Memorex MX5310 инструкция обслуживания

E-1 MINI SYSTEM STEREO AM/FM 3 CD CHANGER WITH DUAL CASSETTE RECORDER MODEL: MX5310 BEFORE OPERATING THIS PRODUCT, PLEASE READ THESE INSTRUCTIONS COMPLETELY Memorex.p65 11/8/01, 11:11 AM 1[...]

E-2 WARNING: To reduce the risk of fire or electric shock, do not expose it is appliance to rain or moisture. CAUTION: Use of controls or adjustments or performance of procedures other than those specificed may result in hazardous radiation exposure. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN To reduce the risk of electric shock, do not remove cove[...]

E-3 IMPORTANT SAFEGUARDS CAUTION : • Read all of these instructions. • Save these instructions for later use. • Follow all warnings and instructions marked on the audio equipment. 1. READ INSTRUCTIONS All the safety and operating instructions should be read before the product is operated. 2. RETAIN INSTRUCTIONS The safety and operating instru[...]

E-4 15. OUTDOOR ANTENNA GROUNDING If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electrical Code, ANSI/NFPA 70 provides information with respect to proper grounding of the mast and supporting s[...]

E-5 CAUTION! THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. CAUTION! DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT IN CABINET OR IN [...]

E-6 LOCATION OF CONTROLS 1. CD Door 2. Disc skip button 3. Disc number button 4. CD Open / Close button 5. CD stop button 6. CD Play / Pause button 7. Remote sensor 8. Standby indicator 9. Display 10. Power button 11. Clock adjust button 12. Volume control 13. Headphone jack 14. Sleep button 15. CD button 16. Tuner button 17. Band button 18. Remain[...]

E-7 LISTENING TO THE RADIO Manual tuning 1. Press the TUNER button to select tuner mode. 2. Press the BAND SELECT button to the desired band. a) For FM Stereo reception: The unit provides FM MONO / STEREO selector (combined with Beat Cut selector). In Stereo mode, the unit will automatically switch to stereo when an FM stereo broadcast is received [...]

E-8 TO INTERRUPT PLAYBACK: 1. Press the PLAY / PAUSE button. • “ “ will appear. 2. Press the PLAY / PAUSE button to resume playback from the same point. TO STOP PLAYBACK: Press the STOP button. TO REMOVE THE CDs: Whilst in the stop mode, press the OPEN / CLOSE button. • The disc tray will open. Remove the two discs. Then press the DISC SKIP[...]

E-9 PROGRAMME PLAYBACK Use this function to programme the CD player to playback tracks in the order that you like. Up to 20 tracks can be programmed. Programme play is operated with the remote control or cabinet. 1. Press the PROG button If a disc(s) has already been loaded, the CD player will go directly to the programming mode and the “PROG” [...]

E-10 INSERTION AND REMOVAL OF CASSETTE – Press Stop / Eject Key to open the cassette door. – Put your cassette tape down the holder properly, with the exposed section Downward and the playback side facing you. – Close the cassette door securely before starting. – When finished press Stop / Eject Key to open the cassette door and retrieve yo[...]

E-11 CLOCK SETTING • Press the CLOCK set button twice. – The hours start flashing. • Press the TUNING Button ( or ) to adjust the hours. • Press the CLOCK Set button again. – The Minutes start flashing. • Press the TUNING Button ( or ) to adjust the minutes. • Press the CLOCK Set button or wait a few seconds and the clock will start r[...]

E-12 SLEEP TIMER The sleep timer is a countdown timer for switching the system to standby mode after a specified time. It enables you to listen to the radio, a CD or a cassette prior to falling asleep. The sleep timer can be set from 120 to 15 minutes. • Switch on the system by pressing the STANDBY (power) button, either on the system or on the r[...]

E-13 REMOTE CONTROL TRANSMITTER CONTROL FUNCTIONS BATTERY INSTALLATION The infrared transmitter requires 3.0 volts for operation. BUTTON DESCRIPTION 1. POWER button – To switch the unit to standby mode. 2. Function Mode CD – Press to select CD mode. TAPE – Press to select TAPE mode. TUNER (BAND) – Press to select TUNER mode and select the d[...]

E-14 SYMPTOMS POSSIBLE CAUSES POSSIBLE SOLUTIONS CD PLAYER CD PL AYER WILL NOT OPERATE F UN CT I ON SELECTOR SWITCH NOT SET TO CD POSITION SET FUNCTION SELECTOR SWITCH TO CD POSITION. CD NO T INSTALLED OR INSTALLED UPSIDE DOWN. INSERT CD WITH LABEL S I DE U P. CD SKIP WHILE PLA YING. D ISC IS D I RTY O R SCRATCHED. WIPE DISC WITH A SOFT CLOTH OR TR[...]

E-15 LIMITED WARRANTY AUDIO/PHONES We at MEMOREX believe you will be pleased with your new Product. Please read this Warranty carefully. Memorex warrants this product to be free from manufacturing defects including original parts and workmanship for a period of ninety (90) days from the date of original purchase in, and if used in, the United State[...]

Memcorp, Inc. Weston, Fl Printed in Hong Kong Visit our website at www .memcorpinc.com MPD8845.O/M.QXD 6/25/02 11:55 AM Page 23[...]