Miele K 12820 SD инструкция обслуживания

Operating and installation instructions Refrigerator with Dynamic cooling K 12620 SD K 12820 SD To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 680 150 e n-G B[...]

Guide to the appliance .............................................4 Caring for the environment ..........................................6 Warning and Safety instructions .....................................7 How to save energy ...............................................1 2 Switching on and off ..............................................1[...]

Installation ......................................................3 0 Side-by-side installation .............................................3 0 Location .........................................................3 0 Climate range ..................................................3 0 Ventilation ......................................................[...]

a On/Off button b Temperature selector button c Temperature display d Super cool button and indicator light e Dynamic cooling button and indicator light Guide to the appliance 4[...]

a Dynamic cooling fan b Butter and cheese compartment c Egg tray d Adjustable shelves e Bottle rack f Bottle shelf g Condensate channel and drain hole h Bottle divider* i Fruit and vegetable containers * * Depending on model Guide to the appliance 5[...]

Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation! Rather than just thro[...]

This appliance complies with all relevant local and national safety requirements. Improper use can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time. They contain importa[...]

Technical safety ~ Before setting up the appliance, check it for any externally visible damage. Do not install and use a damaged appliance. A damaged appliance is dangerous. ~ If the connection cable is faulty it must only be replaced by a service technician authorised by the manufacturer to protect the user from danger. ~ This appliance contains t[...]

~ The electrical safety of this appliance can only be guaranteed when continuity is complete between it and an effective earthing system which complies with current local and national safety regulations. It is most important that this basic safety requirement is present and tested regularly, and where there is any doubt, the household wiring system[...]

Correct use ~ Never store explosive materials in the appliance or any products containing propellants (e.g. spray cans). Thermostats switching on may produce sparks which could present a fire hazard. Flammable compounds could explode. ~ Do not operate any electrical equipment (e.g. an electric ice-cream maker) inside the appliance. Danger of sparki[...]

Disposal of your old appliance ~ Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. ~ Be careful not to damage any part of the pipework whilst awaiting disposal, e.g. by – puncturing the refrigerant channels in th[...]

Normal energy consumption Increased energy consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source (radiator, oven). Situated near to a heat source (radiator, oven). Where the ideal ambient room temperature is approx. 20°C. Where t[...]

Before using for the first time The stainless steel trim to the interior shelves and the door shelves has a layer of protective foil to prevent damage during transportation. Please remove this carefully after installation. ^ Clean the inside of the appliance and the accessories with lukewarm water and a little washing-up liquid, and then dry with a[...]

It is very important to set the correct temperature for storing food in the appliance. Micro-organisms will cause food which is not stored at the correct temperature to deteriorate rapidly. Temperature influences the growth rate of these micro-organisms. Reducing the temperature reduces their growth rate. The temperature in the appliance will rise:[...]

Super cool The Super cool function can be used to rapidly reduce the temperature in the refrigerator section to its lowest setting (depending on the room temperature). Switching on Super cool Super cool is particularly recommended for faster chilling of large amounts of fresh food or drink. ^ Press the Super cool button. The Super cool indicator li[...]

Switching off Dynamic cooling ^ Press the Dynamic cooling button m . The Dynamic cooling indicator light will go out. The fan automatically switches off when the door is open. Super cool and Dynamic cooling 16[...]

Different storage zones Due to the natural circulation of the air in the appliance, there are different temperature zones in the refrigerator. Cold, heavy air sinks to the lowest section of the appliance. Make use of the different zones when placing food in the appliance. This appliance has Dynamic cooling, which helps to keep an even temperature w[...]

Food which should not be stored in a refrigerator Not all food is suitable for refrigeration, as some food is sensitive to cold. Cucumbers, for example, become glassy, aubergines bitter and potatoes sweet. Tomatoes and oranges lose their aroma, and the peel on citrus fruit hardens. Food which should not be stored in a refrigerator includes: – pin[...]

– Examples of fruit and vegetables which react strongly to the natural gases given off by other types of fruit and vegetables are: Kiwis, broccoli, cauliflower, brussels sprouts, mangos, honeydew melons, apples, apricots, cucumbers, tomatoes, pears, nectarines and peaches. Example : Broccoli should not be stored with apples, as apples produce a l[...]

Moving the shelves The shelves can be adjusted according to the height of the food. ^ Raise the shelf, and pull it forwards slightly until the notch at the side is in line with the shelf support. It can then be raised or lowered to the required level. The raised edge at the back must face upwards to prevent food from touching the back of the applia[...]

Fruit and vegetable containers The fruit and vegetable containers are pushed in and out on telescopic runners, and can be completely removed if necessary. ^ Pull the container right out and then lift it up and off. Push the runners back in again to avoid injury or damage. To replace a container, ^ place it back on the fully extended runners a . The[...]

