your dealer immediately . 1. Place the mattress on top of the bed fram[...]

6 4. Plug into main electrical outlet. NOTE 1. Make sure the pump unit is suitable for the local power voltage. 2. The plug also serves as the disconnect device CAUTION: The pump can only be applied to the mattress recommended by the manufacturer . Do not use it for any other purpose. 5 Then turn the main power switch ON. The power switch is locate[...]

7 4. Operation NOTE: Always read the operating instructions before use. 4.1 Function Description: Control Button Function Description POWER T wo conditions: 1. T o turn on control unit. It takes approximately 1 minute to inflate the mattress. The default setting is at a comfort range, level 6, for the quickest inflation time. 2. T o turn off Power [...]

8 Control Button Function Description AUTOFIRM For maximum inflation of mattress. All other functions are disabled unless this button is pressed again. This mode will last for 20 minutes and then it will return to default setting automatically . ST A TIC For true low air-loss therapy mode, similar to a regular air mattress with very low air pressur[...]

9 4.2 Operating Instruction 1. Press the POWER button on the display panel to start the system. 2. For faster inflation, the AUTOFIRM function can be activated. This mode will last for 20 minutes and then it will return to default setting automatically . 3. After the mattress is fully inflated, user can change the setting according to their prefere[...]

10 NOTE: If the pressure level is consistently low , check for any leakage at air cells or connecting tubes. If necessary , replace any damaged cells or tubes or contact local qualified dealer for repair . If the control unit is equipped without audible alarm feature, the Low Pressure Indicator will flash until the low-pressure fault condition is s[...]

11 6. Storage 1. Pull the CPR tags and make sure all cells are deflated. 2. Lay the mattress out flat and upside down. 3. Protect the air tube coupler by putting it in the inner side of mattress. 4. Roll the mattress from the head end towards the foot end. 5. Foot-end straps can then be stretched around the rolled mattress to prevent unrolling. 7. [...]

12 Problem Solution Power is not ON • Check if the plug is connected to main power . • Check if there is any blown fuse. Alarm is on (audible & visual) • Check if the connection between air tube connector to pump unit is tightly secured. • Check if the CPR is sealed. • Check if there are any leakage on air cells. • Check if all tubi[...]

13 Pump Specification Power Supply ( Note: See rating label on the product) 120V AC 60Hz, 1A (For 120V system) 230V AC 50Hz, 7W ( For 230V system) Fuse Rating 5A (For 120V system), T3A ( For 230V system) Dimension 37 x 27 x 13 (cm) or 14.4" x 10.5" x 5" Weight 4.5 kg or 9.9 lb Environment T emperature Operation:10° C to 40° C (50°[...]

U.S.A., Corporate Headquar ters: Graham-Field Health Pr oducts 2935 Northeast Parkway Atlanta, Geor gia 30360 telephone: 800-347-5678, 770-447-1609 fax: 800-726-0601, 678-291-3232 http://www .grahamfield.com[...]