Napoleon GVF36N инструкция обслуживания

1 W415-0297 / D / 04.03.03 CERTIFIED UNDER AMERICAN NA TIONAL ST ANDARDS, ANSI Z21.11.2, VOL UME II FOR UNVENTED ROOM HEA TERS. UNVENTED MILLIVOL T SYSTEM INST ALLA TION AND OPERA TION INSTRUCTIONS FOR UNVENTED GAS FIREPLACE NA TURAL GAS MODEL GVF36N PROP ANE GAS MODEL GVF36P CERTIFIED FOR UNITED ST A TES USING ANSI METHODS W ARNING: If the informa[...]

2 W415-0297 / D / 04.03.03 WARNING • • Under no circumstances should this heater be modified. • Pr ovide adequate ventila tion and combustion air . Pro vide adequate accessibility c learance f servicing and oper ating the heater . Nev er obstruct the fr ont opening of the heater . • If hea ter shuts of f, do not r e-light until you pr ovide[...]

3 W415-0297 / D / 04.03.03 NAPOLEON gas fireplaces are manufactured under the strict Standard of the world recognized ISO 9001 : 2000 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work. The burner and valve assembly are leak and test[...]

4 W415-0297 / D / 04.03.03 THIS GAS FIREPLACE SHOULD BE INST ALLED AND SERVICED BY A QUALIFIED INST ALLER to conform with local codes. Installation practices vary from region to re- gion and it is important to know the specifics that apply to your area, for example: in Massachusetts State: • The fireplace damper must be removed or welded in the o[...]

5 W415-0297 / D / 04.03.03 ROOM 2 ROOM 1 This heater shall not be installed in a confined space or unusually tight construction unless provisions are pro- vided for adequa te combustion and ventila tion air . In order to avoid the possibility of exposed insulation or vapour barrier coming in contact with the fireplace body , it is r ecommended tha [...]

6 W415-0297 / D / 04.03.03 1. Move the fireplace into position and secure using the nailing tabs and/or secure to the floor through the ¼"ø holes located at either end of the base. 2. Install rigid black pipe, 1/2" type-L copper tubing or , if local codes permit, a 3/8" flex connector and shutoff valve to the gas line and the firep[...]

7 W415-0297 / D / 04.03.03 NAILING TA B T o install the fireplace face flush with the finished wall, position the framework to accommodate the thick- ness of the finished wall. Bend out the four nailing tabs, attached on either side of the fireplace and secure to the 2x4 framing. The tabs will facilitate the installation of either a 3 / 4 " or[...]

8 W415-0297 / D / 04.03.03 The curtain mesh must be kept fully closed during opera- tion to help prevent accidental burns from occurring. The heater must not be used when the hood is removed. Hook the hood over the lip of the curtain sup- port plate. HOOD CURT AIN MESH FIGURE 1 1 Remove the backing of the logo supplied and place on the screen cover[...]

9 W415-0297 / D / 04.03.03 PHAZER TM logs and glowing embers exclusive to Napoleon Fireplaces, provide a unique and realistic glowing effect that is different in every inst allation. T ake the time to care- fully position the glowing embers for a maximum glowing effect. Log colours may vary . During the initial use of the fire- place, the colours w[...]

10 W415-0297 / D / 04.03.03 UPPER L OUVRES: In- sert the upper louvres into the slots on both brackets. Press the top flange of the hood into the four clips located along the top of the unit as shown. L OWER LOUVRES: At- tach each hinge to the fire- bo x with 2 screws. HINGE SCREEN: Position the hinge screen into place and with the control door ope[...]

11 W415-0297 / D / 04.03.03 NO TE : ORNAMENT AL INSETS CAN NOT BE USED IN CONJUNCTION WITH THE CA T AL YTIC DOOR This unique patented catalytic system was designed to provide unparalleled safety and peace of mind. The top of the door contains four catalytic tiles which are designed to filter out combustion gases and limit the carbon monox- ide outp[...]

12 W415-0297 / D / 04.03.03 Attach the connectors from the black and red wires to the blower . Attach and secure the variable speed switch using the nut pro- vided. Plug the harness cord into the receptacle. The wire harness provided in this kit is a univer- sal harness . When installed, ensure tha t any ex- cess wire is contained, preventing it fr[...]

13 W415-0297 / D / 04.03.03 FIGURE 27 This optional kit is meant to be used only in conjunction with the GD65 Fan Kit, which may be ordered from your Wolf Steel /Napoleon dealer. With the thermostatic sensor option, the fan, when turned on, becomes thermally activated, and will automatically run approximately 10 minutes after the fireplace has been[...]

14 W415-0297 / D / 04.03.03 P I N O L O T F F O When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob is depressed. 1. STOP! Read the above safety information on this la- bel. 2. Set the thermostat to lowest setting. 3. Turn off all electric power to the fireplace. 4. Open the control door . T urn the gas kn[...]

15 W415-0297 / D / 04.03.03 This procedure must be performed by a qualified service person! Inspect the pilot for any visible contamination or debris (usually lint, pet hair , spider webs, carpet fibre, etc.) and remove. Disconnect the pilot from the pilot tubing line. Using a 7 / 16 ” wrench, remove the injector from the pilot housing. Blow out [...]

16 W415-0297 / D / 04.03.03 Contact your dealer or the factory for questions concerning prices and policies on replacement parts. Normally all parts can be ordered through your Napoleon dealer or distribu- tor . When ordering replacement parts always give the follow- ing information: 1. M ODEL & S ERIAL N UMBER OF FIREPLACE 2. I NST ALLA TION D[...]

17 W415-0297 / D / 04.03.03[...]

18 W415-0297 / D / 04.03.03 Main burner goes out; pilot stays on. Pilot flame is not large enough or not engulfing the thermopile - service or replace Oxygen Depletion Sensor System - correct piping and/or regulator to provide correct pressure Thermopile shorting - clean thermopile connection to the valve. Reconnect. - replace Oxygen Depletion Sens[...]

19 W415-0297 / D / 04.03.03 Pilot goes out while standing; Main burner is in 'OFF' position. Gas piping is undersized. - turn on all gas appliances and see if pilot flame flutters, dimin- ishes or extinguishes, especially when main burner ignites. Monitor appliance supply working pressure. - check if supply piping size is to code. Correct[...]

20 W415-0297 / D / 04.03.03 Wolf Steel Fir eplace Ser vice Histor y This fireplace must be serviced annually depending on usage. Date Service T echnician Name Service Performed Special Concerns Dealer Name[...]