Pentair 710 инструкция обслуживания

IMPOR T ANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SA VE THESE INSTRUCTIONS Installation and User's Guide Prowler ™ 710 Robotic Inground Pool Cleaner[...]

© 2006 Pentair W ater Pool and Spa, Inc. All rights reserved. This document is subject to change without notice. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles A ve., Moorpark, CA 93021 • (805) 553-5000 T rademarks and Disclaimers. Prowler and the Pentair Water Pool and Spa logo are trademarks of Pentair W ater Po[...]

i Prowler ™ 710 Installation and User ’ s Guide Contents Important Safety Precautions .............................................................................................. i i Section 1: Introduction ..................................................................................................... 1 Prowler ™ 710 Overvi ew .......[...]

ii Prowler ™ 710 Installation and User ’ s Guide IMPORTANT SAFETY PRECAUTIONS Important Notice: Attention Installer: This guide contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/or operator of this equipment after installation of the pool cleaner . At[...]

1 Prowler ™ 710 Installation and User ’ s Guide Section 1 Introduction The Prowler ™ 710 Overview Automatically clean your pool in 60 to 90 minutes or less The fastest and most effective robotic cleaner in its class, the Prowler ™ 710 features true “plug and play” convenience. It operates totally independently of your pool’ s circulat[...]

2 Prowler ™ 710 Installation and User ’ s Guide General Features The Prowler ™ 710 features three-way cleaning performance: • Dual pressure wash jets lift sand, silt and algae off floors and walls – including surface pores where brushes can’t reach. • Powerful vacuum action removes fine particles and larger debris. • Internal filtra[...]

3 Prowler ™ 710 Installation and User ’ s Guide Section 2 Set-up The following general information describes how to set-up your Prowler ™ 710 robotic pool cleaner . Carefully read the following so that you are fully aware of all the capabilities and features this cleaner has to offer . NOTE: Before setting up this product, read and follow all[...]

4 Prowler ™ 710 Installation and User ’ s Guide How your Prowler ™ 710 Cleaner works The patented built in pump motor provides the power for your cleaner ’ s jet drive propulsion and hydroscrubbing jets. The hydroscrubbing jets, directed at the pool surface under your cleaner , stir up dirt and debris for easy vacuuming by the cleaner ’ s[...]

5 Prowler ™ 710 Installation and User ’ s Guide Setting up your Prowler™ 710 Cleaner Y our new cleaner consists of two main parts: A. Power Supply (T ransformer) with T wo-Hour Automatic Shut-Off, Figure 1 .      Fuse Holder      Forward/Reverse Timer Control Dial      Power Supply Cord   [...]

6 Prowler ™ 710 Installation and User ’ s Guide Setting up the Power Supply W ARNING — Risk of electrical shock or electrocution. A ground fault current interrupter (GFCI) must be in place to protect your electric outlet . Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa users, in[...]

7 Prowler ™ 710 Installation and User ’ s Guide Figure 6. Placing the Cleaner into the Pool W ARNING — Risk of electrical shock or electrocution. The power supply MUST be placed and a minimum distance of 10 feet away from the pool. Failure to do so could create an electrical hazard which could result in death or serious injury to pool or spa [...]

8 Prowler ™ 710 Installation and User ’ s Guide Adjusting the Timing Cycle The T ime Control Dial located on the front panel of the Power Supply can be adjusted to allow more or less time between the cleaner's forward and reverse motion, see Figure 8. Set your cleaner's T ime Control Dial to 30 seconds. The goal is to have your cleane[...]

9 Prowler ™ 710 Installation and User ’ s Guide The Cleaning Motion in the Pool The size of your pool, and the amount of debris in it, will determine the length of time required to clean the pool. The time required may vary up to two hours. If the cleaner typically reaches the waterline at each side as it is supposed to, but begins to slow down[...]

10 Prowler ™ 710 Installation and User ’ s Guide Cleaning or Changing the Filter Bag 1. Make sure that the Power Supply is turned “OFF” and that the cleaner's Floating Cable is unplugged from the Power Supply. Place the cleaner on its back on a non-abrasive surface and release the two Lock Tabs, (located on the sides of the unit), see [...]

11 Prowler ™ 710 Installation and User ’ s Guide In-Season Storage W ARNING — Do not allow swimmers in the pool while your pool cleaner is in the pool. Cable can trip or entangle swimmers which could result in drowning. Do not leave your cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag and cleaner . After[...]

12 Prowler ™ 710 Installation and User ’ s Guide[...]

13 Prowler ™ 710 Installation and User ’ s Guide Section 3 T roubleshooting Use the following troubleshooting information to resolve possible problems with your Prowler™ 710 pool cleaner . Problem Corrective Action Slower motion or inefficient vacuuming. Check to see if the Filter Bag is thoroughly clean. FYI : The Fine Filter Bag is capable [...]

14 Prowler ™ 710 Installation and User ’ s Guide Problem Corrective Action Does not reverse direction. T ake a garden hose with high pressure, spray into the V alve Housing at each V alve Port opening, ( Figure 2, Item 9 ). This should free the Jet V alve System of any debris. If this does not solve the problem, firmly grab hold of both of your[...]

15 Prowler ™ 710 Installation and User ’ s Guide Figure 17. Figure 18. Figure 19. Figure 20.[...]

16 Prowler ™ 710 Installation and User ’ s Guide Section 4 Replacement Parts Prowler ™ 710 Model 12.0" 17.0" 20.1" 5 1 2 3 4 6 7 8 9 9 10 10 11 11 12 13 13 14 14 15 15 15 15 16 16 17 18 19 20 20 20 20 21 21 21 21 21 21 21 21 22 23 22 22 23 22 24 25 25 26 26 27 28 28 29 30 31 32 33 34 34 36 36 35 35 36 36 35 35 37 37[...]

17 Prowler ™ 710 Installation and User ’ s Guide Replacement Parts List for the Prowler ™ 710 Model IT E M P/N’ s DESCRIPTION QT Y . NO. 1 BODY S-AS BLUE/BLUE 300C WITH SLOT 1 2 SWITCHING WEDGE ASSY . 1 3 P12144 V A L V E HOUSING ASSY . 1 4 P12141 PUMP MOTOR ASSY . 1 5 P12142 POWER SUPPL Y 1 6 BOTTOM LID ASSY . 1 7 P12143 CABLE ASSY ., 2 WI[...]

18 Prowler ™ 710 Installation and User ’ s Guide Notes[...]

Prowler ™ 710[...]

P/N P12153 Rev . A 2/23/06[...]