MTD 500 Thru 509 инструкция обслуживания

22” Rotary Mowers Model Series 500 Thru 509[...]

2 TABLE OF CONTENTS FINDING MODEL NUMBER This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best perform ance. Plea se read and understand what it sa ys. Before you start as sembling your new equipment , please locate the model plate on th e equipment and copy the infor[...]

3 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety an d/or property of yourself and ot hers. Read and follow all instructions in this manual before attempting to operate this ma chine. Failure to comply with these instructions may r[...]

4 18. If the equipment should start to vibrate abnormally, stop the engine and check imm ediately for the cause. Vibration is genera lly a warning of trouble. 19. Shut the engine off and wait until the blade comes to a complete stop before removing the grass catcher or unclogging the chute. The cutting b lade continues to rotate for a few seconds a[...]

5 General Service: 1. Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 2. Before cleaning, repa iring, or inspecting, make certain the blade and all mo ving parts have stopped. Disconnect the spark plug wire an d ground against the eng ine to prevent unintended sta rtin[...]

6 SECTION 2: SLOPE GAUGE Use this page as a guide to determi ne slopes where you may not operate safely. Do not operate your lawn mower on such sl opes. 15° SIGHT AND HOLD THIS LEVEL WITH A VERTI CAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST F O L D O N D O T T E D L I N E , R E P R E S E N T I N G A 1 5 ° S L O P E WARNING Do not [...]

7 SECTION 3: ASSEMBLING YOUR LAWN MOWER IMPORT ANT : This unit is shipped wit hout gasoline or oil in the engine. Be cer tain to service engine wi th gasoline and oil as instructed in th e separate engine manual before op erating y our mower. NOTE: Reference to right or left hand side of the mower is observed from the operatin g position. Removing [...]

8 Installing Front Wheels • Place the front of the mower deck on raised blocks. • Remove lock nut from pivot arm assembly, slide wheel onto pivot arm assemb ly and secure with lock nut. See Figure 6. • Assemble the other sid e in the same manner. • If your mower is equipped with hub caps, place hub caps in position against the inner hub of [...]

9 IMPORT ANT : This unit is shipped without gasoline or oil in the engine. Be cer tain to service engine wi th gasoline and oil as instructed in the separate engine manual before operating your mower. SECTION 4: KNOW YOUR LAWN MOWER Read this operator ’s manual and safe ty rules before operating your lawn mower. Compar e the illustration in Figur[...]

10 • Your lawn mower may be equipped with a constant speed throttle, which is set at full throttle f or best performance. • Stand behind the mower and squeeze the bla de control handle against the uppe r handle. • Grasp recoil start er handle and pull rope out slowly until engine reache s the start of compression cycle (rope will pull slightl[...]

11 SECTION 7: MAINTAINING YOUR LAWN MOWER General Recommendations • Always observe safety rules when performing any maintenance. • The warranty on this lawn mower does not cover items that have been subjected to operato r abuse or negligence. To receive full value from the warranty, operator must maintain the lawn mower as instructed in this ma[...]

12 Maintenance NOTE: When tipping the unit or emptying the fuel tank keep the air cleaner side of engine u p. Never tip the mower more than 90 deg rees and do not leave the mower tipped for any length of time . Oil can d rain into the upper part of the engine causing a star ting problem. Engine Care A list of key maintenance jobs, re quired for goo[...]

13 SECTION 8: TROUBLESHOOTING Prob lem Cause Remedy Engine fails to start 1. Blade control h andle disengaged. 2. Spark plug wire disconnected. 3. Fuel tank empty or stale fuel. 4. Blocked fuel line. 5. Faulty spar k plug. 6. Engine flood ed 1. Engage blade contro l handle. 2. Connect wire to spark plug. 3. Fill tank with clean, fresh gasoline. 4. [...]

14[...]

15 Model Series 500 thru 509 Ref. No. P art No. P art Description 1. 747-1161A Blade Control Handle 2. 749-1092A Upper Handle 3. 746-0957 Blade Control Cable - B&S 37.25” 746-1130 Blade Control Cable - B&S 40” 746-0946 Blade Control Cable - Tec 48.25” 4. 710-1205 Eye Bolt 5. 720-0279 Wing Nut 6. 720-0284 Wing Nut 7. 736-0451 Shoulder [...]

MANUF A CTURER’S LIMITED W ARRANTY FOR: The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its possessions and te rritories. “MTD”warrants this product against defects in material and workmanship for a period of two (2) years commen cing on the date of original pur[...]