Olympus PT-022 инструкция обслуживания

For the digital camera CAMEDIA C-760 Ultra Zoom/ C-770 Ultra Zoom ■ Thank you for buying the Underwater Case PT-022. ■ Please read this instruction manual carefully and use the product safely and correctly. Please keep this instruction manual for reference after reading it. ■ Wrong use may cause damage to the camera on the inside from water l[...]

E-1 Introduction ● Unauthorized copying of this manual in part or in full, except for private use, is prohibited. Unauthorized reproduction is strictly prohibited. ● OLYMPUS CORPORATION shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from unsuitable use of this product. ● OLY[...]

E-2 1. Keep this product out of the reach of babies, infants, and children. There is the possibility of occurrence of the following types of accidents.  Injury by dropping onto the body from a height.  Injury from parts of the body getting caught in parts which open and close.  Swallowing of small parts. Please consult a physician immediat[...]

E-3 Batteries ● Always use lithium ion battery packs manufactured by Olympus and bearing the Olympus brand. For more details, refer to your camera's instruction manual. ● Take care that the battery electrodes do not become wet. This may cause trouble or accidents. ● Carefully read the instruction manual for the camera about other caution[...]

When water leakage occurs while this product is being used, repair of the camera housed in this product may become impossible. Please observe the following cautions for use. 1. When sealing this product, make sure that no hairs, fibers, sand particles or other foreign matter stick not only to the O-ring, but also to the contact surface (flat part o[...]

E-5 Handling the Product ● Use or storage of the product at the following locations may cause defective operation, defects, trouble, damage, fire, internal clouding, or water leakage. Always avoid these locations.  Locations reaching high temperatures such as those under direct sunlight, in an automobile, etc.  Locations with open fire  [...]

E-6 ● Do not perform operations other than specified in this instruction manual, do not remove or modify parts other than specified, and do not use parts other than specified. Any troubles in taking pictures or with the equipment resulting from the above actions shall be outside the guarantee. ● OLYMPUS CORPORATION shall be in no way responsibl[...]

E-7 Introduction ................................................................................E-1 Please read the following items before use ..............................E-1 For safe use ..............................................................................E-1 Batteries ...................................................................[...]

E-8 Check the loading status. ........................................................E-22 Seal the Case. ........................................................................E-22 Install the special balance weight. ..........................................E-22 Installation and Removal of the LCD Hood ..............................E-23 Installa[...]

E-9 1. Preparations Check the contents of the package. Check that all accessories are in the box. Contact your dealer if accessories should be missing or damaged. 取扱説明書 デジタルカメラ CAMEDIA C-760 Ultra Zoom／ C-770 Ultra Zoom用 ■このたびは、防水プロテクタ PT-022をお買上 げいただき、あり がとうご ?[...]

E-10 Names of the parts Note : The Case operation parts marked by ❈ corresponds to the operation parts of the digital camera. When the operation parts of the Case are operated, the corresponding functions of the digital camera will operate. For details of the functions, refer to the instruction manual for the digital camera. 澹  澡  ①?[...]

E-11 Install the strap. Install the strap on the Case body. : Please install the strap correctly as shown above. OLYMPUS CORPORATION shall bear no responsibility for damage etc. caused by dropping the Case because of incorrect installation of the strap. CA UTION :• Do not exert excessive force onto the lens window or the lens ring. • Take care [...]

E-12 How to Press the Shutter When pressing the shutter lever, press it gently, so that there will be no movement of the camera. Note: • For detailed operation of the shutter, refer to the instruction manual for the digital camera. How to Use the Zoom Lever Zoom operation is possible by operating the zoom lever of this Case corresponding to the z[...]

E-13 Setting the Zoom Lever When loading the digital camera in the Case, fit the projecting part of the zoom lever of the digital camera into the recessed part of the zoom lever on the inside of the Case. How to switch the power ON The method of turning this product ON is variable depending on the camera in use (C-760 Ultra Zoom/C-770 Ultra Zoom). [...]

E-14 Note: • When the set time (initial setting: 3 minutes) passes without any operation while the digital camera is installed in shooting mode, the camera enters into sleep mode (standby status) and the operation stops. To cancel sleep mode (return to operation status), press the shutter button or any other button. For details, refer to the inst[...]

