Mackie HD1501 инструкция обслуживания

HD1501 OWNER’S MANUAL 15” P ower ed Subwoofer[...]

1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’ s instructions. 8. Do not install near any heat sources such as radiators, heat r[...]

Contents IMPOR T ANT SAFETY INSTRUCTIONS 2 CONTENTS 3 FEA TURES 3 INTRODUCTION 3 HOOKUP DIAGRAMS 4 REAR P ANEL FEA TURES 7 INS AND OUTS OF POLARITY 10 PLACEMENT 11 THERMAL CONSIDERA TIONS 11 Introduction Thank you for choosing the Mackie HD1501 subwoofer . Mackie HD Series Powered Subwoofers provide intense low-frequency extension and punch to any [...]

HD1501: 3-W A Y MONO SUB SYSTEM WITH SRM450V2 LOUDSPEAKERS Hookup Diagrams MO N MAIN 4 3 2 15 /6 7/ 89 /10 11/12 SRM450v2 reproduces all frequencies above the subwoofer’ s crossov er point Le ft line level output Right line level output Po we r Cor d Line-level High P ass output B SRM450v2 reproduces all frequencies above the subwoofer’ s cross[...]

HD1501: STEREO 3-W A Y SYSTEM WITH HD1521 LOUDSPEAKERS 1 2 3 4 5 6 7 8 9-10 11-1 2 1234 HD1521 reproduces all frequencies above the subwoofer’ s crossov er point HD1521 reproduces all frequencies above the subwoofer’ s crossov er point Po we r Cor d Po we r Cor d P ole Mount P ole Mount Line-level High P ass output A Line-level High P ass outpu[...]

HD1501: STEREO 4-W A Y SYSTEM WITH HD1521 LOUDSPEAKERS AND DUAL SUBWOOFERS This diagram shows the left and right line level outputs of a Mackie Onyx 1640i mixer feeding input A of two Mackie HD1501 subwoofers. The Full Range output A of each subwoofer then feeds input A of another pair of Mackie HD1501 subwoofers. The High Pass output A of these su[...]

Rear Panel Features 1. IEC AC Receptacle Thisjackacceptsthesupplied 3-prongACpowercord. BeforeyouplugtheACpowercordintothe powered subwoofer , make sure that the voltage of your unit is the same voltage as your local AC mains supply . Use only the power cord supplied. Also, disconnecting the plu[...]

3. INPUTS ThesefemaleXLRconnectorsacceptbalanced line-level signals from a mixing console or other signal source. If you are connecting a single subwoofer output, or LFE (low-frequency effects) output to the subwoofer , youmayuseeithertheAorBinputconnector . CAUTION: NEVER connect the output of an ampli?[...]

9. SIG/LIMIT LED This bi-color LED illuminates green whenever ther e is a signal present at the main inputs. It senses the signal just after the level control, so adjustments to the level controlwillaffectthesig/limitindicator . The HD1501 has a built-in limiter that helps to pre- vent the amplifier outputs from clipping or overdriv[...]

The Ins and Outs of Polarity Mackie’s HD-Series Power ed Subwoofers include a switch that allows you to quickly invert the polarity of the subwoofer’s output r elative to the input signal it is receivingfromthemixerorothersoundsource.But what exactly does that mean? A subwoofer works by lit- erally pumping air as the [...]

Placement The HD1501 subwoofer is designed to sit on the floor or stage. A socket is provided on top of the HD1501 for mounting other Mackie loudspeakers. Use the optional Mackie speaker mounting pole to mount them on the HD1501.Seethehookupdiagramsstartingonpage4. Check to make sure that the support surface (e.g., floor ,[...]

P oor bass performanc e • Checkthepolarityoftheconnectionsbetween the mixer and the subwoofers. Y ou may have your positive and negative connections r eversed at one end of one cable, causing one subwoofer to be out-of-phase. • Checkyoursubwooferpolarityswitchesare configured appropriately for your [...]

Appendix B: Connections “XLR ” Connectors TheHD1501hastwofemaleXLRinputsthataccept balanced li n e- le ve l s i gn al s. Whe n c on ne c ti ng a ba l an ce d signal, be sure it’ s wired per AES (Audio Engineering Society) standards: XLR Pin 1 – Shield (Ground) Pin 2 – Hot (+) Pin3–Cold(–) T[...]

Acoustic P erformance Frequency Response (–10 dB): 36 Hz – 145 Hz Frequency Response (–3 dB): 43 Hz – 92 Hz Max peak SPL (calculated) 1 : 131 dB Max peak SPL (measured) 2 : 126 dB T ransducer Diameter: 15.0 in / 381 mm V oice Coil Diameter: 3.0 in / 76 mm Diaphragm Material: Paper Magnet Material: Ferrite P ower Amplier Rated Power: 600 [...]

Correct disposal of this product. This symbol indicates that this product should not be disposed of with your household waste, according to the WEEE Directive (2002/96/EC) and your national law . This product should be handed over to an authorized collection site for recycling waste electrical and electronic equipment (EEE). Improper handling of th[...]

LEVEL + 6d B 6 dB - Input XLRs High Pass Output XLRs F ull Range Output XLRs Crossove r Signal / Limit LED Thermal LED Polarity In ve rt LED LPF 100 Hz Ov erex cursion Pr otection HPF 45 Hz Thermal Monitoring Am p Limiter Polarity In ve rt Thermal Mute Normal In ve rt ed Gain HD Subwoof er Pr ocessing Crossove r HPF 100 Hz Crossove r HPF 100 Hz 16 [...]

Mackie Limited W arranty Please keep your sales receipt in a safe place. This Limited Product W arranty (“Product W arranty”) is provided by LOUD T echnologies Inc. (“LOUD”) and is applicable to products purchased in the United States or Canada through a LOUD-authorized reseller or dealer . The Product W arranty will not extend to anyone ot[...]

16220 W ood-Red Road NE • Woodinville, W A 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and S outh America: 425.487 .4333 Middle East and Africa: 31.20.654.4000 F ax: 425.487 .4337 • www .mackie.com E -mail: sales@mackie.com RE VI S IO N SE RI A L NU MB E R WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO[...]