NEC RWC-3217 инструкция обслуживания

Thank you very much for purchasing A ir Conditioner. Before please read this User carefully , and keep it for future reference. installing and using this appliance, Manual SWING SWING OFF ON / MODE TIMER FAN SPEED F HR Window (Room) Air Conditioner User Manual RWC-3217 RWC-4717[...]

2 3 CONTENTS Safety Precautions Operating Instructions Parts Name Care and Maintenance 5 8 Trouble Shooting Installation Instructions 10 11 Operation Tips 9 1[...]

S W I N G S W I N G OF F ON / M O D E T I M E R F A N S P E E D F F HR HR 2 Symbols in this User's Manual are interpreted as shown below: Be sure not to do. The feature of the appliance, instead of a fault. Pay attention to such a situation. Grounding is necessary. Be sure to follow the instruction. Do not use the power supply circuit breaker [...]

ÅÅË®×ì Note: The figure in this manual are based on the external view of a standard model. Consequently , the shape may dif fer from that of the air conditioner you have selected. Air Outlet Fig. 1 Control Panel Power Cord Interior Air Inlet Grille Horizontal Air Vane Vertical Air Vane Front view Fresh air lever Exterior Air Inlet Exterior Ai[...]

Air Filter handle Fresh air lever S W I N G S W I N G OFF ON / M O D E T I M E R F A N S P E E D F F HR HR Shut the fresh air door to achieve the best cooling effect and open it to introduce fresh air into the room if the air is foul inside . Fresh air lever SHUT OPEN Fresh air lever Pull out Push in Fig.1 Fig.2 ÅÅË®×ì Outside Air Outlet Drai[...]

MODE button Each time MODE button is pressed, the operation mode is changed in sequence: COOLING FAN ONL Y ENERGY SAVING COOLING NOTE: After setting the mode, allow 3 minutes before switching to another mode. NOTE: T emperature setting range is from 19 (66 ) to 31 (88 ). FAN SPEED button Used to select fan speed in sequence auto, low, medium and hi[...]

Power Mode + _ Te mp/T ime Auto Power Saver Mid High Low Time r Fan Speed The remote controller transmits signals to the system. 1 1 2 3 8 2 3 5 6 8 Buttoms POWER Buttom MODE Buttom TIMER Buttom The appliance will start when it is energized or will stop when it is in operation, if you press this button. Used to select the operation mode. Used to se[...]

Remote control How to Insert the Batteries Remove the battery cover according to the arrow direction. Insert new batteries making sure that the (+) and (-) of battery are matched correctly. Reattach the cover by sliding it back into position. Note: Use 2 LR6 AA(1.5volt) batteries. Do not use rechargeable batteries. Re- place batteries with new ones[...]

8 Unplug from power source Front panel maintenance Air filter maintenance T ake out air filter as shown Stop operation and take out air filter. Wipe with a soft and dry cloth Use lukewarm water (below 40 C) to clean if the air conditioner is very dirty. Unplug from power source after switch off the air conditioner. Never use volatile substance such[...]

9 Noise pollution Operating condition The protective device maybe trip and stop the appliance in the cases listed below. The noise level of air conditioner sounds higher at night than in the daytime. Please set (LOW FAN SPEED) or (FAN ONL Y) mode at night in order to decrease noise. COOLING o Outdoor air temperature is over *43 c o Room temperature[...]

10 Is the air filter dirty? Are the intakes and outlets of the air conditioner blocked Is the temperature set properly Is the fresh air lever shut off Is the door or windows closed If the protector trip or fuse is blown. If the plug is not properly plugged. If batteries in the remote controller exhausted. Please wait for 3 minutes and start again, [...]

Installation Instructions 11 1.Accessories Installation accessories RWC-3217 20 10 5 3 2 40 550 15 3 7 5 50 600 454 1. buffer 2.leveling pad 3. seal foam pad 4. decorating strip 20 10 5 3 2 40 700 15 4 68 50 750 550 1. Buffer 2.leveling pad 3. seal foam pad 4. decorating strip RWC-4717 Note: All mentioned accessories are prepared or purchased by us[...]

1.Accessories 2. Installation requirements Leave a space more than 100 cm at the rear of the appliance and ensure the outdoor air intake not be blocked. A wooden frame as shown in fig.1 is advisable if the appliance is installed through a window . The installation bracket as shown in fig.2 should not be welded with the window sash. The metallic ins[...]

13 T est the appliance by plugging the power supply cord in a correct outlet of power source before installation. A clearance of 20 mm is advisable between the appliance cabinet and the wall. Fix the indoor air intake panel with the cabinet by employing two screws which packed in the packing bag as shown in Fig.5. Put the buffers on the installatio[...]

Version No 819043161-01 . NEC Australia Pty . Ltd ABN 86 001 217 527 Home Electronics Group NEC Service Centres NEW South Wales Sydney 184 Milperra Rd, Revesby 2212 (02) 9780 8688 Newcastle 120 Parry Street, Newcastle 2302 (02) 4926 2466 Victoria Melborne 480 Princes Highway, Noble Park 3174 (03) 9554 6245 Queensland Brisbane 116 Ipswich Rd, Woollo[...]