E-15 Note: • For details about using the flash for taking pictures, refer to the instruction manual for the camera. Flash operation procedure Press the flash button to raise the flash out of the camera. Moving the flash storage button again to store the flash inside the camera. PT_022_E.qxd 2004.3.18 4:34 PM ページ E-15[...]

E-16 Removing the TLL cable connector cap T TL flash shooting by combining this case (PT-022) and the case for FL-20 flash (optional PFL-01): TTL cable connector cap T urn counter clockwise . Remov e. Underwater TTL cable Inser t into the connector . T urn the threaded section of the connector clockwise lightly until it is stopped. 1 2 1 Remove the[...]

E-17 Removing the hot shoe cable cap To perform TTL flash shooting when this case is used, connect the hot shoe cable provided with the optional PFL-01 between the connector on this case and the C-770 Ultra Zoom's hot shoe. 1 Turn the hot shoe cable connector cap inside the case counterclockwise to remove it. 2 Insert the connector of the hot [...]

E-18 2. Adv ance Check of the Case Advance test before use This Case has been the subject of thorough quality control for the parts during the manufacturing process and thorough function inspections during the assembly. In addition, a water pressure test is performed with a water pressure tester for all products to confirm that the performance conf[...]

E-19 3. Install the digital camera. Check the digital camera. Check the digital camera before loading it in the Case. Battery Confirmation As the LCD monitor is used for picture confirmation while taking pictures under water, the battery life becomes short. Confirm that the remaining battery capacity is sufficient. Do not use alkaline batteries, as[...]

E-20 Check the operation of the camera. Confirm the operation according to the instruction manual for the digital camera. Load the digital camera. Open the Case. Insert the buckle opener of the accessory into the buckle opening lever as shown in the figure (in direction ) Pull the buckle opener slowly (in direction ). When not using the buckle open[...]

E-21 Insertion of silica gel P ay attention to the orientation. Before sealing the Case, insert the accessory silica gel bag for prevention of fogging between the bottom of the camera and the Case. Insert the bag with the glued longer side to the inside. : • Insert the silica gel all the way at the specified location and with the specified orient[...]

E-22 Install the special balance weight. Seal the Case. Check the loading status. : • Seal the Case by turning both buckle lock levers down in arrow direction. When one of the buckles is left open, the Case will not be sealed and water leakage will be caused. CA UTION When the rear lid is closed (quietly, so that the O-ring will not come out of t[...]

E-23 Installation and Removal of the LCD Hood Installation Strongly push the mounting projections of the LCD hood as shown in the figure into the guides above and below the LCD monitor window. Removal Remove the mounting projections of the LCD hood from the guides above and below the LCD monitor window by widening the LCD hood. Installation Remov a[...]

E-24 Perform the final checks. Visual Inspection After sealing the Case, check the sealing part of front and rear lid visually to confirm that the O-ring is not twisted or out of the groove and that no foreign matter has been caught. Fit the lens cap onto the lens ring as shown in the figure. Be sure to remove the lens cap before shooting. Mounting[...]

E-25 Now everything is all right! Have a nice dive! Did you remember to attach the balance weight? Final Test The final test after loading the camera is explained below. This is the only way to eliminate worry about possible entry of water! Always perform this test. It can be performed easily in a water tank or a bathtub. The required time is about[...]

E-26 4. T aking Pictures Under W ater How to Use the Hand Strap Pass your hand through the accessory hand strap and adjust the length with the stop button. Take pictures carefully. Confirm the picture on the LCD monitor. This Case uses the LCD monitor to confirm the picture. The viewfinder cannot be used. Quietly press the shutter lever. When press[...]

E-27 5. Handling After Shooting Wipe off any waterdrop. After completing the shooting and returning to land, wipe off any waterdrop sticking to the Case. Use air or a soft cloth not leaving any fibers to thoroughly wipe any waterdrop etc. from the joint between the front and rear lid, the shutter lever, the palm grips, and the buckles. Note : • M[...]

E-28 Take out the digital camera. Open the case carefully, pull up the mode dial from the upper surface of the case to disengage it from the mode lever of the camera, and then remove the digital camera from the case. : • Always place the opened Case with the O-ring side facing up. When the Case is placed with the O-ring side facing down, dirt or [...]

