Panasonic SC-AK310 инструкция обслуживания

RQT6693-1P CD Stereo System Operating Instructions Model No. SC-AK310 SC-AK110 Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference. As an E NERGY S TAR ® Partner, Panasonic has determined that this product meets the E NERGY S TAR ® guidelines for energy ef[...]

Before using RQT6693 2 Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. These operating instructions are applicable to the following systems. These operating instructions, however, fundamentally explain the operation of system SC-AK310. System SC-AK310 SC-AK110 Main u[...]

Before using RQT6693 3 Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference. Selecting fine audio equipment such as the unit you’ve just pur- chased is only the start of your mu[...]

RQT6693 4 Batteries The remote contr ol Aim at the sensor, avoiding obstacles, at a maximum range of 7 meters directly in front of the unit. • Keep the transmission window and the unit’s sensor free from dust. • Operation can be affected by strong light sources, such as direct sunlight, and the glass doors on cabinets. Do not: • put heavy o[...]

Before using RQT6693 5 1 FM indoor antenna Adhesive tape Affix where reception is best. 2 AM loop antenna Stand the antenna up on its base. 4 A C power supply cor d Note The included AC po wer supply cord is for use with this unit only . Do not use it with other equipment. For your ref erence Information you enter into the unit’ s memory , except[...]

Before using RQT6693 6 1 AC supply indicator (AC IN) This indicator lights when the unit is connected to the AC power supply. 2 Standby/on switch ( f f f f f /I, POWER) Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still consuming a small amount of power. 3 Display 4 Remote control signal sensor ......[...]

RQT6693 Recording operations Cassette deck operations 7 The radio: manual tuning Preparation: Press [TUNER BAND] to select “FM” or “AM”. Automatic presetting Do the following once each for FM and AM. Preparation: Tune to the frequency where pre-setting is to begin. Hold down [PROGRAM] until the frequency changes. The tuner presets all the s[...]

RQT6693 Cassette deck operations 8 1 Press [ c , OPEN/CLOSE] to open the tray. The unit comes on. 2 Set a CD in the tray. (Label must face upward.) To continue loading CDs in the other trays Press [1] – [5] to select the required tray and press [ c , OPEN/ CLOSE] to open the tray. Press [ c , OPEN/CLOSE] to close the tray. 3 Press [1] – [5] to [...]

RQT6693 Recording operations Cassette deck operations 9 Starting play from a specific track Remote control only 1 Press [DISC] and (within 10 seconds) [1] – [5] to select the disc. 2 Select the track with the numbered buttons. To select track 10 or over, press [ X 10] then the two digits. Play starts from the selected track. Note You cannot use t[...]

RQT6693 Cassette deck operations 10 You can use either deck 1 or deck 2 for tape playback. Use normal position tapes. High position and metal position tapes can be played, but the unit will not be able to do full justice to the characteristics of these tapes. 1 Press [ : , TAPE]. The unit comes on. If a cassette was loaded, play starts automaticall[...]

Recording operations Cassette deck operations RQT6693 11 To stop recording Press [ L , STOP]. If the tape finishes before the CD The CD continues playing. Press [ L , STOP] to stop it. To record on the other side of the tape Turn the tape over and press [ a REC]. Reducing noise when recording AM Remote control only Hold down [PLAY MODE] while recor[...]

Timer operations RQT6693 12 A demonstration of the display is shown if you have not set the clock. You can reduce the power consumed in standby mode by turning it off. During standby mode Hold down [-DISP/–DEMO] until “NO DEMO” is displayed. Every time you hold down the button: NO DEMO (off) ↔ DEMO ON (on) To show a demonstration of the dis[...]

Timer operations RQT6693 Reference 13 To cancel the timer Press [ r PLAY/REC] to clear the timer indicator from the display. (The timer comes on at the set time everyday if the timer is on.) To change the settings (when the unit is on) To change the play/record times Do steps 1, 2, 3 and 5. To change the source or volume 1. Press [ r PLAY/REC] to c[...]

Reference RQT6693 14 T r oubleshooting guide Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem: In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail consumerproducts@panasonic.com, or web site (htt[...]

RQT6693 Reference 15 1. Damage requiring service —The unit should be serviced by qualified service personnel if: (a) The AC power supply cord or AC adaptor has been damaged; or (b)Objects or liquids have gotten into the unit; or (c) The unit has been exposed to rain; or (d) The unit does not operate normally or exhibits a marked change in perform[...]

16 Reference RQT6351 Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094 http://www.panasonic.com Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. (“PSC”) Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial Park, Carolina, Pue[...]