The refrigerator defrosts automatically. Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. You do not need to remove this, as it will defrost and evaporate automatically with the warmth generated by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the [...]

^ A range of Miele cleaning and conditioning agents is available from the Miele UK Spare Parts Department, or via the internet at www.miele-shop.com. Never use cleaning agents containing abrasive substances such as sand, soda, acids or chemical solvents. "Non-abrasive" cleaning agents are also unsuitable as they can cause matt areas to ap[...]

Metal grille at the back of the appliance The metal grille at the back of the appliance (heat exchanger) should be dusted at least once a year. A build-up of dust will increase the energy consumption of the appliance. When cleaning the grille, make sure that the pipework and other components do not get broken or damaged in any way. After cleaning ^[...]

Repairs to electrical appliances should only be carried out by a suitably qualified and competent person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work. What to do i f... . . . the appliance does n[...]

^ Unscrew the lamp b and replace it with a new one. Lamp specification: 220 - 240 V, E 14 fitting See the old lamp for the Wattage required. ^ Replace the lamp cover a . . . . the floor of the refrigerator is wet. The drain hole is blocked. ^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these sug[...]

Normal noises What causes them Brrrrr... Humming noise made by the motor (compressor). This noise can get louder for brief periods when the motor is switching on. Blubb, blubb.... A gurgling noise can be heard when coolant is circulating through the pipes. Click.... Clicking sounds are made when the thermostat switches the motor on and off. Sssrrrr[...]

In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer or – Miele (see back cover for contact details). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. This information is given on the data plate inside your applianc[...]

Electrical connection U.K. All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current local and national safety regulations (BS 7671 in the UK). The appliance is supplied with a mains cable and moulded plug ready for connection to an a.c. single phase 220-240 V 50 Hz supply. Please ensur[...]

Do not place any appliance which gives off heat, such as a toaster or microwave oven, on top of this appliance, as this would increase the appliance's energy consumption. Side-by-side installation To avoid a build-up of condensation and resultant damage, refrigerators and freezers should not generally be installed side-by-side next to each oth[...]

Ventilation Air at the back of the appliance gets warm. To ensure sufficient ventilation, the ventilation gaps must not be covered over. The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. Installation ^ Remove the cable clip from the back of the appliance. ^ Check that all parts at the back[...]

Appliance dimensions ABC K 12620 SD 1650 mm 600 mm 630 mm K 12820 SD 1850 mm 600 mm 630 mm Installation 32[...]

The appliance is supplied right hand hinged. If left hand door hinging is required, follow the instructions below. To change the door hinging you will need the following tools : – a cross-slotted screwdriver, – a flat-bladed screwdriver, – a selection of Torx screwdrivers, – a spanner. Two people are needed for changing the door hinging. Re[...]

Changing over the door Make sure the door shelves are empty! ^ Close the appliance door. ^ Remove cover a by sliding it forwards from the back and then lifting it off. ^ Remove cover b by pulling it upwards. Caution. The appliance door is not secure once the hinge plate has been removed. ^ Loosen screws d in upper hinge plate c and pull it upwards [...]

^ Remove cover a by pulling it forwards. ^ With the help of another person, carefully tilt the appliance backwards and pull hinge pin b out. ^ Do not lose hinge bush c . ^ Undo screws d and take hinge plate e off. ^ Remove cover f and fit it into the holes on the opposite side. ^ Unscrew bearing g from hinge plate e and screw it into the hole on th[...]

^ Fit hinge plate c onto the opposite side and secure it with screws d . If necessary drill pilot holes for the screws or use a battery operated screwdriver. ^ Fit covers a and b to their opposite sides. ^ Align the door with the appliance housing using the long slot in the lower hinge plate. Then tighten the screws. Refitting the handle Please mak[...]

It is important to check that the side section of the handle d does not come into contact with the door seal when opening the door, as this would damage the door seal permanently. If, after you have refitted the handle, you find that the side section does touch the door seal when the door is opened: ^ Realign mounting plate c with grub screws a unt[...]

The appliance door can be aligned to the housing using the outer long slots in the lower hinge plate. In the following illustration the door is not shown in the closed position to make it easier to see what happens next. ^ Remove centre screw a from the hinge plate. ^ Slightly loosen both outer screws b . ^ Align the door by sliding the hinge plate[...]

a Top box b Appliance c Housing unit d Wall The appliance can be installed in a kitchen run. To match the height of the rest of the kitchen, the appliance can be fitted with a suitable top box a . A ventilation gap of at least 50 mm depth must be allowed for behind the appliance across the entire width of the top box for air to circulate. The cross[...]

Alteration rights reserved / 3309 K 12620 SD, K 12820 SD M.-Nr. 07 680 150 / 00[...]