E-29 Wash the Case with pure water. After use, seal the Case again after taking out the camera and wash it sufficiently in pure water as soon as possible. After use in sea water, it is effective to immerse it for a fixed time in pure water to remove any salt. : • Water leakage may be caused when a high water pressure is applied locally. Before wa[...]

E-30 6. Maintaining the W aterproof Function Remove the O-ring. Open the Case and remove the O-ring from the Case. Removal of the O-ring  Insert the O-ring removal pick between the O-ring and the wall of the O-ring groove.  Move the tip of the inserted pick under the O-ring. (Take care not to damage the O-ring groove with the tip of the pick.[...]

E-31 : • When a mechanical pencil or a similar other sharp object is used to remove the O-ring or to clean the inside of the O-ring groove, the Case and the O-ring may be damaged and water leakage may be caused. • When the O-ring is checked with the fingertips, take care not to stretch the O-ring. • Never use alcohol, thinner, benzene or simi[...]

E-32 1 Install the O-ring. Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the O-ring, and fit the O-ring into the groove. At this time, confirm that the O-ring does not stick out from the groove. How to Apply Grease to the O-ring Apply the exclusive lubricant to each O-ring. Make sure that your fingers and [...]

E-33 Clean and apply O-ring silicon grease to these sections. Maintenance of the threaded sections on the TTL cable and TTL cable connector If the threaded sections used to connect the TTL cable to the TTL cable connector are not maintained properly, salt and other seawater residue may adhere the TTL cable and prevent it from being disconnected. Af[...]

E-34 Replace consumable products.  The O-ring is a consumable product. Independent of the number of times the Case is used, it is recommended that the O-ring should be replaced by a new one at least once a year.  Deterioration of the O-ring is accelerated by the use conditions and the storage conditions. Replace the O-ring even before a year [...]

E-35 7. Appendix Q & A on the use of the PT-022 Q1 : Which digital cameras can be used? A1 : The PT-022 is only for the models C-760 Ultra Zoom/C-770 Ultra Zoom. Q2 : What cautions must be observed when loading the digital camera into the Case? A2 : Pay special attention to the following items when loading the camera into the Case. (1) Check th[...]

E-36 (3) In case of the following handling with a camera loaded into the Case, trouble or breakage may be caused for the Case and/or the loaded camera. Always avoid such handling. (a) Hitting other objects (b) Dropping (c) Placing heavy objects on top of the Case (4) When the Case is not used for a long time, trouble from formation of mold etc. may[...]

E-37 dry them. When an object with a sharp tip is used to remove the O-ring from the groove, the O-ring may be damaged and water leakage may be caused. Always use the accessory pick for O-ring removal. Q6 : How should I take pictures under water? A6 : Please observe the following items for shooting under water. (1) Fix the case with the accessory h[...]

E-38 Q9 : What are the important points for O-ring maintenance? A9 : Please observe the following items. ( 1) Never use alcohol, thinner, benzene or similar organic solvents or chemical detergents to clean the O-ring. When such chemicals are used, it is to be feared that the O-ring will be damaged or that its deterioration will be accelerated. (2) [...]

E-39 Q11 : Please tell me about repairs. A11 : Please contact a service station of OLYMPUS CORPORATION or your dealer, if repair should be necessary. Do not try to repair, disassemble or modify the Case yourself. Repair, disassembly or modification by you or third parties not authorized by Olympus invalidates the guarantee. Q12 : What are the model[...]

E-40 After-sale Service ● You will receive the guarantee card from your dealer. Please make sure that the dealer's name, the date of purchase, etc. have been entered. If they have not been entered, immediately ask your dealer to have them entered. Read the guarantee conditions carefully and keep the guarantee card at a safe location. ● Ple[...]

E-41 Specifications ❈ We reserve the right to change the external appearance and the specifications without notice. Available models Olympus digital camera CAMEDIA C-760 Ultra Zoom/C-770 Ultra Zoom Pressure resistance Depth of up to 40 m Main materials Body: Transparent polycarbonate Buckles: Stainless steel Grip/Shutter lever: Red polycarbonate [...]

E-42 MEMO PT_022_E.qxd 2004.3.18 4:34 PM ページ E-42[...]